RESUMO
We established the comprehensive emission profiles of organic compounds for typical Chinese diesel trucks. The profiles cover the entire volatility range, including speciated volatile organic compounds (VOCs), intermediate-volatility organic compounds (IVOCs), and semi-volatile organic compounds (SVOCs). The VOCs and I/SVOCs were analyzed by one-dimensional gas chromatography quadrupole mass spectrometry (GC qMS) and two-dimensional gas chromatography time-of-flight mass spectrometry (GC × GC-ToF-MS) separately. The impacts of starting mode and aftertreatment technology on the VOC, gaseous and particulate I/SVOC emissions, and the gas-particle partitioning were investigated. The emission factor (EF) of gas phase I/SVOCs was approximately 10 times higher than that of particle phase I/SVOCs and the chemical compositions and volatility distributions varied greatly. VOC, IVOC, and SVOC emissions significantly decreased when vehicles were equipped with advanced aftertreatment technologies. Diesel particulate filters (DPF) can remove >71 % VOC, 74 % gaseous, and 88 % particulate I/SVOCs, many of which are significant secondary organic aerosol (SOA) precursors. The chemical compositions and volatility distributions of the gaseous I/SVOCs and unburned diesel fuel were similar, revealing that diesel fuel is the main origin of the gaseous I/SVOCs. The I/SVOC emission profiles covering the whole volatility range, i.e., log10C* = -3 to 10 (C*: effective saturation concentration, µg m-3) were established.
RESUMO
The Chinese central government has initiated pilot projects to promote the adoption of gasoline containing 10%v ethanol (E10). Vehicle emissions using ethanol blended fuels require investigation to estimate the environmental impacts of the initiative. Five fuel formulations were created using two blending methods (splash blending and match blending) to evaluate the impacts of formulations on speciated volatile organic compounds (VOCs) from exhaust emissions. Seven in-use vehicles covering China 4 to China 6 emission standards were recruited. Vehicle tests were conducted using the Worldwide Harmonized Test Cycle (WLTC) in a temperature-controlled chamber at 23 °C and -7 °C. Splash blended E10 fuels led to significant reductions in VOC emissions by 12%-75%. E10 fuels had a better performance of reducing VOC emissions in older model vehicles than in newer model vehicles. These results suggested that E10 fuel could be an option to mitigate the VOC emissions. Although replacing methyl tert-butyl ether (MTBE) with ethanol in regular gasoline had no significant effects on VOC emissions, the replacement led to lower aromatic emissions by 40%-60%. Alkanes and aromatics dominated approximately 90% of VOC emissions for all vehicle-fuel combinations. Cold temperature increased VOC emissions significantly, by 3-26 folds for all vehicle/fuel combinations at -7 °C. Aromatic emissions were increased by cold temperature, from 2 to 26 mg/km at 23 °C to 33-238 mg/km at -7 °C. OVOC emissions were not significantly affected by E10 fuel or cold temperature. The ozone formation potential (OFP) and secondary organic aerosol formation potential (SOAFP) of splash blended E10 fuels decreased by up to 76% and 81%, respectively, compared with those of E0 fuels. The results are useful to update VOC emission profiles of Chinese vehicles using ethanol blended gasoline and under low-temperature conditions.
Assuntos
Poluentes Atmosféricos , Compostos Orgânicos Voláteis , Gasolina/análise , Temperatura Baixa , Compostos Orgânicos Voláteis/análise , Etanol , Emissões de Veículos/análise , China , Poluentes Atmosféricos/análiseRESUMO
Polyamorphic transition (PT) is a compelling and pivotal physical phenomenon in the field of glass and materials science. Understanding this transition is of scientific and technological significance, as it offers an important pathway for effectively tuning the structure and property of glasses. In contrast to the PT observed in conventional metallic glasses (MGs), which typically exhibit a pronounced first-order nature, herein we report a continuous PT (CPT) without first-order characteristics in high-entropy MGs (HEMGs) upon heating. This CPT behavior is featured by the continuous structural evolution at the atomic level and an increasing chemical concentration gradient with temperature, but no abrupt reduction in volume and energy. The continuous transformation is associated with the absence of local favorable structures and chemical heterogeneity caused by the high configurational entropy, which limits the distance and frequency of atomic diffusion. As a result of the CPT, numerous glass states can be generated, which provides an opportunity to understand the nature, atomic packing, formability, and properties of MGs. Moreover, this discovery highlights the implication of configurational entropy in exploring polyamorphic glasses with an identical composition but highly tunable structures and properties.
RESUMO
The in-depth investigation of the high black carbon (BC) emission scenarios of heavy-duty diesel vehicles (HDDVs) is a crucial step toward developing effective control strategies. Chassis dynamometer tests were conducted for three in-use HDDVs, namely, vehicle #1, #2, and #3, focusing on the instantaneous BC characterizations during multiple driving conditions, i.e., speed phases and acceleration intervals. BC emission was found to increase with positive acceleration, and high acceleration could result in instantaneous BC spikes. The total BC emissions during velocity-acceleration interval 15-60 km h-1 and 0.1-0.9 m s-2 contributed to 43.4 ± 10.2 % of the whole-cycle emissions, while the proportions of time spent in the velocity-acceleration interval to the whole cycle were 23.1 ± 7.6 %. The cold-start microscopic operating condition was assessed by the cold-start extra emissions (CSEEs). Under various pre-defined cold-start durations, the proportions of CSEEs in the total cycle emissions were 9.4-21.0 %, 0-9.1 %, and 6.8-39.4 % for vehicles #1, #2, and #3, respectively. The CSEEs exhibited an initial rise, followed by a plateau as the assumed cold-start durations extended. A uniform cold-start duration of 600 s was established based on the criterion that the relative standard deviation (RSD) of CSEEs during the plateau period was <10 %. We proposed that the updated cold-start duration can enhance the accuracy and consistency of cold-start corrections in emission inventory models.
