Multimodal X-ray imaging of grain-level properties and performance in a polycrystalline solar cell.

The factors limiting the performance of alternative polycrystalline solar cells as compared with their single-crystal counterparts are not fully understood, but are thought to originate from structural and chemical heterogeneities at various length scales. Here, it is demonstrated that multimodal focused nanobeam X-ray microscopy can be used to reveal multiple aspects of the problem in a single measurement by mapping chemical makeup, lattice structure and charge collection efficiency simultaneously in a working solar cell. This approach was applied to micrometre-sized individual grains in a Cu(In,Ga)Se2 polycrystalline film packaged in a working device. It was found that, near grain boundaries, collection efficiency is increased, and that in these regions the lattice parameter of the material is expanded. These observations are discussed in terms of possible physical models and future experiments.

Tuning Lasing Emission toward Long Wavelengths in GaAs-(In,Al)GaAs Core-Multishell Nanowires.

Semiconductor nanowire (NW) lasers are attractive as integrated on-chip coherent light sources with strong potential for applications in optical communication and sensing. Realizing lasers from individual bulk-type NWs with emission tunable from the near-infrared to the telecommunications spectral region is, however, challenging and requires low-dimensional active gain regions with an adjustable band gap and quantum confinement. Here, we demonstrate lasing from GaAs-(InGaAs/AlGaAs) core-shell NWs with multiple InGaAs quantum wells (QW) and lasing wavelengths tunable from ∼0.8 to ∼1.1 µm. Our investigation emphasizes particularly the critical interplay between QW design, growth kinetics, and the control of InGaAs composition in the active region needed for effective tuning of the lasing wavelength. A low shell growth temperature and GaAs interlayers at the QW/barrier interfaces enable In molar fractions up to ∼25% without plastic strain relaxation or alloy intermixing in the QWs. Correlated scanning transmission electron microscopy, atom probe tomography, and confocal PL spectroscopy analyses illustrate the high sensitivity of the optically pumped lasing characteristics on microscopic properties, providing useful guidelines for other III-V-based NW laser systems.

Biodiversity in urban habitat patches.

We examined the biodiversity of urban habitats in Birmingham (England) using a combination of field surveys of plants and carabid beetles, genetic studies of four species of butterflies, modelling the anthropochorous nature of the floral communities and spatially explicit modelling of selected mammal species. The aim of the project was to: (i) understand the ecological characteristics of the biota of cities model, (ii) examine the effects of habitat fragment size and connectivity upon the ecological diversity and individual species distributions, (iii) predict biodiversity in cities, and (iv) analyse the extent to which the flora and fauna utilise the 'urban greenways' both as wildlife corridors and as habitats in their own right. The results suggest that cities provide habitats for rich and diverse range of plants and animals, which occur sometimes in unlikely recombinant communities. The studies on carabids and butterflies illustrated the relative importance of habitat quality on individual sites as opposed to site location within the conurbation. This suggests that dispersal for most of our urban species is not a limiting factor in population persistence, although elements of the woodland carabid fauna did appear to have some geographical structuring. Theoretical models suggested that dormice and water voles may depend on linear habitats for dispersal. The models also indicated that other groups, such as small and medium sized mammals, may use corridors, although field-based research did not provide any evidence to suggest that plants or invertebrates use urban greenways for dispersal. This finding indicates the importance of identifying a target species or group of species for urban greenways intended as dispersal routeways rather than as habitat in their own right. Their importance for most groups is rather that greenways provide a chain of different habitats permeating the urban environment. We suggest that planners can have a positive impact on urban biodiversity by slowing the pace of redevelopment and by not hurrying to tidy up and redevelop brownfield sites.

On the rationale and interpretation of the Farm Scale Evaluations of genetically modified herbicide-tolerant crops.

Farmland biodiversity and food webs were compared in conventional and genetically modified herbicide-tolerant (GMHT) crops of beet (Beta vulgaris L.), maize (Zea mays L.) and both spring and winter oilseed rape (Brassica napus L.). GMHT and conventional varieties were sown in a split-field experimental design, at 60-70 sites for each crop, spread over three starting years beginning in 2000. This paper provides a background to the study and the rationale for its design and interpretation. It shows how data on environment, field management and the biota are used to assess the current state of the ecosystem, to define the typical arable field and to devise criteria for selecting, sampling and auditing experimental sites in the Farm Scale Evaluations. The main functional and taxonomic groups in the habitat are ranked according to their likely sensitivity to GMHT cropping, and the most responsive target organisms are defined. The value of the seedbank as a baseline and as an indicator of historical trends is proposed. Evidence from experiments during the twentieth century is analysed to show that large changes in field management have affected sensitive groups in the biota by ca. 50% during a year or short run of years--a figure against which to assess any positive or negative effects of GMHT cropping. The analysis leads to a summary of factors that were, and were not, examined in the first 3 years of the study and points to where modelling can be used to extrapolate the effects to the landscape and the agricultural region.

