Electromechanical Coupling in Collagen Measured under Increasing Relative Humidity.

The functional role of collagen piezoelectricity has been under debate since the discovery of piezoelectricity in bone in 1957. The possibility that piezoelectricity plays a role in bone remodeling has generated interest in the investigation of this effect in relevant physiological conditions; however, there are conflicting reports as to whether collagen is piezoelectric in a humid environment. In macroscale measurements, the piezoelectricity in hydrated tendon has been shown to be insignificant compared to dehydrated tendon, whereas, at the nanoscale, the piezoelectric effect has been observed in both dry and wet bone using piezoresponse force microscopy (PFM). In this work, the electromechanical properties of type I collagen from a rat tail tendon have been investigated at the nanoscale as a function of humidity using lateral PFM (LPFM) for the first time. The relative humidity (RH) was varied from 10% to 70%, allowing the piezoelectric behavior to be studied dry, humid, as well as in the hydrated range for collagen in physiological bone (12% moisture content, corresponding to 40-50% RH). The results show that collagen piezoresponse can be measured across the humidity range studied, suggesting that piezoelectricity remains a property of collagen at a biologically relevant humidity.

Visualizing molecular polar order in tissues via electromechanical coupling.

Electron microscopy (EM) and atomic force microscopy (AFM) techniques have long been used to characterize collagen fibril ordering and alignment in connective tissues. These techniques, however, are unable to map collagen fibril polarity, i.e., the polar orientation that is directed from the amine to the carboxyl termini. Using a voltage modulated AFM-based technique called piezoresponse force microscopy (PFM), we show it is possible to visualize both the alignment of collagen fibrils within a tissue and the polar orientation of the fibrils with minimal sample preparation. We demonstrate the technique on rat tail tendon and porcine eye tissues in ambient conditions. In each sample, fibrils are arranged into domains whereby neighboring domains exhibit opposite polarizations, which in some cases extend to the individual fibrillar level. Uniform polarity has not been observed in any of the tissues studied. Evidence of anti-parallel ordering of the amine to carboxyl polarity in bundles of fibrils or in individual fibrils is found in all tissues, which has relevance for understanding mechanical and biofunctional properties and the formation of connective tissues. The technique can be applied to any biological material containing piezoelectric biopolymers or polysaccharides.

Capture of circulating tumor cells from whole blood of prostate cancer patients using geometrically enhanced differential immunocapture (GEDI) and a prostate-specific antibody.

Geometrically enhanced differential immunocapture (GEDI) and an antibody for prostate-specific membrane antigen (PSMA) are used for high-efficiency and high-purity capture of prostate circulating tumor cells from peripheral whole blood samples of castrate-resistant prostate cancer patients.

Piezoelectric Tensor of Collagen Fibrils Determined at the Nanoscale.

Piezoelectric properties of rat tail tendons, sectioned at angles of 0, 59, and 90° relative to the plane orthogonal to the major axis, were measured using piezoresponse force microscopy. The piezoelectric tensor at the length scale of an individual fibril was determined from angle-dependent in-plane and out-of-plane piezoelectric measurements. The longitudinal piezoelectric coefficient for individual fibrils at the nanoscale was found to be roughly an order of magnitude greater than that reported for macroscopic measurements of tendon, the low response of which stems from the presence of oppositely oriented fibrils, as confirmed here.

Elucidating the molecular mechanisms underlying cellular response to biophysical cues using synthetic biology approaches.

The use of synthetic surfaces and materials to influence and study cell behavior has vastly progressed our understanding of the underlying molecular mechanisms involved in cellular response to physicochemical and biophysical cues. Reconstituting cytoskeletal proteins and interfacing them with a defined microenvironment has also garnered deep insight into the engineering mechanisms existing within the cell. This review presents recent experimental findings on the influence of several parameters of the extracellular environment on cell behavior and fate, such as substrate topography, stiffness, chemistry and charge. In addition, the use of synthetic environments to measure physical properties of the reconstituted cytoskeleton and their interaction with intracellular proteins such as molecular motors is discussed, which is relevant for understanding cell migration, division and structural integrity, as well as intracellular transport. Insight is provided regarding the next steps to be taken in this interdisciplinary field, in order to achieve the global aim of artificially directing cellular response.

Photoreduction of SERS-active metallic nanostructures on chemically patterned ferroelectric crystals.

Photodeposition of metallic nanostructures onto ferroelectric surfaces is typically based on patterning local surface reactivity via electric field poling. Here, we demonstrate metal deposition onto substrates which have been chemically patterned via proton exchange (i.e., without polarization reversal). The chemical patterning provides the ability to tailor the electrostatic fields near the surface of lithium niobate crystals, and these engineered fields are used to fabricate metallic nanostructures. The effect of the proton exchange process on the piezoelectric and electrostatic properties of the surface is characterized using voltage-modulated atomic force microscopy techniques, which, combined with modeling of the electric fields at the surface of the crystal, reveal that the deposition occurs preferentially along the boundary between ferroelectric and proton-exchanged regions. The metallic nanostructures have been further functionalized with a target probe molecule, 4-aminothiophenol, from which surface-enhanced Raman scattering (SERS) signal is detected, demonstrating the suitability of chemically patterned ferroelectrics as SERS-active templates.