RESUMO
The complex and heterogeneous nature of the lignin macromolecule has presented a lasting barrier to its utilization. To achieve high lignin yield, the technical lignin extraction process usually severely modifies and condenses the native structure of lignin, which is a critical drawback for its utilization in conversion processes. In addition, there is no method capable of separating lignin from plant biomass with controlled structural properties. Here, we developed an N-heterocycle-based deep eutectic solvent formed between lactic acid and pyrazole (La-Py DES) with a binary hydrogen bonding functionality resulting in a high affinity toward lignin. Up to 93.7% of lignin was extracted from wheat straw biomass at varying conditions from 90 °C to 145 °C. Through careful selection of treatment conditions as well as lactic acid to pyrazole ratios, lignin with controlled levels of ether linkage content, hydroxyl group content, and average molecular weight can be generated. Under mild extraction conditions (90 °C to 120 °C), light-colored native-like lignin can be produced with up to 80% yield, whereas ether linkage-free lignin with low polydispersity can be obtained at 145 °C. Overall, this study offers a new strategy for native lignin extraction and generating lignin with controlled structural properties.
RESUMO
Ethanol can be used as a platform molecule for synthesizing valuable chemicals and fuel precursors. Direct synthesis of C5+ ketones, building blocks for lubricants and hydrocarbon fuels, from ethanol was achieved over a stable Pd-promoted ZnO-ZrO2 catalyst. The sequence of reaction steps involved in the C5+ ketone formation from ethanol was determined. The key reaction steps were found to be the inâ situ generation of the acetone intermediate and the cross-aldol condensation between the reaction intermediates acetaldehyde and acetone. The formation of a Pd-Zn alloy inâ situ was identified to be the critical factor in maintaining high yield to the C5+ ketones and the stability of the catalyst. A yield of >70 % to C5+ ketones was achieved over a 0.1 % Pd-ZnO-ZrO2 mixed oxide catalyst, and the catalyst was demonstrated to be stable beyond 2000â hours on stream without any catalyst deactivation.
RESUMO
The formation of carbonaceous deposits (coke) in zeolite pores during catalysis leads to temporary deactivation of catalyst, necessitating regeneration steps, affecting throughput, and resulting in partial permanent loss of catalytic efficiency. Yet, even to date, the coke molecule distribution is quite challenging to study with high spatial resolution from surface to bulk of the catalyst particles at a single particle level. To address this challenge we investigated the coke molecules in HZSM-5 catalyst after ethanol conversion treatment by a combination of C K-edge X-ray absorption spectroscopy (XAS), 13C Cross polarization-magic angle spinning nuclear magnetic resonance (CP-MAS NMR) spectroscopy, and atom probe tomography (APT). XAS and NMR highlighted the aromatic character of coke molecules. APT permitted the imaging of the spatial distribution of hydrocarbon molecules located within the pores of spent HZSM-5 catalyst from surface to bulk at a single particle level. 27Al NMR results and APT results indicated association of coke molecules with Al enriched regions within the spent HZSM-5 catalyst particles. The experimental results were additionally validated by a level-set-based APT field evaporation model. These results provide a new approach to investigate catalytic deactivation due to hydrocarbon coking or poisoning of zeolites at an unprecedented spatial resolution.