Genetic analysis of wheat (Triticum aestivum) adaptation to heat stress.

KEY MESSAGE: Adaptation to abiotic stresses such as high-temperature conditions should be considered as its independent components of total performance and responsiveness. Understanding and identifying improved adaptation to abiotic stresses such as heat stress has been the focus of a number of studies in recent decades. However, confusing and potentially misleading terminology has made progress difficult and hard to apply within breeding programs selecting for improved adaption to heat stress conditions. This study proposes that adaption to heat stress (and other abiotic stresses) be considered as the combination of total performance and responsiveness to heat stress. In this study, 1413 doubled haploid lines from seven populations were screened through a controlled environment assay, subjecting plants to three consecutive eight hour days of an air temperature of 36 °C and a wind speed of 40 km h-1, 10 days after the end of anthesis. QTL mapping identified a total of 96 QTL for grain yield determining traits and anthesis date with nine correlating to responsiveness, 72 for total performance and 15 for anthesis date. Responsiveness QTL were found both collocated with other performance QTL as well as independently. A sound understanding of genomic regions associated with total performance and responsiveness will be important for breeders. Genomic regions of total performance, those that show higher performance that is stable under both stressed and non-stressed conditions, potentially offer significant opportunities to breeders. We propose this as a definition and selection target that has not previously been defined for heat stress adaptation.

Multi-environment analysis and improved mapping of a yield-related QTL on chromosome 3B of wheat.

Improved mapping, multi-environment quantitative trait loci (QTL) analysis and dissection of allelic effects were used to define a QTL associated with grain yield, thousand grain weight and early vigour on chromosome 3BL of bread wheat (Triticum aestivum L.) under abiotic stresses. The QTL had pleiotropic effects and showed QTL x environment interactions across 21 diverse environments in Australia and Mexico. The occurrence and the severity of water deficit combined with high temperatures during the growing season affected the responsiveness of this QTL, resulting in a reversal in the direction of allelic effects. The influence of this QTL can be substantial, with the allele from one parent (RAC875) increasing grain yield by up to 12.5 % (particularly in environments where both heat and drought stress occurred) and the allele from the other parent (Kukri) increasing grain yield by up to 9 % in favourable environments. With the application of additional markers and the genotyping of additional recombinant inbred lines, the genetic map in the QTL region was refined to provide a basis for future positional cloning.

Genetic dissection of grain yield and physical grain quality in bread wheat (Triticum aestivum L.) under water-limited environments.

In the water-limited bread wheat production environment of southern Australia, large advances in grain yield have previously been achieved through the introduction and improved understanding of agronomic traits controlled by major genes, such as the semi-dwarf plant stature and photoperiod insensitivity. However, more recent yield increases have been achieved through incremental genetic advances, of which, breeders and researchers do not fully understand the underlying mechanism(s). A doubled haploid population was utilised, derived from a cross between RAC875, a relatively drought-tolerant breeders' line and Kukri, a locally adapted variety more intolerant of drought. Experiments were performed in 16 environments over four seasons in southern Australia, to physiologically dissect grain yield and to detect quantitative trait loci (QTL) for these traits. Two stage multi-environment trial analysis identified three main clusters of experiments (forming distinctive environments, ENVs), each with a distinctive growing season rainfall patterns. Kernels per square metre were positively correlated with grain yield and influenced by kernels per spikelet, a measure of fertility. QTL analysis detected nine loci for grain yield across these ENVs, individually accounting for between 3 and 18% of genetic variance within their respective ENVs, with the RAC875 allele conferring increased grain yield at seven of these loci. These loci were partially dissected by the detection of co-located QTL for other traits, namely kernels per square metre. While most loci for grain yield have previously been reported, their deployment and effect within local germplasm are now better understood. A number of novel loci can be further exploited to aid breeders' efforts in improving grain yield in the southern Australian environment.

Detection of two major grain yield QTL in bread wheat (Triticum aestivum L.) under heat, drought and high yield potential environments.

