Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 4 de 4
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
Phys Med ; 31(8): 897-902, 2015 Dec.
Artigo em Inglês | MEDLINE | ID: mdl-26160702

RESUMO

PURPOSE: To characterize a synthetic diamond dosimeter (PTW Freiburg microDiamond 60019) in high dose-per-pulse electron beams produced by an Intra Operative Radiation Therapy (IORT) dedicated accelerator. METHODS: The dosimetric properties of the microDiamond were assessed under 6, 8 and 9 MeV electron beams by a NOVAC11 mobile accelerator (Sordina IORT Technologies S.p.A.). The characterization was carried out with dose-per-pulse ranging from 26 to 105 mGy per pulse. The microDiamond performance was compared with an Advanced Markus ionization chamber and a PTW silicon diode E in terms of dose linearity, percentage depth dose (PDD) curves, beam profiles and output factors. RESULTS: A good linearity of the microDiamond response was verified in the dose range from 0.2 Gy to 28 Gy. A sensitivity of 1.29 nC/Gy was measured under IORT electron beams, resulting within 1% with respect to the one obtained in reference condition under (60)Co gamma irradiation. PDD measurements were found in agreement with the ones by the reference dosimeters, with differences in R50 values below 0.3 mm. Profile measurements evidenced a high spatial resolution of the microDiamond, slightly worse than the one of the silicon diode. The penumbra widths measured by the microDiamond resulted approximately 0.5 mm larger than the ones by the Silicon diode. Output factors measured by the microDiamond were found within 2% with those obtained by the Advanced Markus down to 3 cm diameter field sizes. CONCLUSIONS: The microDiamond dosimeter was demonstrated to be suitable for precise dosimetry in IORT applications under high dose-per-pulse conditions.


Assuntos
Diamante , Elétrons , Radiometria/instrumentação , Radioterapia Assistida por Computador/instrumentação , Aceleração
2.
G Chir ; 12(4): 244-9, 1991 Apr.
Artigo em Italiano | MEDLINE | ID: mdl-1911071

RESUMO

The authors relate upon the so-called Boerhaave's syndrome or spontaneous perforation of the esophagus illustrating 2 cases recently observed. On the basis of their experience and of what has been reported by the literature on this subject the etiopathogenetic and pathophysiologic problems as well as the adequate treatment are debated. Particularly the nature of the lesion, which is a barotrauma lesion, the urgency of the surgical treatment, and the severity of the prognosis are pointed out.


Assuntos
Doenças do Esôfago/cirurgia , Idoso , Emergências , Doenças do Esôfago/diagnóstico por imagem , Esôfago/diagnóstico por imagem , Esôfago/cirurgia , Humanos , Masculino , Pessoa de Meia-Idade , Radiografia , Ruptura Espontânea , Síndrome
3.
Phys Med Biol ; 56(14): 4579-96, 2011 Jul 21.
Artigo em Inglês | MEDLINE | ID: mdl-21725139

RESUMO

The aim of this study was to investigate the dosimetric characteristics of the electron beams generated by the light intraoperative accelerator, Liac® (SORDINA, Italy), using Monte Carlo (MC) calculations. Moreover we investigated the possibility of characterizing the Liac® dosimetry with a minimal set of dosimetric data. In fact accelerator commissioning requires measurements of both percentage depth doses (PDDs) and off-axis profiles for all the possible combinations of energy, applicator diameter and bevelled angle. The Liac® geometry and water phantom were simulated in a typical measurement setup, using the MC code EGSnrc/BEAMnrc. A simulated annealing optimization algorithm was used in order to find the optimal non-monoenergetic spectrum of the initial electron beam that minimizes the differences between calculated and measured PDDs. We have concluded that, for each investigated nominal energy beam, only the PDDs of applicators with diameters of 30, 70 and 100 mm and the PDD without an applicator were needed to find the optimal spectra. Finally, the output factors of the entire set of applicator diameters/bevelled angles were calculated. The differences between calculated and experimental output factors were better than 2%, with the exception of the smallest applicator which gave differences between 3% and 4% for all energies. The code turned out to be useful for checking the experimental data from various Liac® beams and will be the basis for developing a tool based on MC simulation to support the medical physicist in the commissioning phase.


Assuntos
Aceleração , Elétrons , Método de Monte Carlo , Radioterapia/instrumentação , Período Intraoperatório
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA