RESUMO
Liquid nitrogen (LN2) behavior on the surface of excited Yb(3+):YAG is investigated using fluorometry. From the time-resolved temperature variations and integrated fluorescence spectra intensity on this directly cooled Yb(3+):YAG surface, we observe a phase transition of LN2 from nucleate boiling to film boiling. As a result of this pool boiling, good beam quality should occur when the temperature and heat flux at an excited surface of Yb(3+):YAG are below 95 K and 15.8 W/cm2, respectively. That is, the LN2 should remain in a steady state of nucleate boiling to produce good beam quality using pool boiling.
RESUMO
We have studied the amplification characteristics of a cryogenically cooled Yb³âº:YAG total-reflection active-mirror (TRAM) ceramic laser including wavefront distortion, birefringence loss, small signal gain (SSG), and temperature rise for developing high-performance master oscillator power amplifier (MOPA) systems. A 0.6 mm thick Yb³âº:YAG ceramic sample was used, and maximum pump intensity ~10 kW/cm² was reached. The transmitted wavefront was measured by using a Shack-Hartmann wavefront sensor, and we evaluated the thermal lens focal length and Strehl ratio for different pump conditions. We have also observed a butterfly-like leakage profile of thermally induced birefringence loss at the maximum pump intensity. From SSG measurements, we obtained moderate laser gain of G=3 for one bounce with a near aberration-free wavefront. Gain calculations, which included also temperature dependence of the emission cross section and reabsorption of Yb³âº:YAG, were in good agreement with the experiments. These experimental results will be useful as benchmark data for numerical simulations of temperature distribution in TRAM and for designing multikilowatt-class high-performance MOPA systems.
RESUMO
The amplified spontaneous emission (ASE) and parasitic lasing (PL) effects in thin disk laser with an anti-ASE cap have been investigated in detail by measuring both time-resolved radiated intensity at longer axis of elliptical pump profile (dominant ASE direction) and small signal gain (SSG) in laser amplifier. A cryogenically-cooled total-reflection active-mirror laser consisting of 9.8 at.% doped, 0.6-mm thick Yb:YAG and un-doped YAG trapezoidal ceramics cap was used as a sample. The phased transitions from spontaneous emission (SE) to ASE and from ASE to PL have been unambiguously observed. For several pump beam diameters, the ASE gain parameter g(0)l(ASE) at ASE threshold was about 3, and the SSG coefficient was down to about 65% until PL started. To the best of our knowledge, this is the first quantitative characterization of the ASE/PL effects in the thin disk laser with an anti-ASE cap.
RESUMO
We have developed a laser Raman spectroscopy technique for assessing the working conditions of transformers by measuring dissolved C2H2 gas concentrations present in transformer oils. A frequency doubled Q-switched Nd:YAG laser (532 nm) was used as a laser source, and Raman signals at ~1972 cm(-1) originating from C2H2 gas dissolved in oil were detected. The results show that laser Raman spectroscopy is a useful alternative method for detecting transformer faults.
RESUMO
We propose a simple coherent beam combining technique for applications in high-power multichannel laser amplifier systems with tiled aperture design. Using a photodiode pair coupled with piezo-actuator mirrors, we demonstrated robust beam combining bandwidth (~1 KHz) and root mean-square deviation (~λ/25) for two beam channels. We estimate that the performance of this technique can be further enhanced in terms of operational bandwidth and phase locking accuracy. It is not limited by single beam power or channel number restrictions, does not require optical phase retrieval algorithms, or calibrations, and can be integrated into various master oscillator power amplifier architectures.
Assuntos
Interferometria/métodos , Fenômenos Ópticos , Algoritmos , Desenho de Equipamento , Interferometria/instrumentação , LasersRESUMO
We analyzed the output power characteristics of a cryogenically cooled Yb:YAG total-reflection active-mirror (TRAM) laser oscillator including the temperature dependence of the emission cross section and the reabsorption loss of the Yb:YAG TRAM. A CW multi-transverse mode oscillation of a 9.8 at.% doped 0.6 mm thick Yb:YAG ceramic TRAM was investigated for various pump spot sizes and compared with theoretical results. The Yb:YAG temperatures were inferred from the ratio between fluorescence intensities at 1022 nm and 1027 nm which varied significantly with temperature below 200 K. Output power calculations using evaluated temperatures were in good agreement with the experimental data measured between 77 and 200 K, and the output power suppression due to the temperature rise observed above ~140 K. To the best of our knowledge, this is the first evaluation of output power for a cryogenically cooled Yb:YAG TRAM laser.
RESUMO
We report on a novel amplifier configuration concept for a 10 kW laser system using a zig-zag optical path based on a cryogenic Yb:YAG Total-Reflection Active-Mirror (TRAM) laser. The laser material is a compact composite ceramic, in which three Yb:YAG TRAMs are combined in series to increase the output power. Output powers of up to 214 W with a slope efficiency of 63% have been demonstrated for CW operation, even at a quite low pump intensity of less than 170 W/cm2. Further scaling could achieve output powers of more than 10 kW.
