High-Yielding Separation and Collection of Plasma from Whole Blood Using Passive Filtration.

Lateral flow tests and hand-held analyzers facilitate diagnostic testing in resource limited settings and at the point-of-care. However, many of these devices require sample preparation such as plasma separation to remove cells and isolate the liquid portion of blood. Specifically, the separation of plasma from blood is necessary for routine health assessments such as comprehensive metabolic panels and chronic HIV viral load monitoring. Away from laboratories, this type of processing has been addressed by unconventional, hand-operated centrifuge devices (high volume) or plasma separation membranes (PSM) coupled with lateral flow tests (low volume). Herein, we describe a device that separates and stores plasma from undiluted blood using only passive filtration in less than 10 min. Integrating a PSM with a prefilter and absorbent material yields a 3-fold increase in separation efficiency compared to similar devices using passive filtration. We demonstrate the reproducibility of our device across the physiological range of hematocrits (20-50%) with an average recovered plasma volume of 61.7 ± 2.6 µL. Maximum separation efficiency (53.8%, 65.6 ± 3.9 µL plasma) was achieved for a sample of whole blood (30% hematocrit) in 10 min. We evaluate the purity of our plasma sample by quantitation of hemoglobin and report hemolysis as either minimal (≤5%) or undetectable (≤1%). Specific recovery of human IgG, IFN-γ, and HIV-1 RNA indicate the diagnostic utility of plasma obtained from our device is unchanged compared to plasma obtained via centrifugation. Finally, we demonstrate the use of recovered plasma, applied via "stamping", to successfully conduct a commercial lateral flow immunochromatographic assay for tetanus antibodies. This device platform is capable of producing pure plasma samples from blood to facilitate tests in resource limited settings to improve access to healthcare.

Microsampling tools for collecting, processing, and storing blood at the point-of-care.

In the wake of the COVID-19 global pandemic, self-administered microsampling tools have reemerged as an effective means to maintain routine healthcare assessments without inundating hospitals or clinics. Finger-stick collection of blood is easily performed at home, in the workplace, or at the point-of-care, obviating the need for a trained phlebotomist. While the initial collection of blood is facile, the diagnostic or clinical utility of the sample is dependent on how the sample is processed and stored prior to transport to an analytical laboratory. The past decade has seen incredible innovation for the development of new materials and technologies to collect low-volume samples of blood with excellent precision that operate independently of the hematocrit effect. The final application of that blood (i.e., the test to be performed) ultimately dictates the collection and storage approach as certain materials or chemical reagents can render a sample diagnostically useless. Consequently, there is not a single microsampling tool that is capable of addressing every clinical need at this time. In this review, we highlight technologies designed for patient-centric microsampling blood at the point-of-care and discuss their utility for quantitative sampling as a function of collection material and technique. In addition to surveying methods for collecting and storing whole blood, we emphasize the need for direct separation of the cellular and liquid components of blood to produce cell-free plasma to expand clinical utility. Integrating advanced functionality while maintaining simple user operation presents a viable means of revolutionizing self-administered microsampling, establishing new avenues for innovation in materials science, and expanding access to healthcare.

Patterned Dried Blood Spot Cards for the Improved Sampling of Whole Blood.

Dried blood spot (DBS) cards perform many functions for sampling blood that is intended for subsequent laboratory analysis, which include: (i) obviating the need for a phlebotomist by using fingersticks, (ii) enhancing the stability of analytes at ambient or elevated environmental conditions, and (iii) simplifying the transportation of samples without a cold chain. However, a significant drawback of standard DBS cards is the potential for sampling bias due to unrestricted filling caused by the hematocrit of blood, which often limits quantitative or reproducible measurements. Alternative microsampling technologies have minimized or eliminated this bias by restricting blood distribution, but these approaches deviate from clinical protocols and present a barrier to broad adoption. Herein, we describe a patterned dried blood spot (pDBS) card that uses wax barriers to control the flow and restrict the distribution of blood to provide enhanced sampling. These patterned cards reproducibly fill four replicate extraction zones independent of the hematocrit effect. We demonstrate a 3-fold improvement in accuracy for the quantitation of hemoglobin using pDBS cards compared to unpatterned cards. Patterned cards also facilitate the near quantitative recovery (ca. 95%) of sodium with no evidence of a statistically significant difference between dried and liquid blood samples. Similarly, the recovery of select amino acids was conserved in comparison to a recent report with improved intercard precision. We anticipate that this approach presents a viable method for preparing and storing samples of blood in limited resource settings while maintaining current clinical protocols for processing and analyzing dried blood spots.

Direct Processing and Storage of Cell-Free Plasma Using Dried Plasma Spot Cards.

Plasma separation cards represent a viable approach for expanding testing capabilities away from clinical settings by generating cell-free plasma with minimal user intervention. These devices typically comprise a basic structure of the plasma separation membrane, unconstrained porous collection pad, and utilize either (i) lateral or (ii) vertical fluidic pathways for separating plasma. Unfortunately, these configurations are highly susceptible to (i) inconsistent sampling volume due to differences in the patient hematocrit or (ii) severe contamination due to leakage of red blood cells or release of hemoglobin (i.e., hemolysis). Herein, we combine the enhanced sampling of our previously reported patterned dried blood spot cards with an assembly of porous separation materials to produce a patterned dried plasma spot card for direct processing and storage of cell-free plasma. Linking both vertical separation and lateral distribution of plasma yields discrete plasma collection zones that are spatially protected from potential contamination due to hemolysis and an inlet zone enriched with blood cells for additional testing. We evaluate the versatility of this card by quantitation of three classes of analytes and techniques including (i) the soluble transferrin receptor by enzyme-linked immunosorbent assay, (ii) potassium by inductively coupled plasma atomic emission spectroscopy, and (iii) 18S rRNA by reverse transcriptase quantitative polymerase chain reaction. We achieve quantitative recovery of each class of analyte with no statistically significant difference between dried and liquid reference samples. We anticipate that this sampling approach can be applied broadly to improve access to critical blood testing in resource-limited settings or at the point-of-care.