RESUMO
A novel approach was investigated for the assessment of leaching from a one-component polyurethane (1C-PU) coating used for hydraulic structures using nontarget analysis via LC-QTOF-MS. Leaching behavior of the 1C-PU coating was studied using experiments in which the coating was exposed to water for defined periods (6 h, 24 h, 3 d, 14 d). Three hardening durations for the 1C-PU coating were tested (0 h, 24 h, 14 d) as well as two water matrices (ultrapure water and river water), including a successive water renewal. Dissolved organic carbon, total nitrogen bound and nontarget measurements via LC-QTOF-MS showed that under all tested conditions organic substances were leached out of the 1C-PU coating. The shorter the hardening duration and the longer the leaching duration, the higher were the number and quantities of the eluted substances, while the influence of the water matrix was minor with respect to substance elution. Based on the MS2 spectra from the LC-QTOF-MS measurements, 30 substances released from the 1C-PU coating were tentatively identified. These substances belong to five chemical groups: derivatives of (i) N-(tosyl)carbamate, (ii) p-toluenesulfonamide (PTSA), (iii) 4,4'-methylenediphenyl diisocyanate (4,4'-MDI), (iv) toluenediisocyanate (TDI), and (v) oligo(ethylene) ([C2H4O]n) as well as p-toluenesulfonic acid. The identity of seven substances was confirmed by authentic reference standards, all of which exhibited an elevated bacterial toxicity to Aliivibrio fischeri. p-Toluenesulfonic acid was present in a German canal (Teltowkanal) with concentrations of up to 11 µg L-1.
Assuntos
Poliuretanos/análise , Poluentes Químicos da Água/análise , Cromatografia Líquida , Água Doce , Espectrometria de MassasRESUMO
Safeguarding sustainability of forest ecosystems with their habitat variability and all their functions is of highest priority. Therefore, the long-term adaptability of forest ecosystems to a changing environment must be secured, e.g., through sustainable forest management. High adaptability is based on biological variation starting at the genetic level. Thus, the ultimate goal of the Convention on Biological Diversity (CBD) to halt the ongoing erosion of biological variation is of utmost importance for forest ecosystem functioning and sustainability. Monitoring of biological diversity over time is needed to detect changes that threaten these biological resources. Genetic variation, as an integral part of biological diversity, needs special attention, and its monitoring can ensure its effective conservation. We compare forest genetic monitoring to other biodiversity monitoring concepts. Forest genetic monitoring (FGM) enables early detection of potentially harmful changes of forest adaptability before these appear at higher biodiversity levels (e.g., species or ecosystem diversity) and can improve the sustainability of applied forest management practices and direct further research. Theoretical genetic monitoring concepts developed up to now need to be evaluated before being implemented on a national and international scale. This article provides an overview of FGM concepts and definitions, discusses their advantages and disadvantages, and provides a flow chart of the steps needed for the optimization and implementation of FGM. FGM is an important module of biodiversity monitoring, and we define an effective FGM scheme as consisting of an assessment of a forest population's capacity to survive, reproduce, and persist under rapid environmental changes on a long-term scale.
Assuntos
Biodiversidade , Conservação dos Recursos Naturais/métodos , Monitoramento Ambiental/métodos , Florestas , Variação Genética , Árvores/genética , Europa (Continente) , Formulação de Políticas , Árvores/crescimento & desenvolvimentoRESUMO
In order to prevent corrosion damage, steel structures need to be protected. Coating systems achieve this by the isolation of the steel from its environment. Common binding agents are epoxide and polyurethane resins which harden by polyaddition reactions. In contact with water, various organic substances might be leached out and released into the aquatic environment potentially causing adverse effects. So far, no legal requirements are mandatory for the environmental sustainability of coating systems. To characterize emissions from steel coatings, recommendations for the ecotoxicological assessment of construction products were utilized. Seven different coating systems based on epoxide or polyurethane resins were leached in 8 steps (6 h-64 d), followed by the testing of acute toxic effects on bacteria and algae as well as estrogen-like and mutagenic effects. In addition, chemical analysis by GC-MS was performed to identify potentially toxic compounds released from the coating systems. Two systems tested did not show any significant effects in the bioassays. One coating system caused significant algal toxicity, none was found to cause mutagenic effects. The other coating systems mainly showed estrogenic effects and bacterial toxicity. The effects increased with increasing leaching time. 4-tert-butylphenol, which is used in epoxy resins as a hardener, was identified as the main contributor to acute and estrogenic effects in two coatings. The release mechanism of 4-tert-butylphenol was characterized by two different modelling approaches. It was found that the release from the most toxic coating is not explainable by an elevated content of 4-tert-butylphenol but more likely by the release mechanism that - in contrast to the less toxic coating - is controlled not only by diffusion. This finding might indicate a sub-optimal formulation of this coating system resulting in a less stable layer and thus an increased release of toxic compounds.
