Total value wall: Full scale demonstration of a green wall for grey water treatment and recycling.

Greywater treatment and reuse for non-potable purposes in urban areas has become a widely researched topic to reduce the burden on fresh water resources. This study reports on the use of a green wall for treating grey water and reusing the effluent for toilet flushing, called Total Value Wall (TVW). Initially, the effectiveness of (mixtures of) different substrates, i.e. lava, lightweight expanded clay aggregates, organic soil and biochar was investigated by means of column tests. All substrates were first examined for hydraulic characteristics and later on the columns were fed with synthetic grey wastewater and followed up in terms of removal efficiency of COD and detergents. The mixture consisting of lava (50%), organic soil (25%) and biochar (25%) proved to be optimal both in terms of percolation rates and removal efficiencies, and was thus selected for the full-scale system. The full-scale TVW of 14.4 m2 was installed at a terraced house in Ghent (Belgium), and was loaded with grey water at 100 L per day. Influent and effluent quality were routinely monitored by grab sampling, water savings were monitored by means of flow meters, and electricity consumption was also accounted for. The TVW was further equipped with sensors that measure temperature, Particulate Matter (PM10) and CO2 in the air. The full-scale system obtained effluent concentrations of 13 mg.L-1 TSS, 91 mg.L-1 COD and 5 mg.L-1 BOD5. Ammonium and total coliforms were removed with removal rates of 97% and 99% (2 log units) respectively. However, an increase in effluent concentration of nitrate and phosphate was observed due to leaching from the selected substrate. Available data from the temperature sensors have clearly demonstrated the additional benefit of the TVW as an insulating layer, keeping the heat outside on warmer days, and keeping the heat inside on colder days. Overall, this study demonstrated that the TVW is a sustainable system for greywater treatment and reuse.

Performance of a green wall (Total Value Wall™) at high greywater loading rates and Life Cycle Impact Assessment.

Nature-based greywater (GW) treatment and reuse in urban areas has become an up-and-coming option. A 14.4 m2 green wall system called Total Value Wall (TVW) was installed at a terraced house in Gent (Belgium) for treating GW and reusing the effluent for toilet flushing. In a previous study, the TVW was loaded at 7 L.m-2.d-1 and efficiently removed TSS (67%), COD (43%), BOD5 (83%) and total coliforms (log 2), but a number of issues were reported related to nutrient leaching from the substrate, and the excessive retention time in the storage tanks. In this study results are reported from a follow-up study during which an adapted TVW was subjected to both higher hydraulic and pollutant loading rates in order to investigate the treatment capability of TVW. The design of the system, i.e. substrate contained in geotextile bags, did not sustain the higher hydraulic loading rates as excessive leakage occurred. Despite this, the higher pollutant loading rates still resulted in an acceptable effluent quality with 15 mg.L-1 TSS (90%), 85 mg.L-1 COD (82%), and 15 mg.L-1 BOD5 (95%). Ammonium, E. coli and total coliforms were removed with removal rates of 98%, 63% (0.4 log units), and 36% (0.2 log units), respectively. Finally, a life cycle assessment (LCA) was performed for the TVW with and without treating GW to analyze the environmental burden. The LCA impacts showed that replacing tap water and chemical fertilizer by GW, and the reuse of effluent, have a positive impact. However, the energy use for pumping has a major impact and should be minimized by using an efficient pump and distribution system to reduce the overall footprint.