Assuntos
Amplificadores Eletrônicos , Cerâmica/química , Lasers , Lentes , Temperatura Baixa , Desenho de Equipamento , Análise de Falha de EquipamentoRESUMO
A diode-pumped joule class in a 10 Hz output Nd:YLF ring amplifier has been developed. A phase conjugate plate was developed as a wavefront corrector for the residual wavefront distortion of an Nd:YLF rod. We have demonstrated a 0.46 J output of 10 ns pulse duration at 10 Hz repetition rate with 1.5 nJ of input energy. The effective gain of the ring amplifier system was 84.8 dB. To our knowledge, this is the highest magnification with joule-level output energy in a single-stage amplifier system that has ever been built. As a preamplifier system, this system contributed a demonstration of 21.3 J in a 10 Hz output diode-pumped Nd:glass zigzag slab laser system with a stimulated Brillouin scattering- phase conjugation mirror. We describe a robust and effective method of wavefront correction for high-energy laser systems.
Assuntos
Lasers Semicondutores , Nanotecnologia/instrumentação , Neodímio , Óptica e Fotônica/instrumentação , Desenho de Equipamento , Nanopartículas , Nanotecnologia/métodos , Óptica e Fotônica/métodosRESUMO
A diode-pumped picosecond 8-pass amplifier with a liquid-nitrogen-cooled Yb:YAG crystal has been developed. An average output power of 23.7 W with a near-diffraction-limited beam quality (M(2) < 1.2) was obtained at a pulse repetition rate of 80 kHz and a pulse duration of 11.7 ps. Average powers above 20 W were also obtained in the 30-80 kHz repetition rate range. The pulse energy reached almost 1 mJ at the 20 kHz repetition rate.
RESUMO
Low-density tin dioxide (SnO2) is required for radiating monochromatic extreme ultraviolet (EUV) light with low debris and high conversion efficiency from a laser. In this paper, tin dioxide nanoparticle hollow microcapsules were successfully fabricated by a layer-by-layer template technique. The obtained capsules have a rougher surface (30 nm in rms) compared to the freshly prepared polyelectrolyte capsules. Based on the X-ray diffraction (XRD) results, the tin dioxide nanoparticles well maintained their size after they were assembled on the capsules' surfaces. In order to remove the polymer template, a heat treatment was introduced, and after the heat treatment the capsule sizes shrank about 71% (the average size was from 4.9 to 3.5 mum), and the obtained capsules maintained their round shape after water evaporation. The narrowest bandwidth at the 13.5 nm emission in the EUV region was observed when the capsules were irradiated by a CO2 laser with an intensity of 2.9 x 10(10) W/cm (2).
Assuntos
Dióxido de Carbono/química , Compostos de Estanho/química , Estanho/química , Adsorção , Eletrólitos , Temperatura Alta , Lasers , Microscopia de Força Atômica , Microscopia Eletrônica de Varredura , Microesferas , Modelos Estatísticos , Nanopartículas/química , Propriedades de Superfície , Raios Ultravioleta , Difração de Raios XRESUMO
We report a high-average-power and high-pulse-energy diode-pumped Nd:glass laser amplifier system consisting of two thermally-edge-controlled zigzag slab amplifiers and a stimulated Brillouin scattering mirror. This phase-conjugated system produces an average power of 213 W at 10 Hz in a 8.9 ns pulse (2.4 GW peak power) with an optical-to-optical conversion efficiency of 11.7% and a near-diffraction-limited beam. To the best of our knowledge, this is the highest performance from a Nd:glass-based laser amplifier system ever built.
RESUMO
Opacity effects on extreme ultraviolet (EUV) emission from laser-produced tin (Sn) plasma have been experimentally investigated. An absorption spectrum of a uniform Sn plasma generated by thermal x rays has been measured in the EUV range (9-19 nm wavelength) for the first time. Experimental results indicate that control of the optical depth of the laser-produced Sn plasma is essential for obtaining high conversion to 13.5 nm-wavelength EUV radiation; 1.8% of the conversion efficiency was attained with the use of 2.2 ns laser pulses.
RESUMO
A newly designed jet-type, water-cooled heat sink (the funryu heat sink, meaning fountain flow in Japanese) yielded 255-W cw laser output at 808 nm from a 1-cm bar made from InGaAsP/InGaP quantum-well active layers with a 67% fill factor [70 quantum-well laser diode (LD) array along the 1-cm bar]. A funryu heat sink measuring 1.1 mm in thickness gave the LD 0.25 degrees C/W thermal resistance, one of the lowest values achieved with a 1-cm LD bar. Over a short period of operation, the device reached a maximum cw power of 255 W. To the best of our knowledge, this is the highest power ever achieved in 808-nm LD operation. In the future, the funryu heat sink may be capable of 80-W cw operation over an extended lifetime of several thousand hours.