RESUMO
Colloidal quantum dots which can emit red, green, and blue colors are incorporated with a micro-LED array to demonstrate a feasible choice for future display technology. The pitch of the micro-LED array is 40 µm, which is sufficient for high-resolution screen applications. The method that was used to spray the quantum dots in such tight space is called Aerosol Jet technology which uses atomizer and gas flow control to obtain uniform and controlled narrow spots. The ultra-violet LEDs are used in the array to excite the red, green and blue quantum dots on the top surface. To increase the utilization of the UV photons, a layer of distributed Bragg reflector was laid down on the device to reflect most of the leaked UV photons back to the quantum dot layers. With this mechanism, the enhanced luminous flux is 194% (blue), 173% (green) and 183% (red) more than that of the samples without the reflector. The luminous efficacy of radiation (LER) was measured under various currents and a value of 165 lm/Watt was recorded.
RESUMO
This study demonstrates the flexible white LED structure with high lumen efficiency and uniform optical performance for neutral white and warm white CCT. Flip-chip LEDs were attached on a polyimide substrate with copper strips as electrical and thermal conduction paths. Yellow phosphors are mixed with polydimenthysiloxane (PDMS) to provide mechanical support and flexibility. The light efficiency of this device can reach 120 lm/W and 85% of light output uniformity of the emission area can be achieved. Moreover, the optical simulation is employed to evaluate various designs of this flexible film in order to obtain uniform output. Both the pitch between the individual devices and the thickness of the phosphor film are calculated for optimization purpose. This flexible white LED with high lumen efficiency and good reliability is suitable for the large area fixture in the general lighting applications.
RESUMO
Because of the Sun's movement across the sky, broadband and omnidirectional light harvesting is a major development in photovoltaic technology. This study reports the fabrication and characterization of flexible-textured polydimethylsiloxane (PDMS) film on Cu(In,Ga)Se2 (CIGS) solar cells, which is one of the simplest and cheapest peel-off processes for fabricating a three-dimensional structure. A cell containing a textured PDMS film enhanced the short-circuit current density from 22.12 to 23.93 mA/cm2 in a simulated one-sun scenario. The omnidirectional antireflection of CIGS solar cells containing various PDMS films is also investigated. This study uses an angle-resolved reflectance spectroscope to investigate the omnidirectional and broadband optical properties of the proposed PDMS film. This improvement in light harvesting is attributable to the scattering of the PDMS film and the gradual refractive index profile between the PDMS microstructures and air. The flexible-textured PDMS film is suitable for creating an antireflective coating for a diverse range of photovoltaic devices.
RESUMO
Biomimetic nanostructures have shown to enhance the optical absorption of Ga(0.5)In(0.5)P/GaAs/Ge triple junction solar cells due to excellent antireflective (AR) properties that, however, are highly dependent on their geometric dimensions. In practice, it is challenging to control fabrication conditions which produce nanostructures in ideal periodic arrangements and with tapered side-wall profiles, leading to sacrificed AR properties and solar cell performance. In this work, we introduce compound biomimetic nanostructures created by depositing a layer of silicon dioxide (SiO(2)) on top of titanium dioxide (TiO(2)) nanostructures for triple junction solar cells. The device exhibits photogenerated current and power conversion efficiency that are enhanced by ~8.9% and ~6.4%, respectively, after deposition due to their improved antireflection characteristics. We further investigate and verify the optical properties of compound structures via a rigorous coupled wave analysis model. The additional SiO(2) layer not only improves the geometric profile, but also serves as a double-layer dielectric coating. It is concluded that the compound biomimetic nanostructures exhibit superior AR properties that are relatively insensitive to fabrication constraints. Therefore, the compound approach can be widely adopted for versatile optoelectronic devices and applications.
RESUMO
Biomimetic nanostructures have shown to enhance the optical absorption of Ga0.5In0.5P/GaAs/Ge triple junction solar cells due to excellent antireflective (AR) properties that, however, are highly dependent on their geometric dimensions. In practice, it is challenging to control fabrication conditions which produce nanostructures in ideal periodic arrangements and with tapered side-wall profiles, leading to sacrificed AR properties and solar cell performance. In this work, we introduce compound biomimetic nanostructures created by depositing a layer of silicon dioxide (SiO2) on top of titanium dioxide (TiO2) nanostructures for triple junction solar cells. The device exhibits photogenerated current and power conversion efficiency that are enhanced by ~8.9% and ~6.4%, respectively, after deposition due to their improved antireflection characteristics. We further investigate and verify the optical properties of compound structures via a rigorous coupled wave analysis model. The additional SiO2 layer not only improves the geometric profile, but also serves as a double-layer dielectric coating. It is concluded that the compound biomimetic nanostructures exhibit superior AR properties that are relatively insensitive to fabrication constraints. Therefore, the compound approach can be widely adopted for versatile optoelectronic devices and applications.
