RESUMO
We present dynamic time-resolved measurements of a multi-pixel analog liquid crystal phase modulator driven at a 1 kHz frame rate. A heterodyne interferometer is used to interrogate two pixels independently and simultaneously, to deconvolve phase modulation with a wide bandwidth. The root mean squared optical phase error within a 30 Hz to 25 kHz bandwidth is <0.5° and the crosstalk rejection is 50 dB. Measurements are shown for a custom-built device with a flexoelectro-optic chiral nematic liquid crystal. However, the technique is applicable to many different types of optical phase modulators and spatial light modulators.
RESUMO
We present here the first time-resolved tilt-angle and retardance measurements for large-tilt (>45°) flexoelectro-optic liquid crystal modulators. These devices have potential for next generation fast switching (>1 kHz), 0-2π analog phase spatial light modulators (SLMs), with applications in optical beamsteering, microscopy and micromachining. The chiral nematic device used consisted of a mixture of CBC7CB and the chiral dopant R5011 in a nominally 5 µm-thick cell, aligned in the uniform lying helix mode. As the device is dynamically switched over angles of ± 54°, retardance changes of up to 0.17λ are observed. Furthermore, the time-resolved measurements reveal an asymmetry in the tilt in the optic-axis depending on the polarity of the applied electric field. The change in the optic-axis exhibits a pattern dependence, whereby it is determined by both the pulse history and the applied field. This pattern dependence results in tilt-angle errors of up to 8.8°, which could manifest as phase errors as large as 35.2° in potential SLMs. These time domain measurements may allow correction of these deterministic errors, to realize practical devices.
RESUMO
A new polarimeter is presented which gives time-resolved measurements of both the optic-axis angle and the linear phase retardation for modulated birefringent optical devices. It is suitable for characterizing dynamic waveplate devices based on liquid crystal and other materials. It is fully automated and requires no angular alignment of the device under test. The system has an absolute angle error of < ± 0.3° and a retardance error of < ± 0.44°, with considerably better relative accuracy. The method has been tested with a chiral nematic liquid crystal device exhibiting flexoelectro-optic switching at 3 kHz in the uniform lying helix mode. These results represent the first time-resolved tilt-angle and phase retardation measurements for a liquid crystal device operating at fast switching frequencies.
RESUMO
We present a flexoelectro-optic liquid crystal (LC) analog phase modulator with >2π phase range at a 1 kHz switching frequency. The chiral nematic LC mixture consists of the bimesogen CBC7CB with chiral dopant R5011, aligned in the uniform lying helix mode. The mixture exhibits >±π/4 rotation of the optic axis for a drive voltage of ±21.5 V (E=±4.5 V µm-1). The rotation of the optic axis is converted into a phase modulation with the aid of a reflective device configuration incorporating a â¼5 µm LC cell, a polarizer, two quarter-wave plates, and a mirror. The residual amplitude modulation is found to be <23%. This flexoelectro-optic phase modulator combination has the potential to enable analog spatial light modulators with very fast frame rates suitable for a range of applications.
RESUMO
Organic-inorganic perovskites are highly promising solar cell materials with laboratory-based power conversion efficiencies already matching those of established thin film technologies. Their exceptional photovoltaic performance is in part attributed to the presence of efficient radiative recombination pathways, thereby opening up the possibility of efficient light-emitting devices. Here, we demonstrate optically pumped amplified spontaneous emission (ASE) at 780 nm from a 50 nm-thick film of CH3NH3PbI3 perovskite that is sandwiched within a cavity composed of a thin-film (â¼7 µm) cholesteric liquid crystal (CLC) reflector and a metal back-reflector. The threshold fluence for ASE in the perovskite film is reduced by at least two orders of magnitude in the presence of the CLC reflector, which results in a factor of two reduction in threshold fluence compared to previous reports. We consider this to be due to improved coupling of the oblique and out-of-plane modes that are reflected into the bulk in addition to any contributions from cavity modes. Furthermore, we also demonstrate enhanced ASE on flexible reflectors and discuss how improvements in the quality factor and reflectivity of the CLC layers could lead to single-mode lasing using CLC reflectors. Our work opens up the possibility of fabricating widely wavelength-tunable "mirror-less" single-mode lasers on flexible substrates, which could find use in applications such as flexible displays and friend or foe identification.
RESUMO
Over the past decade, there has been a rising interest in utilizing functionalized porous polymers for sensor applications. By incorporating functional groups into nanostructured materials like hydrogels, nanosheets, and nanopores, exciting new opportunities have emerged for biomarker detection. The ability of functionalized polymers to undergo physical changes and deformations makes them perfect for modulating optical signals. This chemical mechanism enables the creation of biocompatible sensors for in situ biomarker measurement. Here a comprehensive overview of the current publication trends is provided in functionalized polymers, encompassing functional groups that can induce measurable physical deformations. It explores various materials categorized based on their detection targets, which include proteins, carbohydrates, ions, and deoxyribonucleic acid. As such, this work serves as a valuable reference for the development of functionalized polymer-based sensors.
Assuntos
Nanoporos , Polímeros , Proteínas , Carboidratos , HidrogéisRESUMO
In this Article, we present a series of novel laser-written liquid crystal (LC) devices for aberration control for applications in beam shaping or aberration correction through adaptive optics. Each transparent LC device can correct for a chosen aberration mode with continuous greyscale tuning up to a total magnitude of more than 2π radians phase difference peak to peak at a wavelength of λ = 660 nm. For the purpose of demonstration, we present five different devices for the correction of five independent Zernike polynomial modes (although the technique could readily be used to manufacture devices based on other modes). Each device is operated by a single electrode pair tuned between 0 and 10 V. These devices have potential as a low-cost alternative to spatial light modulators for applications where a low-order aberration correction is sufficient and transmissive geometries are required.
