N-TiO2/gamma-Al2O3 granules: preparation, characterization and photocatalytic activity for the degradation of 2,4-dichlorophenol.

Nitrogen doping TiO2 and gamma-Al2O3 composite oxide granules (N-TiO2/gamma-Al2O3) were prepared by co-precipitation/oil-drop/calcination in gaseous NH3 process using titanium sulphate and aluminum nitrate as raw materials. After calcination at 550 degrees C in NH3 atmosphere, the composite granules showed anatase TiO2 and gamma-Al2O3 phases with the granularity of 0.5-1.0 mm. The anatase crystallite size of composite granules was range from 3.5-25 nm calculated from XRD result. The UV-Vis spectra and N 1s XPS spectra indicated that N atoms were incorporated into the TiO2 crystal lattice. The product granules could be used as a photocatalyst in moving bed reactor, and was demonstrated a higher visible-light photocatalytic activity for 2,4-dichlorophenol degradation compared with commercial P25 TiO2. When the mole ratio of TiO2 to Al2O3 equal to 1.0 showed the highest catalytic activity, the degradation percentage of 2,4-chlorophenol could be up to 92.5%, under 60 W fluorescent light irradiation for 9 hours. The high visible-light photocatalytic activity might be a synergetic effect of nitrogen doping and the form of binary metal oxide of TiO2 and gamma-Al2O3.

Degradation kinetics and mechanism of 3-Chlorobenzoic acid in anoxic water environment using graphene/TiO2 as photocatalyst.

Degradation kinetics and mechanism of 3-Chlorobenzoic acid (3-CBA) in anoxic water environment using graphene/TiO2 (GR/TiO2) as photocatalyst had been investigated. The effects of various parameters such as catalyst dosage, pH, initial concentration, catalyst reuse and dissolved oxygen (DO) on 3-CBA photocatalytic degradation kinetics were studied. The qualitative and quantitative analysis for degradation intermediate products and parent compound were studied by using HPLC, HPLC/MS/MS and IC technologies. The results show that the residual concentration of 3-CBA has a good linear relationship and its correlation coefficient R 2 are all greater than 0.985 by Langmuir-Hinshelwood (L-H) dynamic model under different photocatalytic degradation conditions. Some oxidative degradation products such as 3-chlorophenol, resorcinol, and hydroxyquinol are generated, and some reductive degradation products such as 3-chlorobenzaldehyde, 3-hydroxybenzaldehyde, 3-hydroxybenzyl alcohol, and cyclohexanediol are produced, and part of 3-CBA are mineralized to generate CO2 when DO is in the range of 0.5-1.0 mg/L; When DO is less than 0.28 mg/L, photocatalytic reduction mainly occurs. The results provide a theoretical basis for photocatalytic in situ remediation of pollutants in anoxic water environment.

[Study on the determination of trace composition and impurity elements in kaolin with ICP-MS].

The direct determination method of trace composition, Fe2O3, TiO2, MnO, K2O, Na2O, CaO and MgO, and impurity elements, Pb, Cr, Cd, Cu and As, in kaolin was studied by using inductive coupled plasma mass spectrometry (ICP-MS). After the samples were dissolved completely in HF-HNO3 at low temperature, silicon was volatilized in the form of SiF4 and separated from the solution. Then the solution was continually evaporated to dry to get the solid substance which was dissolved by the nitric acid (1+3). The internal elements 45Sc, 115In and 205Tl were added on line and the effect of matrix, interface and fluctuation of instrument was overcome effectively by using internal standard calibration method. By choosing the optional operating parameters and appropriate isotopes of element to be detected, the influence of mass spectrometry interference was conquered effectively. The effect of temperature in samples preparation on the determination of arsenic was tested. The recovery for spiking sample is in the range from 95.0% to 101.0% and the relative standard deviation is in the range from 1.1% to 2.01%. In order to check the accuracy of the method, the kaolin standard reference material GBW03122 was also analyzed, and the analytical values conformed to standard values. This method has the characteristics of being simple, rapid and accurate, and can be used in the testing of trace composition and impurity elements in kaolin and ceramic product.

Migration and Transformation Characteristics of Niclosamide in a Soil-Plant System.

The molluscicide niclosamide is found in most of the wetlands of China. The migration and transformation pathways, and degradation kinetics of niclosamide in the plant-soil system was analyzed by with the use of potting experiment. Experimental results showed that degradation of niclosamide in rhizosphere soil fit the first-order kinetics, and microorganisms played an important role in the degradation of niclosamide. It was found that niclosamide degrades to form a series of aromatic intermediate products both in soil and plants. Niclosamide could be absorbed from soil to plant by the root and then migrate to the stem. At an initial concentration of niclosamide of 2.11 mg·kg-1 in soil, the maximum residue of niclosamide in Artemisia somai aerial was 2.47 mg·kg-1 after 10 days of cultivation. This value is close to the pollution maximum residue limit (3 mg·kg-1) in rice, and niclosamide and its intermediates can remain about 43 days in plants. The experimental results demonstrate that the use of niclosamide in wetlands would have some risk in edible plants and was harmful for human health.