Effect of dried distillers' grain with solubles as a replacer of peanut cake for sheep fed on low quality forage.

Several concerns exist on the performance and health attributes of sheep fed on complete replacements of the traditional feed ingredients with dried distillers' grain solubles (DDGS). The study intended to know the effect of DDGS on replacing the peanut cake (PNC) at 0%, 50%, 75%, and 100% in sheep fed Jowar stover-based diet. Replacing PNC with DDGS increased (P < 0.05) the final body weight and concentrate intake. The weight gain and average daily gain tended to increase (P = 0.086), whereas the feed conversion ratio tended to decrease (P = 0.092) with increased DDGS inclusion levels. The CP intake increased linearly (P < 0.01) with an increase in DDGS levels. However, the intakes of DM, OM, NDF, and ADF increased quadratically (P < 0.01) and showed a quadratic maximum at 75% replacements group. The in vitro dry matter digestibility and 24 h-gas (ml) production linearly increased (P < 0.05) with increased DDGS inclusion levels, while the CH4 (% total gas) and CH4 (ml) showed a quadratic increase (P < 0.05). The metabolisable energy, ammonia nitrogen, and volatile fatty acid concentrations were higher for DDGS diets. Further, the Gompertz curve fitting of the gas production data revealed higher asymptotic volume with lower constant of integration (b) and rate of production (k) of the DDGS incubations. No significant differences were observed for any of the carcass characteristics, except for leg weight, which showed a linear increase (P < 0.05). Increased tendency was observed for EBW, loin eye area at 12th rib, and edible portion of the sheep fed DDGS groups. Further, the visceral organs and carcass composition did not show any significant differences, except for kidney weight (linear, P < 0.05). The income over feed cost (IOFC) was higher for 100% DDGS group with lower feed cost and higher income per Kg mutton. Replacing the traditional peanut cake with DDGS in the crop residue-based diets of growing lambs contributes to higher yields for producers.

Ultra-thin polarization independent broadband terahertz metamaterial absorber.

In this work, we present the design of a polarization independent broadband absorber in the terahertz (THz) frequency range using a metasurface resonator. The absorber comprises of three layers, of which, the top layer is made of a vanadium dioxide (VO2) resonator with an electrical conductivity of σ = 200000 S/m; the bottom layer consists of a planar layer made of gold metal, and a dielectric layer is sandwiched between these two layers. The optimized absorber exhibits absorption greater than 90% from 2.54-5.54 THz. Thus, the corresponding bandwidth of the designed absorber is 3 THz. Further, the thermal tunable absorption and reflection spectra have been analyzed by varying the electrical conductivity of VO2. The impact of the various geometrical parameters on the absorption characteristics has also been assessed. The physics of generation of broadband absorption of the proposed device has been explored using field analysis. Finally, the absorption characteristics of the unit cell has been studied for various incident and polarization angles.

Ferromagnetic behaviour of nickel contacted multiwalled carbon nanotubes.

A novel method for the contact of ferromagnetic nano-nickel onto multiwalled carbon nanotubes (MWCNTs) is proposed in this work. The process involves the decomposition of the precursor: nickel carbonyl-Ni(CO)4 into nickel and CO by laser chemical vapour deposition at 150-200 degrees C and the deposition of nano-nickel onto MWCNTs. Field emission scanning electron microscopy (FE-SEM), transmission electron microscopy (TEM), HR (High resolution) TEM, and Raman spectroscopy were employed for the detailed analysis of the nickel contacted MWCNTs. The ferro-magnetic nature of the sample was confirmed by Super-conducting Quantum Interference Device (SQUID) analysis.

Dosimetric Effect of Rotational Setup Errors in Single-Isocenter Volumetric-Modulated Arc Therapy of Multiple Brain Metastases.

