RESUMO
This paper reports the effect of a magnetic field on plasma parameters and surface structuring of the Mg alloy after laser irradiation. Femtosecond pulses of a Ti:sapphire laser system (800 nm, 35 fs, 1 KHz) are employed as the source of irradiation at various irradiances ranging from 0.011P W/c m 2 to 0.117P W/c m 2 to generate ablated Mg-alloy plasma. A transvers magnetic field (TMF) of strength 1.1 Tesla is employed to confine laser generated Mg plasma. All the measurements are performed with and without TMF. The two plasma parameters, i.e., excitation temperature (T e x c ) and electron number density (n e) of Mg plasma, have been evaluated by laser-induced breakdown spectroscopy (LIBS) analysis. It is observed that the values of T e x c and n e of laser produced plasma (LPP) of the Mg alloy are higher in the presence of a magnetic field as compared to the field free case. Both show initially an increasing trend with increasing laser irradiance and after attaining their respective maxima a decreasing trend is observed with the further increase of irradiance. The magnetic confinement validity is confirmed by analytically evaluating thermal beta (ß t), directional beta (ß d), confinement radius (R b), and diffusion time (t d) for LPP of the Mg alloy. To correlate the LPP parameters of the Mg alloy with surface modifications a field emission scanning electron microscope (FE-SEM) analysis is performed. It was revealed that structures like laser-induced periodic surface structures (LIPSSs), agglomerates, islands, large sized bumps, along with channels and multiple ablative layers are observed. Distinct and well-defined surface structuring is observed in the presence of TMF as compared to the field free case. It is concluded that by applying an external magnetic field during laser irradiation, controlled material surface structuring is possible for fabrication of nanogratings and field emitters where spatial uniformity is critically important.
RESUMO
Lahore (Pakistan), being an industrial city, has high emission of aerosols that affects and contaminates the air quality. Therefore, the abatement/inactivation of aerosols is necessary to restrict their infectious activities. In this project, ionic wind isolated from dielectric barrier discharge plasma (DBD plasma) has been utilized to abate the aerosols trapped in the Surgical Mask and KN95 Respirator. To infer the chemical and elemental detection of ambient aerosols, FTIR and LIBS have been employed. "From the results, it is noteworthy that abatement/removal of aerosols has been successfully carried out by the ionic wind irradiation and highlights the potential of DBD plasma technology in removing the aerosols pollution."