RESUMO
We report on a highly efficient, in-band pumped, Q-switched, Tm-doped, rod-type master oscillator power amplifier (MOPA) system delivering up to 140â W average output power and 7â mJ pulse energy with a slope efficiency of 77% at 20â kHz repetition rate. The amplifier is pumped with Raman-shifted fiber lasers centered at 1692â nm. This in-band pump scheme for Tm-doped fiber lasers can significantly mitigate their quantum defect-related heat load limitations. At the same time, this pump wavelength yields a similar amount of storable and extractable energy to the state-of-the-art pumping at 793â nm. This approach has allowed for the development of highly efficient Tm-doped fiber laser systems combining a high average power and a high output pulse energy.
RESUMO
We investigate the influence of the pump wavelength on the high-power amplification of large-mode area, thulium-doped fibers which are suitable for an ultrashort pulsed operation in the 2 µm wavelength region. By pumping a standard, commercially available photonic crystal fiber in an amplifier configuration at 1692 nm, a slope efficiency of 80 % at an average output power of 60 W could be shown. With the help of simulations we investigate the effect of cross-relaxations on the efficiency and the thermal behavior. We extend our investigations to a rod-type, large-pitch fiber with very large mode area, which is exceptionally suited for high-energy ultrafast operation. Pumping at 1692 nm leads to a slope efficiency of 74 % with a average output power of 67 W, instead of the 38 % slope efficiency obtained when pumping at 793 nm. These results pave the way to highly efficient 2 µm fiber-based CPA systems.
RESUMO
High-energy, ultrafast, short-wavelength infrared laser sources with high average power are important tools for industrial and scientific applications. Through the coherent combination of four ultrafast thulium-doped rod-type fiber amplifiers, we demonstrate a Tm-doped chirped pulse amplification system with a compressed pulse energy of 1.65 mJ and 167 W of average output power at a repetition rate of 101 kHz. The system delivers 85 fs pulses with a peak power of 15 GW. Additionally, the system presents a high long- and short-term stability. To the best of our knowledge, this is the highest average output power short wavelength IR, mJ-class source to date. This result shows the potential of coherent beam combining techniques in the short wavelength infrared spectral region for the power scalability of these systems.
RESUMO
We experimentally analyze the average-power-scaling capabilities of ultrafast, thulium-doped fiber amplifiers. It has been theoretically predicted that thulium-doped fiber laser systems, with an emission wavelength around 2 µm, should be able to withstand much higher heat-loads than their Yb-doped counterparts before the onset of transverse mode instability (TMI) is observed. In this work we experimentally verify this theoretical prediction by operating thulium doped fibers at very high heat-load. In separate experiments we analyze the performance of two different large-core, thulium-doped fiber amplifiers. The first experiment aims at operating a short, very-large core, thulium-doped fiber amplifier at extreme heat-load levels of more than 300 W/m. Even at this extreme heat-load level, the onset of TMI is not observed. The second experiment maximizes the extractable average-output power from a large-core, thulium-doped, fiber amplifier. We have achieved a pump-limited average output power of 1.15 kW without the onset of TMI. However, during a longer period of operation at this power level the amplifier performance steadily degraded and TMI could be observed for average powers in excess of 847 W thereafter. This is the first time, to the best of our knowledge, that TMI has been reported in a thulium-doped fiber amplifier.
RESUMO
We report on soliton-fission mediated infrared supercontinuum generation in liquid-core step-index fibers using highly transparent carbon chlorides (CCl4, C2Cl4). By developing models for the refractive index dispersions and nonlinear response functions, dispersion engineering and pumping with an ultrafast thulium fiber laser (300 fs) at 1.92 µm, distinct soliton fission and dispersive wave generation was observed, particularly in the case of tetrachloroethylene (C2Cl4). The measured results match simulations of both the generalized and a hybrid nonlinear Schrödinger equation, with the latter resembling the characteristics of non-instantaneous medium via a static potential term and representing a simulation tool with substantially reduced complexity. We show that C2Cl4 has the potential for observing non-instantaneous soliton dynamics along meters of liquid-core fiber opening a feasible route for directly observing hybrid soliton dynamics.