AIM: The aim of this study is to investigate the dosimetric effects of rotational uncertainties in patient positioning on target coverage in stereotactic radiosurgery (SRS) of multiple brain metastases using single isocenter volumetric modulated arc therapy (VMAT). MATERIALS AND METHODS: Ten SRS cases with multiple brain metastases (2-8) planned with single isocenter non-coplanar VMAT technique were investigated in this study. Pitch, yaw and roll displacements of 1, 3 and 5° were simulated about isocenter along each axes and nine plans were obtained for each case. Gross tumor volume (GTV) coverage obtained on simulated plans were compared with the original plan on four metrics of mean dose (Dmean), minimum dose to GTV (Dmin), dose to 95% of GTV (D95) and the volume covered by the 95% of the prescribed dose (V95). RESULTS: At 1° rotation about 4% of the PTV had V95 and D95 values <95%. The minimum dose obtained across all PTV was 85.1% and there was not much change in the mean dose values obtained. The PTV volume which had V95 and D95 values <95% were in the range of 0.05 - 0.07cc and at a radial distance of 6.2 cm - 7.2 cm. At 3° rotation almost 50% of the PTV had V95 and D95 values <95%. The minimum dose obtained across all PTV was 48.3% and the mean dose reduced to as low as 78.8%. At 5° rotation almost 74% of the PTV had V95 and D95 values <95%. The minimum dose obtained across all PTV was 21.2% and the mean dose reduced to as low as 49.2%. CONCLUSION: Our results indicate that correcting rotational uncertainties is critical in single-isocenter, multi-target SRS. For rotational deviations, radial distance of the target from isocenter along the respective axis has a strong influence on target coverage. For rotational setup deviation at a given radial distance larger targets tend to have lesser geometric miss compared to smaller targets. Mathematical model for spherical targets can be used to estimate V95 for given rotational errors.

Hydrogen in chemical vapour deposited carbon nanotubes: an active site for functionalization.

The presence of hydrogen in as-grown carbon nanotubes (CNTs) synthesized by microwave plasma (MP) chemical vapour deposition (CVD) technique is demonstrated. Our results showed that the MPCVD, as-grown CNTs were hydrogenated consisting of C-H bonds; whereas, the tubes synthesized by arc discharge consisted of non-hydrogenated multi-walled CNTs. Fourier transform infrared spectroscopy (FTIR) and micro-Raman spectroscopy techniques were used to detect C-H bonding in the as-grown CNTs. The effective functionalization of as-grown hydrogenated CNTs grown using a microwave CVD process is first time demonstrated by laser assisted CVD process. It was found that the laser-assisted CVD process resulted in the termination of hydrogen and the oxidation of as-grown CNT structure leading to the carboxylic group attachment. The FTIR results show the presence of -OH and C=O bonds in the functionalized samples. However, the non-hydrogenated CNTs could not be effectively functionalized by the same process, probably due to the fact that it did not contain active sites pre-requisite for functionalization, as did the CVD grown samples. The functionalization of CVD grown tubes is believed to take place at the 'active' hydrogen-terminated sites on the CNT surfaces.

Study of Variation in Dose Calculation Accuracy Between kV Cone-Beam Computed Tomography and kV fan-Beam Computed Tomography.

Cone-beam computed tomography (CBCT) images are presently used for geometric verification for daily patient positioning. In this work, we have compared the images of CBCT with the images of conventional fan beam CT (FBCT) in terms of image quality and Hounsfield units (HUs). We also compared the dose calculated using CBCT with that of FBCT. Homogenous RW3 plates and Catphan phantom were scanned by FBCT and CBCT. In RW3 and Catphan phantom, percentage depth dose (PDD), profiles, isodose distributions (for intensity modulated radiotherapy plans), and calculated dose volume histograms were compared. The HU difference was within ± 20 HU (central region) and ± 30 HU (peripheral region) for homogeneous RW3 plates. In the Catphan phantom, the difference in HU was ± 20 HU in the central area and peripheral areas. The HU differences were within ± 30 HU for all HU ranges starting from -1000 to 990 in phantom and patient images. In treatment plans done with simple symmetric and asymmetric fields, dose difference (DD) between CBCT plan and FBCT plan was within 1.2% for both phantoms. In intensity modulated radiotherapy (IMRT) treatment plans, for different target volumes, the difference was <2%. This feasibility study investigated HU variation and dose calculation accuracy between FBCT and CBCT based planning and has validated inverse planning algorithms with CBCT. In our study, we observed a larger deviation of HU values in the peripheral region compared to the central region. This is due to the ring artifact and scatter contribution which may prevent the use of CBCT as the primary imaging modality for radiotherapy treatment planning. The reconstruction algorithm needs to be modified further for improving the image quality and accuracy in HU values. However, our study with TG-119 and intensity modulated radiotherapy test targets shows that CBCT can be used for adaptive replanning as the recalculation of dose with the anisotropic analytical algorithm is in full accord with conventional planning CT except in the build-up regions. Patient images with CBCT have to be carefully analyzed for any artifacts before using them for such dose calculations.