A large proportion of the worlds' wheat growing regions suffers water and/or heat stress at some stage during the crop growth cycle. With few exceptions, there has been no utilisation of managed environments to screen mapping populations under repeatable abiotic stress conditions, such as the facilities developed by the International Wheat and Maize Improvement Centre (CIMMYT). Through careful management of irrigation and sowing date over three consecutive seasons, repeatable heat, drought and high yield potential conditions were imposed on the RAC875/Kukri doubled haploid population to identify genetic loci for grain yield, yield components and key morpho-physiological traits under these conditions. Two of the detected quantitative trait loci (QTL) were located on chromosome 3B and had a large effect on canopy temperature and grain yield, accounting for up to 22 % of the variance for these traits. The locus on chromosome arm 3BL was detected under all three treatments but had its largest effect under the heat stress conditions, with the RAC875 allele increasing grain yield by 131 kg ha(-1) (or phenotypically, 7 % of treatment average). Only two of the eight yield QTL detected in the current study (including linkage groups 3A, 3D, 4D 5B and 7A) were previously detected in the RAC875/Kukri doubled haploid population; and there were also different yield components driving grain yield. A number of discussion points are raised to understand differences between the Mexican and southern Australian production environments and explain the lack of correlation between the datasets. The two key QTL detected on chromosome 3B in the present study are candidates for further genetic dissection and development of molecular markers.

Identification of novel quantitative trait loci for days to ear emergence and flag leaf glaucousness in a bread wheat (Triticum aestivum L.) population adapted to southern Australian conditions.

In southern Australia, where the climate is predominantly Mediterranean, achieving the correct flowering time in bread wheat minimizes the impact of in-season cyclical and terminal drought. Flag leaf glaucousness has been hypothesized as an important component of drought tolerance but its value and genetic basis in locally adapted germplasm is unknown. From a cross between Kukri and RAC875, a doubled-haploid (DH) population was developed. A genetic linkage map consisting of 456 DArT and SSR markers was used to detect QTL affecting time to ear emergence and Zadoks growth score in seven field experiments. While ear emergence time was similar between the parents, there was significant transgressive segregation in the population. This was the result of segregation for the previously characterized Ppd-D1a and Ppd-B1 photoperiod responsive alleles. QTL of smaller effect were also detected on chromosomes 1A, 4A, 4B, 5A, 5B, 7A and 7B. A novel QTL for flag leaf glaucousness of large, repeatable effect was detected in six field experiments, on chromosome 3A (QW.aww-3A) and accounted for up to 52 percent of genetic variance for this trait. QW.aww-3A was validated under glasshouse conditions in a recombinant inbred line population from the same cross. The genetic basis of time to ear emergence in this population will aid breeders' understanding of phenological adaptation to the local environment. Novel loci identified for flag leaf glaucousness and the wide phenotypic variation within the DH population offers considerable scope to investigate the impact and value of this trait for bread wheat production in southern Australia.

A multisite managed environment facility for targeted trait and germplasm phenotyping.

Field evaluation of germplasm for performance under water and heat stress is challenging. Field environments are variable and unpredictable, and genotype×environment interactions are difficult to interpret if environments are not well characterised. Numerous traits, genes and quantitative trait loci have been proposed for improving performance but few have been used in variety development. This reflects the limited capacity of commercial breeding companies to screen for these traits and the absence of validation in field environments relevant to breeding companies, and because little is known about the economic benefit of selecting one particular trait over another. The value of the proposed traits or genes is commonly not demonstrated in genetic backgrounds of value to breeding companies. To overcome this disconnection between physiological trait breeding and uptake by breeding companies, three field sites representing the main environment types encountered across the Australian wheatbelt were selected to form a set of managed environment facilities (MEFs). Each MEF manages soil moisture stress through irrigation, and the effects of heat stress through variable sowing dates. Field trials are monitored continuously for weather variables and changes in soil water and canopy temperature in selected probe genotypes, which aids in decisions guiding irrigation scheduling and sampling times. Protocols have been standardised for an essential core set of measurements so that phenotyping yield and other traits are consistent across sites and seasons. MEFs enable assessment of a large number of traits across multiple genetic backgrounds in relevant environments, determine relative trait value, and facilitate delivery of promising germplasm and high value traits into commercial breeding programs.