RESUMO
We present a rigorous study on the impact of atmospheric molecular absorption on the linear propagation of ultrashort pulses in the mid-infrared wavelength region. An ultrafast thulium-based fiber laser was employed to experimentally investigate ultrashort-pulse propagation through the atmosphere in a spectral region containing several strong molecular absorption lines. The atmospheric absorption profile causes a significant degradation of the pulse quality in the time domain as well as a distortion of the transverse beam profile in the spatial domain. Numerical simulations carried out in the small signal limit accurately reproduce the experimental observations in the time domain and reveal that the relative loss in peak power after propagation can be more than twice as high as the relative amount of absorbed average power. Although their nature is purely linear (i.e. the intensities considered are sufficiently low) the discussed effects represent significant challenges to performance-scaling of mid-infrared ultrafast lasers operating in spectral regions with molecular absorption bands. Guidelines for an efficient mitigation of the pulse quality degradation and the beam profile distortion are discussed.
RESUMO
Tm-based fiber-laser systems are an attractive concept for the development of high-performance laser sources in the spectral region around 2 µm wavelength. Here we present a system delivering a pulse-peak power higher than 200 MW in combination with 24 W average power and 120 µJ pulse energy. Key components enabling this performance level are a Tm-doped large-pitch fiber with a mode-field diameter of 65 µm, highly efficient dielectric gratings, and a Tm-based fiber oscillator operating in the stretched-pulse regime.
Assuntos
Lasers , Fibras Ópticas , TúlioRESUMO
We report on the utilization of a novel Tm:fiber laser source for mid-IR ZnGeP2 (ZGP) optical parametric oscillator (OPO) pumping. The pump laser is built in a master oscillator power-amplifier configuration delivering up to 3.36 W of polarized, diffraction limited output power with 7 ns pulse duration and 4 kHz repetition rate. This corresponds to a peak power of â¼121 kW and a pulse energy of â¼0.84 mJ. With this source, we generated 27.9 kW of total mid-IR peak power in a doubly resonant oscillator (DRO) configuration. This is, to the best of our knowledge, the highest ever demonstrated mid-IR peak power from a directly Tm:fiber laser pumped ZGP OPO. Moreover, a DRO output with about 284 µJ of total mid-IR pulse energy was demonstrated using 100 ns pump pulses. The wavelength tuning of the idler was extended to 6 µm with lower output power in another OPO experiment.
RESUMO
A high-power thulium (Tm)-doped fiber chirped-pulse amplification system emitting a record compressed average output power of 152 W and 4 MW peak power is demonstrated. This result is enabled by utilizing Tm-doped photonic crystal fibers with mode-field diameters of 35 µm, which mitigate detrimental nonlinearities, exhibit slope efficiencies of more than 50%, and allow for reaching a pump-power-limited average output power of 241 W. The high-compression efficiency has been achieved by using multilayer dielectric gratings with diffraction efficiencies higher than 98%.
Assuntos
Amplificadores Eletrônicos , Transferência de Energia , Tecnologia de Fibra Óptica/instrumentação , Lasers , Túlio/química , Desenho de Equipamento , Análise de Falha de Equipamento , Túlio/efeitos da radiaçãoRESUMO
We present a novel ytterbium (Yb)-doped large-pitch fiber design with significantly increased pump absorption and higher energy storage/gain per unit length, which enables high-peak-power fiber laser systems with smaller footprints. Up to now index matching between core and surrounding material in microstructured fibers was achieved by co-doping the active core region with fluorine. Here we carry out the index matching by passively doping the cladding with germanium, thus raising its index of refraction. Hence, the fluorine in the core can be omitted, which leads to an effective increase of the core doping concentration, while detrimental effects such as photo-darkening and lifetime quenching are avoided by maintaining the bulk Yb concentration. Experiments and simulations show that a gain higher than 50 dB/m and an output average power higher than 100 W with excellent beam quality are feasible even with a fiber length of only 40 cm.
