RESUMO
Stability is a key critical quality attribute monitored throughout the development of monoclonal antibody (mAb) therapeutics. Minor changes in their higher order structure (HOS) caused by stress or environment may alter mAb aggregation, immunogenicity, and efficacy. In addition, the structures of the resulting mAb aggregates are largely unknown, as are their dependencies on conditions under which they are created. In this report, we investigate the HOS of mAb monomers and dimers under a variety of forced degradation conditions with ion mobility-mass spectrometry (IM-MS) and collision-induced unfolding (CIU) technologies. We evaluate two model IgG1 antibodies that differ significantly only in their complementarity-determinant regions: IgG1α and IgG1ß. Our data covering both heat- and pH-based forced degradation conditions, aquired on two different IM-MS platforms, show that these mAbs undergo global HOS changes at both monomer and dimer levels upon degradation, but shifts in collision cross section (CCS) differ under pH or heat degradation conditions. In addition, the level of CCS change detected is different between IgG1α and IgG1ß, suggesting that differences in the CDR drive differential responses to degradation that influence the antibody HOS. Dramatically different CIU fingerprints are obtained for IgG1α and IgG1ß monomers and dimers for both degradation conditions. Finally, we constructed a series of computational models of mAb dimers for comparison with experimental CCS values and found evidence for a compact, overlapped dimer structure under native and heat degradation conditions, possibly adopting an inverted or nonoverlapped quaternary structure when produced through pH degredation. We conclude by discussing the potential impact of our findings on ongoing biotherapeutic discovery and development efforts.
Assuntos
Anticorpos Monoclonais , Espectrometria de Mobilidade Iônica , Anticorpos Monoclonais/química , Espectrometria de Massas/métodosRESUMO
Phospholipids (PLs) are a major, diverse constituent of cell membranes. PL diversity arises from the nature of the fatty acid chains, as well as the headgroup structure. The headgroup charge is thought to contribute to both the strength and specificity of protein-membrane interactions. Because it has been difficult to measure membrane charge, ascertaining the role charge plays in these interactions has been challenging. Presented here are charge measurements on lipid Nanodiscs at 20°C in 100 mM NaCl, 50 mM Tris, at pH 7.4. Values are also reported for measurements made in the presence of Ca(2+) and Mg(2+) as a function of NaCl concentration, pH, and temperature, and in solvents containing other types of cations and anions. Measurements were made for neutral (phosphatidylcholine and phosphatidylethanolamine) and anionic (phosphatidylserine, phosphatidic acid, cardiolipin, and phosphatidylinositol 4,5-bisphosphate (PIP2)) PLs containing palmitoyl-oleoyl and dimyristoyl fatty acid chains. In addition, charge measurements were made on Nanodiscs containing an Escherichia coli lipid extract. The data collected reveal that 1) POPE is anionic and not neutral at pH 7.4; 2) high-anionic-content Nanodiscs exhibit polyelectrolyte behavior; 3) 3 mM Ca(2+) neutralizes a constant fraction of the charge, but not a constant amount of charge, for POPS and POPC Nanodiscs; 4) in contrast to some previous work, POPC only interacts weakly with Ca(2+); 5) divalent cations interact with lipids in a lipid- and ion-specific manner for POPA and PIP2 lipids; and 6) the monovalent anion type has little influence on the lipid charge. These results should help eliminate inconsistencies among data obtained using different techniques, membrane systems, and experimental conditions, and they provide foundational data for developing an accurate view of membranes and membrane-protein interactions.
Assuntos
Bicamadas Lipídicas/química , Nanoestruturas/química , Fosfolipídeos/química , Cálcio/química , Eletroforese , Escherichia coli , Concentração de Íons de Hidrogênio , Íons/química , Magnésio/química , Transição de Fase , TemperaturaRESUMO
Forced degradation, also known as stress testing, is used throughout pharmaceutical development for many purposes including assessing the comparability of biopharmaceutical products according to ICH Guideline Q5E. These formal comparability studies, the results of which are submitted to health authorities, investigate potential impacts of manufacturing process changes on the quality, safety, and efficacy of the drug. Despite the wide use of forced degradation in comparability assessments, detailed guidance on the design and interpretation of such studies is scarce. The BioPhorum Development Group is an industry-wide consortium enabling networking and sharing of common practices for the development of biopharmaceuticals. The BioPhorum Development Group Forced Degradation Workstream recently conducted several group discussions and a benchmarking survey to understand current industry approaches for the use of forced degradation studies to assess comparability of protein-based biopharmaceuticals. The results provide insight into the design of forced degradation studies, analytical characterization and testing strategies, data evaluation criteria, as well as some considerations and differences for non-platform modalities (e.g., non-traditional mAbs). This article presents survey responses from several global companies of various sizes and provides an industry perspective and experience regarding the practicalities of using forced degradation to assess comparability.