Weeds in fields with contrasting conventional and genetically modified herbicide-tolerant crops. I. Effects on abundance and diversity.

We compared the seedbanks, seed rains, plant densities and biomasses of weeds under two contrasting systems of management in beet, maize and spring oilseed rape. Weed seedbank and plant density were measured at the same locations in two subsequent seasons. About 60 fields were sown with each crop. Each field was split, one half being sown with a conventional variety managed according to the farmer's normal practice, the other half being sown with a genetically modified herbicide-tolerant (GMHT) variety, with weeds controlled by a broad-spectrum herbicide. In beet and rape, plant densities shortly after sowing were higher in the GMHT treatment. Following weed control in conventional beet, plant densities were approximately one-fifth of those in GMHT beet. In both beet and rape, this effect was reversed after the first application of broad-spectrum herbicide, so that late-season plant densities were lower in the GMHT treatments. Biomass and seed rain in GMHT crops were between one-third and one-sixth of those in conventional treatments. The effects of differing weed-seed returns in these two crops persisted in the seedbank: densities following the GMHT treatment were about 20% lower than those following the conventional treatment. The effect of growing maize was quite different. Weed density was higher throughout the season in the GMHT treatment. Late-season biomass was 82% higher and seed rain was 87% higher than in the conventional treatment. The difference was not subsequently detectable in the seedbank because the total seed return was low after both treatments. In all three crops, weed diversity was little affected by the treatment, except for transient effects immediately following herbicide application.

Weeds in fields with contrasting conventional and genetically modified herbicide-tolerant crops. II. Effects on individual species.

We compared the effects of the management of genetically modified herbicide-tolerant (GMHT) and conventional beet, maize and spring oilseed rape on 12 weed species. We sampled the seedbank before and after cropping. During the season we counted plants and measured seed rain and biomass. Ratios of densities were used to calculate emergence, survival, reproduction and seedbank change. Treatments significantly affected the biomass of six species in beet, eight in maize and five in spring oilseed rape. The effects were generally consistent, with biomass lower in GMHT beet and spring oilseed rape and higher in GMHT maize. With few exceptions, emergence was higher in GMHT crops. Subsequent survival was significantly lowered for eight species in beet and six in spring oilseed rape in the GMHT treatments. It was increased for five species in maize and one in spring oilseed rape. Significant effects on seedbank change were found for four species. However, for many species in beet and spring oilseed rape (19 out of 24 cases), seed densities were lower in the seedbank after GMHT cropping. These differences compounded over time would result in large decreases in population densities of arable weeds. In maize, populations may increase.

Invertebrates and vegetation of field margins adjacent to crops subject to contrasting herbicide regimes in the Farm Scale Evaluations of genetically modified herbicide-tolerant crops.

The effects of management of genetically modified herbicide-tolerant (GMHT) crops on adjacent field margins were assessed for 59 maize, 66 beet and 67 spring oilseed rape sites. Fields were split into halves, one being sown with a GMHT crop and the other with the equivalent conventional non-GMHT crop. Margin vegetation was recorded in three components of the field margins. Most differences were in the tilled area, with fewer smaller effects mirroring them in the verge and boundary. In spring oilseed rape fields, the cover, flowering and seeding of plants were 25%, 44% and 39% lower, respectively, in the GMHT uncropped tilled margins. Similarly, for beet, flowering and seeding were 34% and 39% lower, respectively, in the GMHT margins. For maize, the effect was reversed, with plant cover and flowering 28% and 67% greater, respectively, in the GMHT half. Effects on butterflies mirrored these vegetation effects, with 24% fewer butterflies in margins of GMHT spring oilseed rape. The likely cause is the lower nectar supply in GMHT tilled margins and crop edges. Few large treatment differences were found for bees, gastropods or other invertebrates. Scorching of vegetation by herbicide-spray drift was on average 1.6% on verges beside conventional crops and 3.7% beside GMHT crops, the difference being significant for all three crops.