Hip biomechanics in early recovery following fixation of intertrochanteric fractures: Results from a randomised controlled trial.

Single and dual integrated screw femoral nails are both commonly used to treat intertrochanteric fractures. This study investigated if using single or dual integrated screw femoral nails result in different post-operative hip joint loading. In the presence of differences, we investigated potential contributing factors. Patients were randomised for treatment via single screw (Stryker, Gamma3) or dual-integrated screw nail (Smith and Nephew, Intertan). Pre-injury mobility levels were collected at enrolment. Hip radiographs and gait data were collected at six weeks (Gamma: 16; Intertan: 15) and six months (Gamma: 14; Intertan: 13) follow-up. The resultant hip joint reaction forces and abductor muscle forces were estimated using electromyography-assisted neuromusculoskeletal modelling during level walking gait. Our primary analysis focused on the resultant hip joint reaction force and abductor muscle forces. We compared between groups, across stance phase of walking gait, using statistical parametric mapping. At six weeks, the Intertan group showed a short (∼5% of stance phase) but substantial (33 % [0.3 × body weight] greater magnitude) resultant hip joint reaction force when compared to the Gamma group (P = 0.022). Higher gluteus medius forces (P = 0.009) were demonstrated in the Intertan group at six weeks. Harris Hip Scores followed the trend seen for the biomechanical outcomes with superior scores for the Intertan group at six weeks postoperative (P = 0.044). The use of dual-integrated screw femoral nails over single screw devices may allow for hip biomechanics more closely resembling normal hip function at earlier post-operative timepoints, but these appear to resolve by six months postoperative.

Development and validation of a biomechanically fidelic surgical training knee model.

Knee arthroplasty technique is constantly evolving and the opportunity for surgeons to practice new techniques is currently highly dependent on the availability of cadaveric specimens requiring certified facilities. The high cost, limited supply, and heterogeneity of cadaveric specimens has increased the demand for synthetic training models, which are currently limited by a lack of biomechanical fidelity. Here, we aimed to design, manufacture, and experimentally validate a synthetic knee surgical training model which reproduces the flexion dependent varus-valgus (VV) and anterior-posterior (AP) mechanics of cadaveric knees, while maintaining anatomic accuracy. A probabilistic finite element modeling approach was employed to design physical models to exhibit passive cadaveric VV and AP mechanics. Seven synthetic models were manufactured and tested in a six-degree-of-freedom hexapod robot. Overall, the synthetic models exhibited cadaver-like VV and AP mechanics across a wide range of flexion angles with little variation between models. In the extended position, two models showed increased valgus rotation (<0.5°), and three models showed increased posterior tibial translation (<1.7 mm) when compared to the 95% confidence interval (CI) of cadaveric measurements. At full flexion, all models showed VV and AP mechanics within the 95% CI of cadaveric measurements. Given the repeatable mechanics exhibited, the knee models developed in this study can be used to reduce the current reliance on cadaveric specimens in surgical training.

EMG-Informed Neuromusculoskeletal Models Accurately Predict Knee Loading Measured Using Instrumented Implants.

OBJECTIVE: Using a musculoskeletal modelling framework, we aimed to (1) estimate knee joint loading using static optimization (SO); (2) explore different calibration functions in electromyogram (EMG)-informed models used in estimating knee load; and (3) determine, when using an EMG-informed stochastic method, if the measured joint loadings are solutions to the muscle redundancy problem when investigating only the uncertainty in muscle forces. METHODS: Musculoskeletal models for three individuals with instrumented knee replacements were generated. Muscle forces were calculated using SO, EMG-informed, and EMG-informed stochastic methods. Measured knee joint loads from the prostheses were compared to the SO and EMG-informed solutions. Root mean square error (RMSE) in joint load estimation was calculated, and the muscle force ranges were compared. RESULTS: The RMSE ranged between 192-674 N, 152-487 N, and 7-108 N for the SO, the calibrated EMG-informed solution, and the best fit stochastic result, respectively. The stochastic method produced solution spaces encompassing the measured joint loading up to 98% of stance. CONCLUSION: Uncertainty in muscle forces can account for total knee loading and it is recommended that, where possible, EMG measurements should be included to estimate knee joint loading. SIGNIFICANCE: This work shows that the inclusion of EMG-informed modelling allows for better estimation of knee joint loading when compared to SO.

Ex vivo assessment of surgically repaired tibial plateau fracture displacement under axial load using large-volume micro-CT.

Postoperative weight bearing has the potential to generate fragmental motion of surgically repaired tibial plateau fractures (TPFs), which may contribute to loss of fracture reduction. The effect of loading on the internal distribution of fragmentary displacements is currently unknown. The aim of this study was to determine the internal displacements of surgically repaired split TPFs due to a three-bodyweight load, using large-volume micro-CT imaging and image correlation. Fractures were generated and surgically repaired for two cadaveric specimens. Load was applied to the specimens inside a large-volume micro-CT system and scanned at 0.046 mm isotropic voxel size. Pre- and post-loading images were paired, co-registered, and internal fragmentary displacements quantified. Internal fragmental displacements of the cadaveric bones were compared to in vivo displacements measured in the lateral split fragments of TPFs in a clinical cohort of patients who had similar surgical repair and were prescribed pain tolerated postoperative weight bearing. The split fragments of cadaveric specimens displaced, on average, less than 0.3 mm, consistent with in vivo measurements. Specimen one rotated around the mediolateral axis, while specimen two displaced consistently caudally. Specimen two also had varying displacements along the mediolateral axis where, at the fracture site, the fragment displaced caudally and laterally, while the most lateral edge of the tibial plateau displaced caudally and medially. The methods applied in this study can be used to measure internal fragmental motion within TPFs.

Postoperative lower limb joint kinematics following tibial plateau fracture: A 2-year longitudinal study.

BACKGROUND: The goal of postoperative tibial plateau fracture (TPF) management is to ensure surgical fixation is maintained while returning patients to normal function as soon as possible, allowing patients to resume their normal activities of daily living. The aim of this study was to investigate longitudinal changes in lower limb joint kinematics following TPF and determine how these kinematics relate to self-reported function. METHODS: Patients presenting with a TPF were recruited (n = 18) and undertook gait analysis at six postoperative time points (two weeks, six weeks, three months, six months, one and two years). Lower limb joint kinematics were assessed at each time point based on gait data. Statistical parametric mapping (SPM) was undertaken to investigate the change in joint kinematic traces with time. The Knee Injury and Osteoarthritis Outcome Score (KOOS) was assessed at each time point to obtain self-reported outcomes. A healthy reference was also analyzed and used for qualitative comparison of joint kinematics. RESULTS AND SIGNIFICANCE: Knee kinematics showed improvements with time, however only minor changes were noted after six weeks at the hip, and six months at the knee and ankle relative to two weeks postoperative. SPM identified significant improvements with time in hip (p < 0.001) and knee (p = 0.003) flexion. No significant changes were observed with time at the ankle however, when compared to the healthy reference, participants showed reduced plantarflexion at two years. Lower limb joint ROM showed significant weak to moderate correlation with the ADL sub-scale of the KOOS (hip r = 0.442, knee r = 0.303, ankle r = 0.367). The lack of significant changes with time and overall reduced plantarflexion at the ankle potentially reduces propulsive capacity during gait up to two years postoperative. In this study, we see a deficiency in joint kinematics in TPF patients up to two years when compared to a healthy reference, especially at the ankle.