Understanding whole-wheat flour and its effect in breads: A review.

Although the consumption of whole grains, including bread made with whole-wheat flour, is promoted for health benefits and reduced risk for disease and mortality, consumer acceptance, and consumption of some whole-wheat products is low compared to that of white breads. This review focuses on the understanding of whole-wheat flours, both their positive and negative aspects, and how to improve those flours for the production of whole-wheat breads. The review addresses genetic aspects, various milling systems, and pretreatment of bran and germ. The baking process and use of additives and enzymes may also improve product quality to help consumers meet dietary recommendations for daily whole-wheat consumption.

Combination of legume proteins and arabinoxylans are efficient emulsifiers to promote vitamin E bioaccessibility during digestion.

The emulsification potential of plant-based emulsifiers, that is, pea (PPI) and lentil (LPI) proteins (4%), corn arabinoxylans (CAX, 1%), and legume protein-arabinoxylan mixtures (4% proteins + 0.15 or 0.9% CAX), was evaluated by assessing: the surface tension and potential of emulsifiers, emulsifier antinutritional contents, emulsion droplet size, emulsion physical stability, and vitamin E bioaccessibility from 10% oil-in-water emulsions. Tween 80 (2%) was used as a control. All emulsions presented small droplet sizes, both fresh and upon storage, except 4% LPI + 0.9% CAX emulsion that exhibited bigger droplet sizes (d(4,3) of approximately 18.76 µm vs 0.59 µm for the control) because of droplet bridging. Vitamin E bioaccessibility from emulsions stabilized with the combination of 4% PPI and either 0.15% or 0.9% CAX (28 ± 4.48% and 28.42 ± 3.87%, respectively) was not significantly different from that of emulsions stabilized with Tween 80 (43.56 ± 3.71%), whereas vitamin E bioaccessibility from emulsions stabilized with individual emulsifiers was significantly lower.

Improving the antinutritional profiles of common beans (Phaseolus vulgaris L.) moderately impacts carotenoid bioaccessibility but not mineral solubility.

Common beans are a common staple food with valuable nutritional qualities, but their high contents in antinutritional factors (ANFs) can decrease the bioavailability of (i) fat-soluble micronutrients including carotenoids and (ii) minerals. Our objective was to select ANF-poor bean lines that would not interfere with carotenoid and mineral bioavailability. To achieve this objective, seeds of commercial and experimental Phaseolus vulgaris L. bean lines were produced for 2 years and the bean's content in ANFs (saponins, phytates, tannins, total polyphenols) was assessed. We then measured carotenoid bioaccessibility and mineral solubility (i.e. the fraction of carotenoid and mineral that transfer into the aqueous phase of the digesta and is therefore absorbable) from prepared beans using in vitro digestion. All beans contained at least 200 mg/100 g of saponins and 2.44 mg/100 g tannins. The low phytic acid (lpa) lines, lpa1 and lpa12 exhibited lower phytate levels (≈ - 80%, p = 0.007 and p = 0.02) than their control BAT-93. However, this decrease had no significant impact on mineral solubility. HP5/1 (lpa + phaseolin and lectin PHA-E free) bean line, induced an improvement in carotenoid bioaccessibility (i.e., + 38%, p = 0.02, and + 32%, p = 0.005, for phytofluene bioaccessibility in 2021 and 2022, respectively). We conclude that decrease in the phytate bean content should thus likely be associated to decreases in other ANFs such as tannins or polyphenols to lead to significant improvement of micronutrient bioaccessibility.

Emulsification Properties of Garlic Aqueous Extract: Effect of Heat Treatment and pH Modification.

Despite the broad research available in the literature dealing with garlic health benefits, little information is found regarding the functional properties of garlic components. The aim of this study was to evaluate the emulsification properties of garlic water-soluble compounds (GWSC), encompassing proteins, saponins, and carbohydrates, after heat treatment (10 min at 95 °C) or pH adjustments (2.5, 3.5, and 7.8). After the various treatments, the extracts were used as such or filtrated (0.45 µm), and 10% soybean oil-in-water emulsions were prepared using low (0.48%) or high (6.55% wt/wt) extract concentrations. Results showed that whereas at low GWSC concentrations, both heating and acidifying resulted in the formation of bigger oil droplet sizes (i.e., from d32 = 0.36 µm using unmodified extract to d32 = 7-22 µm at pH 2.5 with or without extract filtration), the effects were opposite at the highest GWSC concentration. In the latter, heat treatment clearly reduced the droplet size as observed from the micrographs as well as the degree of creaming, though the occurrence of depletion and/or bridging flocculation was still strong. The acidification of the extract at this high GWSC concentration significantly reduced the droplet size, as observed from the micrographs; however, a strong flocculation was observed. Removal of protein aggregates, and possibly also saponin micelles, from the extract resulted in an obvious increase in emulsion droplet size. This research brings valuable insights on this study and utilisation of novel natural food emulsifiers from plant sources.

Arabinoxylans as Functional Food Ingredients: A Review.

The health benefits of fibre consumption are sound, but a more compressive understanding of the individual effects of different fibres is still needed. Arabinoxylan is a complex fibre that provides a wide range of health benefits strongly regulated by its chemical structure. Arabinoxylans can be found in various grains, such as wheat, barley, or corn. This review addresses the influence of the source of origin and extraction process on arabinoxylan structure. The health benefits related to short-chain fatty acid production, microbiota regulation, antioxidant capacity, and blood glucose response control are discussed and correlated to the arabinoxylan's structure. However, most studies do not investigate the effect of AX as a pure ingredient on food systems, but as fibres containing AXs (such as bran). Therefore, AX's benefit for human health deserves further investigation. The relationship between arabinoxylan structure and its physicochemical influence on cereal products (pasta, cookies, cakes, bread, and beer) is also discussed. A strong correlation between arabinoxylan's structural properties (degree of branching, solubility, and molecular mass) and its functionalities in food systems can be observed. There is a need for further studies that address the health implications behind the consumption of arabinoxylan-rich products. Indeed, the food matrix may influence the effects of arabinoxylans in the gastrointestinal tract and determine which specific arabinoxylans can be included in cereal and non-cereal-based food products without being detrimental for product quality.

Evaluation of Starch⁻Protein Interactions as A Function of pH.

Protein-starch gels are becoming more common in food processing when looking for enriched foods. However, processing conditions scarcely are considered when producing those gels. The aim of this research was to study the effect of processing pH (4.5, 6.0, and 7.5) on the hydration and pasting properties, gel microstructure, and texture of corn starchy gels made with four different proteins (pea, rice, egg albumin, and whey) at a ratio of 1:1 starch/protein and a solid content of 12.28%. The water binding capacity of the starch-protein mixtures was positively influenced by low solubility of the protein used. Acidic pH decreased the apparent peak viscosity of both starch and starch-protein mixtures, with the exception of starch-albumin blends, which increased it. The gels' microstructure showed that the uniformity of the protein-enriched gels was dependent on protein type and pH, leading to diverse hardness. In general, the starchy gels containing animal proteins (albumin and whey) were more affected by pH than those obtained with vegetal proteins (pea and rice). Therefore, processing pH might be an advisable method to modify the functionality of starch-protein gels.