Swelling of Poly(n-butyl methacrylate) Films Exposed to Supercritical Carbon Dioxide: A Comparative Study with Polystyrene.

We report here the swelling and relaxation properties of confined poly(n-butyl methacrylate) (PBMA) films having thicknesses of less than 70 nm under supercritical carbon dioxide (scCO2) using the X-ray reflectivity technique. Swellability is found to be dominant in thinner films compared to thicker ones as a consequence of the confinement-induced densification of the former. Swellability is proportionately increased with the density of the film. PBMA films exhibit a more significant swelling than do PS films, and their differences become more prominent with the increase in film thickness. A comparison between the results obtained for polystyrene (PS) and PBMA ultrathin films reveals that the swellability is dependent upon the specific intermolecular interaction between CO2 and the chemical groups available in the polymers. Owing to strong Lewis acid-base interactions with scCO2 and the lower glass-transition temperature (bulk Tg ≈ 29 °C), PBMA films exhibit a greater amount of swelling than do PS films (bulk Tg ≈ 100 °C). Though they reach to the different swollen state upon exposition, identical relaxation behavior as a function of aging time is evidenced. This unprecedented behavior can be ascribed to the strong bonding between trapped CO2 and PBMA that probably impedes the release of CO2 molecules from the swollen PBMA films manifested in suppressed relaxation.

Interfacial Interactions of a Myoglobin/DOPC Hybrid System at the Air-Water Interface and Its Physicochemical Properties.

In the present study, the intermolecular interactions between a water-insoluble phospholipid (DOPC) and water-soluble protein (myoglobin) and the interaction among themselves were investigated at the air-water interface using the Langmuir and Langmuir-Blodgett techniques. The effects of changes in physicochemical factors, like pH and temperature, on these interactions were also examined. Surface pressure-molecular area (π-A) isotherms of the DOPC monolayer at the air-water interface, with and without myoglobin (Myo) revealed the evolution of various physical properties, such as elastic, thermodynamic, and hysteric properties, in response to changes in subphase pH and temperature. With the increment of subphase pH from 5 to 7 at a fixed temperature (20 °C), the DOPC isotherm expanded, and the in-plane elasticity (CS-1) decreased, but no significant presence of hysteresis was encountered in either of the pH values. On the other hand, a diminution of temperature (from 20 to 5 °C) leads to an expansion of monolayers yielding low elasticity and significant hysteresis. The incorporation of Myo molecules within the DOPC monolayer decreased the CS-1 value of the DOPC monolayer. Such a decrement in CS-1 was also encountered while increasing the pH and decreasing the temperature (T) of the subphase in the absence of Myo. Systematic expansion of DOPC isotherm and increased hysteric area with the increase in Myo proportion were observed and the atomic force microscopy (AFM) observations suggested a strong conjugation between Myo and DOPC in the mixed monolayer. The denaturation effect of Myo molecules was studied using AFM at different temperatures. Furthermore, the Myo molecules were found to be most surface active at pH = 7, which is very close to its isoelectric point. These observations come up with the interaction mechanism between biomolecules under dynamically varied conditions.

Physicochemical Properties of a Bi-aromatic Heterocyclic-Azo/BSA Hybrid System at the Air-Water Interface.

The interaction of a heterocyclic azo compound with itself and with bovine serum albumin (BSA) is realized by probing the structural modifications in Langmuir (L) monolayers and Langmuir-Blodgett (LB) films. It was found from the pressure-area/molecule isotherms that the elastic, thermodynamic, and hysteretic properties of the pure azo L monolayer were strongly altered due to the variation of temperature and pH of subphase water. In addition to that, the modification of such properties of the azo L monolayer due to mixing with BSA was also studied. The incorporation of BSA within the azo molecular assembly reduced the elasticity of that assembly. Such reduction of in-plane elasticity of the pure azo monolayer can also be achieved by reducing the temperature and pH of subphase water without adding BSA. A reduction in area per molecule of the azo assembly at the air-water interface associated with the conformational change from horizontal to vertical orientation facilitating π-π interaction was observed with increase in temperature and pH of the subphase. Such parameters also affected the interactions between azo and BSA molecules within the azo/BSA binary system. The structures of pure azo and binary films can be determined after they are transferred to hydrophilic and hydrophobic Si surfaces using the LB technique. Their out-of-plane and in-plane structures, as extracted from two complementary surface sensitive techniques, X-ray reflectivity and atomic force microscopy, were found to be strongly dependent on mixing with BSA, subphase pH, temperature, and substrate nature.

Size selective excitonic transition energies in strongly confined CdSe quantum dots.

We report on the synthesis of CdSe nanocrystal quantum dots (QDs) of different radii (R). Size dependent optical properties like increase in the confinement energy with decreasing radius for different excitonic transitions are studied. Different excitonic transitions are calculated from the second derivative of UV-vis absorption spectra of as synthesized CdSe QDs. The transitions are assigned to specific states by calculating the transition energies using effective mass approximation. A close matching of the transition energies with the experiment suggesting that the second derivative of the absorption spectra could provide a direct knowledge of the electronic transition for the direct band gap semiconductor quantum dots.

