RESUMO
The global issue of ongoing trace metal emissions and legacy accumulation from diverse sources is posing threats to coastal wildlife. This study characterized the distribution of five metals in relation to dietary ecology (carbon and nitrogen stable isotopes: δ15N and δ13C) in representative predatory species (starfish, fish, and seabird) collected from the coast of Qingdao, northeastern China. Zinc (Zn) was the most abundant metal across species, followed by copper (Cu), chromium (Cr), cadmium (Cd), total and methylated mercury (THg and MeHg). Among the studied species, black-tailed gulls (Larus crassirostris) occupied the highest trophic position, followed by three predatory fish species, whereas the northern Pacific seastar (Asterias amurensis) had the lowest trophic position. The starfish exhibited high capacity to accumulate Cd, Cr and Cu. Conversely, black-tailed gulls exhibited high levels of Zn, while Hg was highest in predatory fishes. Across species, Cr, MeHg, THg and MeHg:THg showed significant positive correlations with δ13C, suggesting the influence of inshore food sources on their accumulation. Both MeHg and THg were significantly and positively correlated with δ15N, with MeHg demonstrating a greater slope, indicating their potential trophic magnification. We assessed health risks from the studied metals using established toxicity reference thresholds. Elevated risks of Hg were identified in three predatory fish species, while other metals and species remain within safe limits. These findings emphasize the significance of foraging patterns in influencing trace metal accumulation in coastal predators and highlight the importance of further monitoring.
Assuntos
Mercúrio , Oligoelementos , Poluentes Químicos da Água , Animais , Cádmio , Cadeia Alimentar , Monitoramento Ambiental , Mercúrio/análise , Metais/toxicidade , Isótopos de Nitrogênio , Zinco , Poluentes Químicos da Água/análise , PeixesRESUMO
The loose accumulation CAUSED by landslide, collapse, debris flow, and mine blasting, exerts considerable negative influence to human activities. Besides, it can easily trigger secondary disaster under inner and outer geological conditions. Extraction and measurement of the particle of loose accumulation is of importance for prediction of slope stability and mine blasting. In this paper, the 3D laser scanning is utilized to collect the point clouds of granular materials in physical model (three types of materials) and landslide accumulation in field, respectively. Then, the alpha shapes (AS) and hill climbing-region growing (HC-RG) algorithms are introduced for identifying particles and finding their dimensions (e.g., particle number and radii). Comparison between the recognition results and reality shows that both algorithms can provide a good performance in laboratory physical model, and acceptable results can be obtained when applying two algorithm to field survey. AS algorithm needs less time to process data than HC-GR algorithm; however, the recognition from HC-RG algorithm is more accurate than that by AS algorithm.
Assuntos
Algoritmos , Tamanho da Partícula , Simulação por Computador , Modelos TeóricosRESUMO
Deformation monitoring is a powerful tool to understand the formation mechanism of earth fissure hazards, enabling the engineering and planning efforts to be more effective. To assess the evolution characteristics of the Yangshuli earth fissure hazard more completely, terrestrial laser scanning (TLS), a remote sensing technique which is regarded as one of the most promising surveying technologies in geohazard monitoring, was employed to detect the changes to ground surfaces and buildings in small- and large-scales, respectively. Time-series of high-density point clouds were collected through 5 sequential scans from 2014 to 2017 and then pre-processing was performed to filter the noise data of point clouds. A tiny deformation was observed on both the scarp and the walls, based on the local displacement analysis. The relative height differences between the two sides of the scarp increase slowly from 0.169 m to 0.178 m, while no obvious inclining (the maximum tilt reaches just to 0.0023) happens on the two walls, based on tilt measurement. Meanwhile, global displacement analysis indicates that the overall settlement slowly increases for the ground surface, but the regions in the left side of scarp are characterized by a relatively larger vertical displacement than the right. Furthermore, the comparisons of monitoring results on the same measuring line are discussed in this study and TLS monitoring results have an acceptable consistency with the global positioning system (GPS) measurements. The case study shows that the TLS technique can provide an adequate solution in deformation monitoring of earth fissure hazards, with high effectiveness and applicability.
RESUMO
The outbreak of COVID-19 has imposed a great threat both to people's health and to social relations. By following the theoretical constructions of critical genre analysis and critical discourse analysis and drawing on the 35 press conferences on the COVID-19 outbreak in China, this paper explores how the discourse of press conferences is used by the Chinese government as a means of crisis management to (re)construct social relations. The analysis of the data reveals a hybridity of social relations reproduced discursively between such social actors as government institutions, the general public, medical institutions or staff, and COVID-19 patients, and a distinct feature of interdiscursivity of the discourse of press conferences on COVID-19, with descriptive, instructional, strategic, and evaluative discourses being the most frequently employed. It is also found that political, professional, social, and cultural forces are interwoven with each other to contribute to the interdiscursivity of the discourse of press conferences and the hybridity of social relations constructed thereof.
RESUMO
Shear behavior of rock mass greatly depends upon the rock joint roughness which is generally characterized by anisotropy, scale effect and interval effect. A new index enabling to capture all the three features, namely brightness area percentage (BAP), is presented to express the roughness based on synthetic illumination of a digital terrain model derived from terrestrial laser scanner (TLS). Since only tiny planes facing opposite to shear direction make contribution to resistance during shear failure, therefore these planes are recognized through the image processing technique by taking advantage of the fact that they appear brighter than other ones under the same light source. Comparison with existing roughness indexes and two case studies were illustrated to test the performance of BAP description. The results reveal that the rock joint roughness estimated by the presented description has a good match with existing roughness methods and displays a wider applicability.