RESUMO
In this review, the concept of utilization of solar spectrum in order to increase the solar cell efficiency is discussed. Among the three mechanisms, down-shifting effect is investigated in detail. Organic dye, rare-earth minerals and quantum dots are three most popular down-shift materials. While the enhancement of solar cell efficiency was not clearly observed in the past, the advances in quantum dot fabrication have brought strong response out of the hybrid platform of a quantum dot solar cell. A multiple layer structure, including PDMS as the isolation layer, is proposed and demonstrated. With the help of pulse spray system, precise control can be achieved and the optimized concentration can be found.
Assuntos
Compostos de Cádmio/química , Compostos de Cádmio/efeitos da radiação , Fontes de Energia Elétrica , Nanotecnologia/instrumentação , Pontos Quânticos , Compostos de Selênio/química , Compostos de Selênio/efeitos da radiação , Energia Solar , Transferência de Energia/efeitos da radiação , Desenho de Equipamento , Análise de Falha de EquipamentoRESUMO
We demonstrate a hybrid design of traditional GaAs-based solar cell combined with colloidal CdS quantum dots. With anti-reflective feature at long wavelength and down-conversion at UV regime, the CdS quantum dot effectively enhance the overall power conversion efficiency by as high as 18.9% compared to traditional GaAs-based device. A more detailed study showed an increase of surface photoconductivity due to UV presence, and the fill factor of the solar cell can be improved accordingly.
RESUMO
The high luminous efficiency and superior uniformity of angular-dependent correlated color temperature (CCT) white light-emitting diodes have been investigated by ZrO2 nano-particles in a remote phosphor structure. By adding ZrO2 nano-particles with silicone onto the surface of the phosphor layer, the capability of light scattering could be enhanced. In particular, the intensity of blue light at large angles was increased and the CCT deviations could be reduced. Besides, the luminous flux was improved due to the ZrO2 nano-particles with silicone providing a suitable refractive index between air and phosphor layers. This novel structure reduces angular-dependent CCT deviations from 1000 to 420 K in the range of -70° to 70°. Moreover, the enhancement of lumen flux was increased by 2.25% at a driving current 120 mA, compared to a conventional remote phosphor structure without ZrO2 nano-particles. Consequently, the ZrO2 nano-particles in a remote phosphor structure could not only improve the uniformity of lighting but also increase the light output.
RESUMO
In this paper, the high performance GaN-based light-emitting diodes (LEDs) with embedded microscale air voids and an SiO(2) nanomask by metal-organic chemical vapor deposition (MOCVD) were demonstrated. Microscale air voids and an SiO(2) nanomask were clearly observed at the interface between GaN nanorods (NRs) and the overgrown GaN layer by scanning electron microscopy (SEM). From the reflectance spectra we show strong reflectance differences due to the different refractive index gradient between the GaN grown on the nanotemplate and sapphire. It can increase the light extraction efficiency due to additional light scattering. The transmission electron microscopy (TEM) images show the threading dislocations were suppressed by nanoscale epitaxial lateral overgrowth (NELOG). The LEDs with embedded microscale air voids and an SiO(2) nanomask exhibit smaller reverse-bias current and large enhancement of the light output (65% at 20 mA) compared with conventional LEDs.
RESUMO
In this study, a novel photoluminescent quantum dots device with laser-processed microscale patterns has been demonstrated to be used as a white light emitting source. The pulsed laser ablation technique was employed to directly fabricate microscale square holes with nano-ripple structures onto the sapphire substrate of a flip-chip blue light-emitting diode, confining sprayed quantum dots into well-defined areas and eliminating the coffee ring effect. The electroluminescence characterizations showed that the white light emission from the developed photoluminescent quantum-dot light-emitting diode exhibits stable emission at different driving currents. With a flexibility of controlling the quantum dots proportions in the patterned square holes, our developed white-light emitting source not only can be employed in the display applications with color triangle enlarged by 47% compared with the NTSC standard, but also provide the great potential in future lighting industry with the correlated color temperature continuously changed in a wide range.