Structure and Elastic Properties of an Unsymmetrical Bi-Heterocyclic Azo Compound in the Langmuir Monolayer and Langmuir-Blodgett Film.

We study the structure and elastic properties of the bi-heterocyclic azo compound at the air-water interface through surface pressure (π)-area (A) isotherm recording followed by transferring them on hydrophilic and hydrophobic Si surfaces by the Langmuir-Blodgett (LB) deposition method. A substantial change in the area/molecule is observed as a function of subphase pH and temperature. Such parameters strongly influence intramolecular interactions within azo molecules and the interactions between azo molecules and water that manifested in higher surface activity at low temperature and high pH, which in turn modifies the elasticity of azo assembly at the air-water interface. A large pH-dependent hysteresis with negative change in entropy, indicating molecular rearrangements, is observed. Molecular assembly formed at the air-water interface is then transferred onto hydrophilic and hydrophobic Si surfaces at two different surface pressures (5 and 30 mN/m) by the LB technique. The structural analysis performed by X-ray reflectivity and atomic force microscopy techniques suggests that the LB films exhibit an abrupt layered structure on hydrophilic Si, whereas an overall rough film is formed on hydrophobic Si. The coverage and compactness of individual layers are found to increase with the deposition pressure (5 to 30 mN/m).

Vitamin C/Stearic Acid Hybrid Monolayer Adsorption at Air-Water and Air-Solid Interfaces.

Because of the antioxidant activity of vitamin C (Vit C) polar heads, they can be used as a protective agent for fatty acids. Hence, the study on the growth of Vit C/stearic acid (SA) mixed binary films at air-water interface (known as Langmuir monolayer) and air-solid interface (known as Langmuir-Blodgett films) is of paramount interest. Although Vit C is situated at subsurface beneath SA molecules and interacts via hydrogen bonding between the hydroxyl groups of Vit C and SA, several Vit C molecules may infiltrate within SA two-dimensional matrix at the air-water interface. The increased mole fraction of Vit C (0.125-0.5) and the reduction of temperature (from 22 to 10 °C) of the subphase water result in an increase in the amount of adsorbed Vit C at the air-water interface. The surface pressure (π)-area (A) isotherms illustrate that such inclusion of Vit C provokes a spreading out of Vit C/SA binary monolayers, which leads to an alteration of different physicochemical parameters such as elasticity, Gibbs free energy of mixing, enthalpy, entropy, interaction energy parameter, and activity coefficient. However, being polar in nature, the transfer of pure Vit C on substrates gets affected. It can be transferred onto substrate by mixing suitably with SA as confirmed by infrared spectra. Their structures, extracted X-ray reflectivity, and atomic force microscopy (topography and phase imaging) are found to be strongly dependent on the nature of the substrate (hydrophilic and hydrophobic).

Chitosan-fatty acid interaction mediated growth of Langmuir monolayer and Langmuir-Blodgett films.

The interaction of chitosan with bio-membranes, which plays important role in deciding its use in biological applications, is realized by investigating the interaction of chitosan with stearic acid (fatty acid) in Langmuir monolayers (at air-water interface) and Langmuir-Blodgett (LB) films (after transferring it onto solid substrate). It is found from the pressure-area isotherms that the chitosan insertion causes an expansion of chitosan-fatty acid hybrid monolayers, which reduces the elasticity and make the film heterogeneous. It is likely that at low surface pressure chitosan is situated at the interface, interacting with stearic acid molecules via electrostatic and hydrophobic interactions whereas at high pressure chitosan mainly located at subsurface beneath stearic acid molecules. In the latter case the interaction is predominantly electrostatic yielding very small contribution to the surface pressure. The reduction of temperature of the subphase water allows more number of chitosan molecules to reach surface to increase the pressure/interaction. On the other hand, although pure chitosan is found difficult to relocate on the substrate from air-water interface due to its hydrophilic-like nature, it alongside stearic acid (amphiphilic molecules) can be transferred onto substrate using LB technique as evident from infrared spectra. Their out-of-plane and in-plane structures, as extracted from two complementary surface sensitive techniques- X-ray reflectivity and atomic force microscopy, are found strongly dependent on the chitosan mole fraction and the deposition pressure. These analysis of the film-structure will essentially allow one to model the system better and provide better insight into the interaction.

Stability of Polymer Ultrathin Films (<7 nm) Made by a Top-Down Approach.

In polymer physics, the dewetting of spin-coated polystyrene ultrathin films on silicon remains mysterious. By adopting a simple top-down method based on good solvent rinsing, we are able to prepare flat polystyrene films with a controlled thickness ranging from 1.3 to 7.0 nm. Their stability was scrutinized after a classical annealing procedure above the glass transition temperature. Films were found to be stable on oxide-free silicon irrespective of film thickness, while they were unstable (<2.9 nm) and metastable (>2.9 nm) on 2 nm oxide-covered silicon substrates. The Lifshitz-van der Waals intermolecular theory that predicts the domains of stability as a function of the film thickness and of the substrate nature is now fully reconciled with our experimental observations. We surmise that this reconciliation is due to the good solvent rinsing procedure that removes the residual stress and/or the density variation of the polystyrene films inhibiting thermodynamically the dewetting on oxide-free silicon.