RESUMO
Comprehensive characterization of diesel vehicle emitted polycyclic aromatic hydrocarbon (PAH) emissions is yet to achieve due to the limitation of analytical methods. Therefore, we herein developed a two-dimensional gas chromatography time-of-flight mass spectrometry (GC × GC-ToF-MS) method and quantified the total PAHs from diesel vehicles based on their characteristic fragments and mass spectral patterns. Overall, the emission factors (EFs) of total PAHs (gas + particle) are observed to range from 4.1 ± 2.5 mg km-1 to 51.4 ± 22.2 mg km-1 under cold-start and hot-start conditions for one China IV and two China VI heavy-duty diesel vehicles (HDDVs), of which the un-speciated PAHs account for more than 97%. Gaseous PAHs (g-PAHs) are dominated by three-ring PAHs, whereas particulate PAHs (p-PAHs) are dominated by two-ring PAHs. The total PAHs partition significantly into the gas phase for whole fleets and cycles, except that five-ring PAHs partition almost completely into the particle phase. The aftertreatment technologies (e.g., diesel particulate filter, DPF) significantly reduce the total PAH emissions by 49.8 ± 33.2%. The minimum toxic equivalency factors (TEFs) are deployed to estimate the toxicity of the total PAHs. Much higher toxicity is obtained than those in previous studies, indicating that the PAH toxicity of diesel vehicle emissions might be largely underestimated.
Assuntos
Poluentes Atmosféricos , Hidrocarbonetos Policíclicos Aromáticos , Poluentes Atmosféricos/análise , Cromatografia Gasosa-Espectrometria de Massas , Gases/análise , Hidrocarbonetos Policíclicos Aromáticos/análise , Emissões de Veículos/análiseRESUMO
Intermediate-volatility and semi-volatile organic compounds (I/SVOCs) are key precursors of secondary organic aerosol (SOA). However, the comprehensive characterization of I/SVOCs has long been an analytical challenge. Here, we develop a novel method of speciating and quantifying I/SVOCs using two-dimensional gas chromatography time-of-flight mass spectrometry (GC × GC-ToF-MS) by constructing class-screening programs based on their characteristic fragments and mass spectrum patterns. Using this new approach, we then present a comprehensive analysis of gaseous I/SVOC emissions from heavy-duty diesel vehicles (HDDVs). Over three-thousand compounds are identified and classified into twenty-one categories. The dominant compound groups of I/SVCOs emitted by HDDVs are alkanes (including normal and branched alkanes, 37-66%), benzylic alcohols (7-20%), alkenes (3-11%), cycloalkanes (3-9%), and benzylic ketones (1-4%). Oxygenated I/SVOCs (O-I/SVOCs, e.g., benzylic alcohols and ketones) are first quantified and account for >20% of the total I/SVOC mass. Advanced aftertreatment devices largely reduce the total I/SVOC emissions but increase the proportion of O-I/SVOCs. With the speciation data, we successfully map the I/SVOCs into the two-dimensional volatility basis set space, which facilitates a better estimation of SOA. As aging time goes by, approximate 45% difference between the two scenarios after seven-day aging is observed, which confirms the significant impact of speciated I/SVOC emission data on SOA prediction.
Assuntos
Poluentes Atmosféricos , Compostos Orgânicos Voláteis , Aerossóis/análise , Poluentes Atmosféricos/análise , Álcoois/análise , Alcanos/análise , Cromatografia Gasosa-Espectrometria de Massas , Gases/análise , Cetonas , Espectrometria de Massas , Emissões de Veículos/análise , Compostos Orgânicos Voláteis/análiseRESUMO
Emissions of major reactive nitrogen compounds, including nitric oxide (NO), nitrogen dioxide (NO2) and ammonia (NH3), from heavy-duty diesel vehicles (HDDVs) place substantial pressure on air quality for many large cities in China. To control nitrogen oxide (NOX) emissions from HDDVs, selective catalytic reduction (SCR) systems have been widely used since the China IV standards. To investigate the impacts of aftertreatment technologies and driving conditions on real-world emissions of reactive nitrogen compounds, a portable emissions measurement system was employed to test eighteen heavy-duty diesel trucks in China. The results showed that the China IV and China V HDDVs with appropriate SCR functionality could reduce NOX emissions by 36% and 53%, respectively, compared to the China III results, although their real-world emissions were still higher than the corresponding emission limits for regulatory engine tests. For these HDDVs, five samples were tested with NH3 emissions, ranging from 1.67 ppm to 51.49 ppm. The NH3 emission rates tended to significantly increase under high-speed driving conditions. The results indicate that the current SCR technology may have certain risks in exceeding the future China VI NH3 limit. However, five China IV/V HDDVs were found to have SCR temperature sensors that were intentionally tampered with, resulting in comparable or even higher NOX emissions and zero NH3 emissions. Increased NO2 emissions due to the adoption of diesel oxidation catalysts and diesel particulate filters were also found from our experiments. This study highlights the importance of enhancing in-use compliance requirements and eliminating aftertreatment tampering for China IV and China V HDDVs.