RESUMO
Atomically thin two-dimensional transition-metal dichalcogenides (TMDCs) have attracted much attention recently due to their unique electronic and optical properties for future optoelectronic devices. The chemical vapor deposition (CVD) method is able to generate TMDCs layers with a scalable size and a controllable thickness. However, the TMDC monolayers grown by CVD may incorporate structural defects, and it is fundamentally important to understand the relation between photoluminescence and structural defects. In this report, point defects (Se vacancies) and oxidized Se defects in CVD-grown MoSe2 monolayers are identified by transmission electron microscopy and X-ray photoelectron spectroscopy. These defects can significantly trap free charge carriers and localize excitons, leading to the smearing of free band-to-band exciton emission. Here, we report that the simple hydrohalic acid treatment (such as HBr) is able to efficiently suppress the trap-state emission and promote the neutral exciton and trion emission in defective MoSe2 monolayers through the p-doping process, where the overall photoluminescence intensity at room temperature can be enhanced by a factor of 30. We show that HBr treatment is able to activate distinctive trion and free exciton emissions even from highly defective MoSe2 layers. Our results suggest that the HBr treatment not only reduces the n-doping in MoSe2 but also reduces the structural defects. The results provide further insights of the control and tailoring the exciton emission from CVD-grown monolayer TMDCs.
RESUMO
This paper presents a hybrid design, featuring a traditional GaAs-based solar cell combined with various colloidal quantum dots. This hybrid design effectively boosts photon harvesting at long wavelengths while enhancing the collection of photogenerated carriers in the ultraviolet region. The merits of using highly efficient semiconductor solar cells and colloidal quantum dots were seamlessly combined to increase overall power conversion efficiency. Several photovoltaic parameters, including short-circuit current density, open circuit voltage, and external quantum efficiency, were measured and analyzed to investigate the performance of this hybrid device. Offering antireflective features at long wavelengths and luminescent downshifting for high-energy photons, the quantum dots effectively enhanced overall power conversion efficiency by as high as 24.65% compared with traditional GaAs-based devices. The evolution of weighted reflectance as a function of the dilution factor of QDs was investigated. Further analysis of the quantum efficiency response showed that the luminescent downshifting effect can be as much as 6.6% of the entire enhancement of photogenerated current.
RESUMO
To enhance the uniformity of correlated color temperature (CCT) and luminous flux, we integrated ZrO2 nanoparticles into white light-emitting diodes. This novel packaging scheme led to a more than 12% increase in luminous flux as compared to that in conventional dispensing structures. This was attributed to the scattering effect of ZrO2 nanoparticles, which enhanced the utilization of blue light. Moreover, the CCT deviation was reduced from 522 to 7 K in a range of -70 to +70°, and essentially eliminated the yellow ring phenomenon. The haze measurement indicated strong scattering across the visible spectrum in the presence of ZrO2 in the silicone layer, and this finding also substantiates our claim. In addition, the chromaticity coordinate shift was steady in the ZrO2 dispensing package structure as the drive current increased, which is crucial for indoor lighting. Combined with its low cost, easy fabrication, and superior optical characteristics, ZrO2 nanoparticles can be an effective performance enhancer for the future generation of white light-emitting devices.
RESUMO
An effective approach is demonstrated for enhancing photoelectric conversion of Cu(In,Ga)Se2 (CIGS) solar cells with three-dimensional ZnO nanotree arrays. Under a simulated one-sun condition, cells with ZnO nanotree arrays enhance the short-circuit current density by 10.62%. The omnidirectional anti-reflection of CIGS solar cells with various ZnO nanostructures is also investigated. The solar-spectrum weighted reflectance is approximately less than 5% for incident angles of up to 60° and for the wavelengths primarily from 400 nm to 1000 nm. This enhancement in light harvesting is attributable to the gradual refractive index profile between the ZnO nanostructures and air.
RESUMO
Broadband and omnidirectional light harvesting is important in photovoltaic technology because of its wide spectral range of radiation and the sun's movement. This study reports the fabrication and characterization of zinc oxide (ZnO) dandelions on Cu(In,Ga)Se2 (CIGS) solar cells. The fabrication of dandelions involves the combination of self-assembled polystyrene (PS) nanospheres and the hydrothermal method, which is one of the simplest and cheapest methods of fabricating a three-dimensional, closely packed periodic structure. This study also investigates the optimization on dimension of the PS nanospheres using the rigorous coupled-wave analysis (RCWA) method. This study uses an angle-resolved reflectance spectroscope and a homemade rotatable photo I-V measurement to investigate the omnidirectional and broadband antireflections of the proposed dandelion structure. Under a simulated one-sun condition and a light incident angle of up to 60°, cells with ZnO dandelions arrays enhanced the short-circuit current density by 31.87%. Consequently, ZnO dandelions are suitable for creating an omnidirectionally antireflective coating for photovoltaic devices.