RESUMO
Lasers possess many attractive features (e.g., high brightness, narrow linewidth, well-defined polarization) that make them the ideal illumination source for many different scientific and technological endeavors relating to imaging and the display of high-resolution information. However, their high-level of coherence can result in the formation of noise, referred to as speckle, that can corrupt and degrade images. Here, we demonstrate a new electro-optic technology for combatting laser speckle using a chiral nematic liquid crystal (LC) dispersed with zwitterionic dopants. Results are presented that demonstrate when driven at the optimum electric field conditions, the speckle noise can be reduced by >90% resulting in speckle contrast (C) values of C = 0.07, which is approaching that required to be imperceptible to the human eye. This LC technology is then showcased in an array of different display and imaging applications, including a demonstration of speckle reduction in modern vectorial laser-based imaging.
RESUMO
Using Berreman 4 × 4 optical methods and continuum theory, we investigate the theoretical viewing properties of a potential homeotropically aligned biaxial nematic display switched with in-plane fields. We determine the isocontrast, isotransmission viewing characteristics for wide-angle viewing for in-plane switching and consider the necessary requirements for optical compensation to produce a high transmission in the bright state and low transmission in the dark state. We show how compensation can be achieved with biaxial compensation layers using a homogeneous biaxial film or from birefringence.
RESUMO
The artefact known as speckle can plague numerous imaging applications where the narrow linewidth of laser light is required, which includes laser projection and medical imaging. Here, we report on the use of thin-film chiral nematic liquid crystal (LC) devices that can be used to mitigate the influence of speckle when subjected to an applied electric field. Results are presented which show that the speckle contrast (a quantitative measure of the presence of speckle) can be significantly reduced by decreasing the pitch of the chiral nematic LC from 2700 to 244 nm. Further reduction in the speckle contrast can be observed by operating the diffuser technology at a temperature close to the chiral nematic to isotropic transition. At such temperatures, we observe a simultaneous improvement in the transmission of light through the device and a decrease in the electric field amplitude required for the minimum speckle contrast value. We conclude by presenting a laser projected image of the 1951 USAF target with and without the LC device to demonstrate the visual improvement as a result of the speckle reduction.
RESUMO
Topological defects are a consequence of broken symmetry in ordered systems and are important for understanding a wide variety of phenomena in physics. In liquid crystals (LCs), defects exist as points of discontinuous order in the vector field that describes the average orientation of the molecules in space and are crucial for explaining the fundamental behaviour and properties of these mesophases. Recently, LC defects have also been explored from the perspective of technological applications including self-assembly of nanomaterials, optical-vortex generation and in tunable plasmonic metamaterials. Here, we demonstrate the fabrication and stabilisation of electrically-tunable defects in an LC device using two-photon polymerisation and explore the dynamic behaviour of defects when confined by polymer structures laser-written in topologically discontinuous states. We anticipate that our defect fabrication technique will enable the realisation of tunable, 3D, reconfigurable LC templates towards nanoparticle self-assembly, tunable metamaterials and next-generation spatial light modulators for light-shaping.
RESUMO
In this paper, we demonstrate a flexoelectro-optic liquid crystal phase-only device that uses a chiral nematic reflector to achieve full 2π phase modulation. This configuration is found to be very tolerant to imperfections in the chiral nematic reflector provided that the flexoelectro-optic LC layer fulfils the half-wave condition. Encouragingly, the modulation in the phase, which operates at kHz frame rates, is also accompanied by low amplitude modulation. The configuration demonstrated herein is particularly promising for the development of next-generation liquid crystal on silicon spatial light modulators.
RESUMO
Flexoelectric effects are studied in the domain walls of a nematic liquid crystal device showing the Freedericksz transition. Walls parallel to the alignment direction have a strong twist distortion and an electro-optic effect dominated by e1-e3 is seen. Walls perpendicular to the alignment direction have a strong splay-bend distortion and an electro-optic effect dominated by e1+e3 is seen. This allows the study of both flexoelectric coefficient combinations in a single device.
RESUMO
The symmetry of the cholesteric uniform lying helix (ULH) structure, where the helix axis is aligned in a single direction parallel to the device substrates, is not compatible with a uniform surface alignment and an unwinding of the helical structure is expected at the interface. Fluorescence confocal polarizing microscopy experiments are performed on the interface between a bulk ULH and a uniform aligning surface (for both planar and homeotropic alignments). The results are analyzed in the framework of a finite difference numerical simulation based on the Frank elastic distortion, to determine relevant director structures. An optical model is introduced to predict three-dimensional fluorescence profiles for the structures. Comparison of experimental and theoretical results shows that the equilibrium structure of the system involves a continuous unwinding of the helix close to the surface.
RESUMO
A composite scheme based on the finite-difference time-domain method and a plane-wave expansion method is developed and applied to the optics of periodic liquid-crystal microstructures. This is used to investigate three-dimensional light-wave propagation in grating-induced bistable nematic devices with double periodicity. Detailed models of realistic devices are analyzed with emphasis on two different underlying surface-relief grating structures: a smooth bisinusoidal grating and a square-post array. The influence of the grating feature size is quantified. Device performance is examined in conjunction with an appropriate compensation layer, and the optimum layer thickness is determined for the different grating geometries.