RESUMO
We report amplification of sub-10-100 ns pulses with repetition rates from 1 to 20 kHz in a rod-type thulium-doped photonic crystal fiber with 80 µm core diameter. The rod is pumped with a 793 nm laser diode and produces the highest peak power at 1 kHz repetition rate with 6.5 ns pulse duration and more than 7 W average output power. This result exemplifies the potential of this fiber design to scale pulse peak powers and pulse energies to the megawatt and multi-millijoule range in the 2 µm wavelength regime.
RESUMO
We report lasing and amplification in a rod type thulium-doped photonic crystal fiber with 80 µm core diameter. The rod is pumped with a 793 nm laser diode and produces more than 20 W output power at a beam quality M(2)<1.3. The laser/amplifier has a slope efficiency of 27.8%/20.1% relative to absorbed pump power with a lasing threshold at 28.6 W. The output wavelength in the lasing configuration can be tuned over 180 nm from 1810-1990 nm.
RESUMO
A high-speed mode analysis technique is required to gain fundamental understanding of mode instabilities in high-power fiber laser systems. In this work a technique, purely based on the intensity profile of the beam, is demonstrated to be ideally suited to analyze fiber laser dynamics. This technique, together with a high-speed camera, has been applied to the study of the temporal dynamics of mode instabilities at high average powers with up to 20,000 frames per second. These measurements confirm that energy transfer between the fluctuating transversal modes takes place in millisecond-time-scale.
RESUMO
The development of high-power, broadband sources of coherent mid-infrared radiation is currently the subject of intense research that is driven by a substantial number of existing and continuously emerging applications in medical diagnostics, spectroscopy, microscopy, and fundamental science. One of the major, long-standing challenges in improving the performance of these applications has been the construction of compact, broadband mid-infrared radiation sources, which unify the properties of high brightness and spatial and temporal coherence. Due to the lack of such radiation sources, several emerging applications can be addressed only with infrared (IR)-beamlines in large-scale synchrotron facilities, which are limited regarding user access and only partially fulfill these properties. Here, we present a table-top, broadband, coherent mid-infrared light source that provides brightness at an unprecedented level that supersedes that of synchrotrons in the wavelength range between 3.7 and 18 µm by several orders of magnitude. This result is enabled by a high-power, few-cycle Tm-doped fiber laser system, which is employed as a pump at 1.9 µm wavelength for intrapulse difference frequency generation (IPDFG). IPDFG intrinsically ensures the formation of carrier-envelope-phase stable pulses, which provide ideal prerequisites for state-of-the-art spectroscopy and microscopy.
RESUMO
The discovery of optical solitons being understood as temporally and spectrally stationary optical states has enabled numerous innovations among which, most notably, supercontinuum light sources have become widely used in both fundamental and applied sciences. Here, we report on experimental evidence for dynamics of hybrid solitons-a new type of solitary wave, which emerges as a result of a strong non-instantaneous nonlinear response in CS2-filled liquid-core optical fibres. Octave-spanning supercontinua in the mid-infrared region are observed when pumping the hybrid waveguide with a 460 fs laser (1.95 µm) in the anomalous dispersion regime at nanojoule-level pulse energies. A detailed numerical analysis well correlated with the experiment uncovers clear indicators of emerging hybrid solitons, revealing their impact on the bandwidth, onset energy and noise characteristics of the supercontinua. Our study highlights liquid-core fibres as a promising platform for fundamental optics and applications towards novel coherent and reconfigurable light sources.Here, Chemnitz et al. report experimental evidence for hybrid solitons - a type of solitary wave, which emerges as a result of a strong non-instantaneous nonlinear response in CS2-filled liquid-core optical fibres, demonstrating efficient soliton-driven supercontinuum generation.