A retrospective analysis of acute organophosphorus poisoning cases admitted to the tertiary care teaching hospital in South India.

OBJECTIVES: We have herein reported our experience with the pattern of presentation of cases of acute organophosphorus (OP) poisoning cases in a tertiary care hospital. MATERIALS AND METHODS: This retrospective study evaluated the hospital records of patients with acute OP poisoning. In a pre-structured proforma, data regarding age, sex, time elapsed after intake, circumstances of poisoning, duration of hospitalization, severity, complications, and outcome of the patients were recorded. The data were presented as mean ± standard deviation, entered in the open office datasheet, and analyzed with PSPP software. RESULTS: A total 101 patients were included in the study. Young adult males were more commonly involved than females (M:F 2.5:1). The mean age of the patients was 28 years (range 2-72 years, SD ± 14.3 years). Mean time to receive treatment was 5.2 ± 7.4 (range 1-48 h). About 45.5% patients received first aid before coming to the hospital. The reason was suicide in 88.1% cases and accident in 12 (11.9%, all children). Seventy-nine patients received pralidoxime (PAM) and the mean duration was 1.7 ± 1.1 (range 1-4 days). Atropine was given in all patients. Mean duration was 5.1 ± 3.1 (range 1-19 days). Mean hospital stay was 7.5 ± 4.7 days (range 1-26 days). Mortality was 9.9% in the present series. CONCLUSION: Although the present study contribute substantial information regarding the epidemiology and outcome of acute OP poisoning in a tertiary care teaching hospital at a district level, its relatively small sample size and the retrospective record-based nature are the major limitations of the present study. There is a further need for prospective studies to understand the underlying socio-economic factors responsible for acute OP poisoning in our population, and, accordingly, address the problems to reduce the incidence of acute OP poisoning cases.

A retrospective review of snake bite victims admitted in a tertiary level teaching institute.

OBJECTIVE: Snake bite remains major public health problem worldwide. We present our experience with cases of snake bites managed in our tertiary care teaching center of South India. MATERIALS AND METHODS: The details of all patients with snake bite admitted to a tertiary teaching care hospital from 2010 to 2012 were retrospectively retrieved and reviewed. The details regarding age, gender, first aid received or not, time elapsed between the bite, emergency care management and ASV (Anti Snake Venom) administration, site of snake bite, clinical features at the time of presentation, local examination findings at the site of bite, duration of hospital stay, need for elective ventilation, details of investigations and outcome were reviewed. The data were analyzed in PSPP software (Free Software Foundation, Inc.) for window for statistical analysis, while standard deviation (SD) was applied for the continuous variables, and proportions were applied for the categorical variables. RESULTS: Mean age was 38.4 ± 14.8 years (range 4-70 years). Majority [72 (82.8%)] were farmers. In 86.2% patients, the site of bite was in lower limbs. Snake could be identified in only 20 cases [Cobra-12 (60%), Krait-2 (10%), and Viper-6 (30%)]. Mean time to reach to hospital was 12.1 ± 21.4 hours (range 1-120 hours). Mean anti-venom therapy duration was 3.2 ± 2.0 days (range 1-14 days). Mean hospital stay was 4.7 ± 3.1 days (range 1-15 days). Majority (72.4%) made good recovery; mortality was in 4.6% cases, and 20 (23%) patients left against medical advice. CONCLUSIONS: This study identified major epidemiological and management variables related to snake bite. There is a need for a well-planned data collection and information dissemination system to avoid this potentially preventable disease.