Assuntos
Poluentes Químicos da Água , Água , Corrosão , Ecotoxicologia , AçoRESUMO
Epoxy resin coatings applied to steel constructions for corrosion protection purposes are often exposed to UV-irradiation and weathering during the construction process. Chemical alteration of the hardened coating might lead to i) the release of potentially harmful substances into the environment and ii) delamination of the polyurethane top layer. However, chemical processes and mechanisms occurring on the surfaces of exposed epoxy resin coatings are not fully understood yet. Herein, we present an innovative approach combining time-of-flight secondary ion mass spectrometry (ToF-SIMS) with inductively coupled plasma mass spectrometry (ICP-MS) and liquid chromatography mass spectrometry (LC-MS) enabling the elucidation of underlying chemical processes and the identification of released organic and inorganic photolytic products. IR-spectroscopy and experiments targeting the acidity/pH-value changes on top of weathered surfaces complement our investigations. It was confirmed that UV-A irradiation leads to photooxidative degradation of the epoxy resin and that inorganic photolytic products are exposed on the weathered surfaces. Polar moieties (hydroxyls, carbonyls, carboxyls, amines) and released metalloids form a hydrophilic surface layer, which hinders adhesion and eventually prevents profound chemical linkage of the polyurethane top layer. Thus, an early delamination of the top layer might occur very likely.
RESUMO
Apomixis in angiosperms is asexual reproduction from seed. Its importance to angiospermous evolution and biodiversity has been difficult to assess mainly because of insufficient taxonomic documentation. Thus, we assembled literature reporting apomixis occurrences among angiosperms and transferred the information to an internet database (http://www.apomixis.uni-goettingen.de). We then searched for correlations between apomixis occurrences and well-established measures of taxonomic diversity and biogeography. Apomixis was found to be taxonomically widespread with no clear tendency to specific groups and to occur with sexuality at all taxonomic levels. Adventitious embryony was the most frequent form (148 genera) followed by apospory (110) and diplospory (68). All three forms are phylogenetically scattered, but this scattering is strongly associated with measures of biodiversity. Across apomictic-containing orders and families, numbers of apomict-containing genera were positively correlated with total numbers of genera. In general, apomict-containing orders, families, and subfamilies of Asteraceae, Poaceae, and Orchidaceae were larger, i.e., they possessed more families or genera, than non-apomict-containing orders, families or subfamilies. Furthermore, many apomict-containing genera were found to be highly cosmopolitan. In this respect, 62% occupy multiple geographic zones. Numbers of genera containing sporophytic or gametophytic apomicts decreased from the tropics to the arctic, a trend that parallels general biodiversity. While angiosperms appear to be predisposed to shift from sex to apomixis, there is also evidence of reversions to sexuality. Such reversions may result from genetic or epigenetic destabilization events accompanying hybridization, polyploidy, or other cytogenetic alterations. Because of increased within-plant genetic and genomic heterogeneity, range expansions and diversifications at the species and genus levels may occur more rapidly upon reversion to sexuality. The significantly-enriched representations of apomicts among highly diverse and geographically-extensive taxa, from genera to orders, support this conclusion.
RESUMO
The vertical niche differentiation of genera of ectomycorrhiza (ECM) was assessed in a 17-year-old Norway spruce (Picea abies [L.] Karst.) plantation on a mountainous dolomitic site (1,050 m above sea level) of the Bavarian Limestone Alps. We determined ECM anatomotypes, recorded the abundance of corresponding ECM root tips and classified them into groups of ECM exploration types, which refer to the organisation and the extent of their extramatrical mycelia. The abundance of ECM was highest in the organic soil layers, compared to the mineral soil horizon. The ordination of the ECM communities and of the exploration types revealed segregation related to soil horizon properties. While Cenococcum geophilum preferred the organic soil layers, Lactarius spp., Tomentella spp. and Craterellus tubaeformis were generally most abundant in the mineral soil horizons. Cenococcum geophilum was the predominant species, possibly based on enhanced competitiveness under the prevailing site conditions. The short-distance exploration types (e.g. C. geophilum) preferentially colonised the organic soil layer, whereas the contact types (e.g. most of the Tomentella spp., C. tubaeformis) together with medium-distance types (e.g. Amphinema byssoides) were primarily associated with the underlying A-horizons. Therefore, the soil horizons had an important effect on the distribution of ECM and on their community structure. The spatial niche differentiation of ECM genera and exploration types is discussed in regard to specific physico-chemical properties of soil horizon and the assumed ecophysiological strategies of ECM.