Assuntos
Produtos Biológicos , Desenvolvimento de Medicamentos , Anticorpos Monoclonais , Indústria Farmacêutica/métodosRESUMO
The diffusion interaction parameter (kD ) has been demonstrated to be a high-throughput technique for characterizing interactions between proteins in solution. kD reflects both attractive and repulsive interactions, including long-ranged electrostatic repulsions. Here, we plot the mutual diffusion coefficient (Dm ) as a function of the experimentally determined Debye-Hückel-Henry surface charge (ZDHH ) for seven human monoclonal antibodies (mAbs) in 15 mM histidine at pH 6. We find that graphs of Dm versus ZDHH intersect at ZDHH, ~ 2.6, independent of protein concentration. The same data plotted as kD versus ZDHH show a transition from net attractive to net repulsive interactions in the same region of the ZDHH intersection point. These data suggest that there is a minimum surface charge necessary on these mAbs needed to overcome attractive interactions.
RESUMO
Calorimeters, which can be used for rapid thermal characterization of biomolecules, are getting intense attention in drug development. This paper presents a novel MEMS-based differential scanning calorimeter (DSC) for direct thermal characterization of protein samples. The DSC consisted of a pair of temperature sensors made by vanadium oxide (VOx) film with a temperature coefficient of resistivity of -0.025/K at 300 K, a microfluidic device with high thermal insulation (2.8 K/mW), and a Peltier heater for linear temperature scanning. The DSC exhibited high sensitivity (6.1 µV/µW), low noise (0.4 µW), high scanning rate (45 K/min), and low sample consumption volume (0.63 µL). The MEMS DSC was verified by measuring the temperature-induced denaturation of lysozyme at different pH, and then used to study the thermal stability of a monoclonal antibody (mAb), an antigen-binding fragment (Fab), and a dual variable domain immunoglobulin (DVD-Ig) at pH = 6. The results showed that lysozyme is a stable protein in the pH range of 4.0-8.0. The protein stability study revealed that the transition temperatures of the intact Fab fragment, mAb, and DVD proteins were comparable with conformational stability results obtained using conventional commercial DSC. These studies demonstrated that the MEMS DSC is an effective tool for directly understanding the thermal stability of antibodies in a high-throughput and low-cost manner compared to conventional calorimeters.
Assuntos
Sistemas Microeletromecânicos , Muramidase , Anticorpos Monoclonais , Varredura Diferencial de Calorimetria , Fragmentos Fab das Imunoglobulinas , TemperaturaRESUMO
Decades of dilute-solution studies have revealed the influence of charged residues on protein stability, solubility and stickiness. Similar characterizations are now required in physiological solutions to understand the effect of charge on protein behavior under native conditions. Toward this end, we used free boundary and native gel electrophoresis to explore the charge of cytochrome c in buffer and in Escherichia coli extracts. We find that the charge of cytochrome c was â¼2-fold lower than predicted from primary structure analysis. Cytochrome c charge was tuned by sulfate binding and was rendered anionic in E. coli extracts due to interactions with macroanions. Mutants in which three or four cationic residues were replaced with glutamate were charge-neutral and "inert" in extracts. A comparison of the interaction propensities of cytochrome c and the mutants emphasizes the role of negative charge in stabilizing physiological environments. Charge-charge repulsion and preferential hydration appear to prevent aggregation. The implications for molecular organization in vivo are discussed.
Assuntos
Misturas Complexas/química , Citocromos c/química , Proteínas de Escherichia coli/química , Escherichia coli/química , Mutação , Agregados Proteicos , Misturas Complexas/genética , Misturas Complexas/metabolismo , Citocromos c/genética , Citocromos c/metabolismo , Escherichia coli/genética , Escherichia coli/metabolismo , Proteínas de Escherichia coli/genética , Proteínas de Escherichia coli/metabolismoRESUMO
We developed an ultrasensitive micro-DSC (differential scanning calorimeter) for liquid protein sample characterization. This design integrated vanadium oxide thermistors and flexible polymer substrates with microfluidics chambers to achieve a high sensitivity (6 V/W), low thermal conductivity (0.7 mW/K), high power resolutions (40 nW), and well-defined liquid volume (1 µl) calorimeter sensor in a compact and cost-effective way. We further demonstrated the performance of the sensor with lysozyme unfolding. The measured transition temperature and enthalpy change were in accordance with the previous literature data. This micro-DSC could potentially raise the prospect of high-throughput biochemical measurement by parallel operation with miniaturized sample consumption.
Assuntos
Dispositivos Lab-On-A-Chip , Técnicas Analíticas Microfluídicas , Varredura Diferencial de Calorimetria/instrumentação , Varredura Diferencial de Calorimetria/métodos , Técnicas Analíticas Microfluídicas/instrumentação , Técnicas Analíticas Microfluídicas/métodosRESUMO
As interest in high-concentration protein formulations has increased, it has become apparent that routine, accurate protein charge measurements are necessary. There are several techniques for charge measurement, and a comparison of the methods is needed. The electrophoretic mobility, effective charge, and Debye-Hückel-Henry charge have been determined for bovine serum albumin, and human serum albumin. Three different electrophoretic methods were used to measure the electrophoretic mobility: capillary electrophoresis, electrophoretic light scattering, and membrane confined electrophoresis. In addition, the effective charge was measured directly using steady-state electrophoresis. Measurements made at different NaCl concentrations, pH, and temperatures allow comparison with previous charge estimates based on electrophoresis, Donnan equilibrium, and pH titration. Similar charge estimates are obtained by all of the methods. The strengths and limitations of each technique are discussed, as are some general considerations about protein charge and charge determination.