Effect of roof colour on indoor temperature and human comfort levels, with implications for malaria control: a pilot study using experimental houses in rural Gambia.

BACKGROUND: In rural sub-Saharan Africa, thatch roofs are being replaced by metal roofs. Metal roofing, however, increases indoor temperatures above human comfort levels, and thus makes it more likely that residents will not use an insecticide-treated bed net (ITN) at night. Whether the colour of a metal roof affects indoor temperature and human comfort was assessed. METHODS: Two identical, experimental houses were constructed with metal roofs in rural Gambia. Roof types were: (1) original bare-metal, (2) painted with red oxide primer or (3) white gloss, to reflect solar radiation. Pairwise comparisons were run in six, five-night blocks during the malaria season 2018. Indoor climate was measured in each house and multivariate analysis used to compare indoor temperatures during the day and night. RESULTS: From 21.00 to 23.59 h, when most residents decide whether to use an ITN or not, the indoor temperature of a house with a bare metal roof was 31.5 °C (95% CI 31.2-31.8 °C), a red roof, 30.3 °C (95% CI 30.0-30.6) and a white roof, 29.8 °C (95% CI 29.4-30.1). During the same period, red-roofed houses were 1.23 °C cooler (95% CI 1.22-1.23) and white roofs 1.74 °C cooler (95% CI 1.70-1.79) than bare-metal roofed houses (p < 0.001). Similar results were found from 00.00 to 06.00 h. Maximum daily temperatures were 0.93 °C lower in a white-roofed house (95% CI 0.10-0.30, p < 0.001), but not a red roof (mean maximum temperature difference = 0.44 °C warmer, 95% CI 0.43-0.45, p = 0.081), compared with the bare-metal roofed houses. Human comfort analysis showed that from 21.00 to 23.59 h houses with white roofs (comfortable for 87% time) were more comfortable than bare-metal roofed houses (comfortable for 13% time; odds ratio = 43.7, 95% CI 27.5-69.5, p < 0.001). The cost of painting a metal roof white is approximately 31-68 USD. CONCLUSIONS: Houses with a white roof were consistently cooler and more comfortable than those with a bare metal roof. Painting the roofs of houses white is a cheap way of making a dwelling more comfortable for the occupants and could potentially increase bed net use in hot humid countries.

Measuring ventilation in different typologies of rural Gambian houses: a pilot experimental study.

BACKGROUND: African houses are frequently too hot and uncomfortable to use a bed net at night. Indoor thermal comfort is often evaluated by measuring temperature and humidity, ignoring ventilation. This study explored ways to measure ventilation in single-roomed rural Gambian houses during the malaria transmission season and evaluated building designs that could increase airflow at night and help keep the occupants comfortable. METHODS: Two identical mud-walled houses were constructed with a metal roof, three doors and closed eaves. Experiment 1 compared five methods for measuring ventilation in a building: (1) using a blower door, (2) increasing carbon dioxide (CO2) levels indoors using an artificial source of CO2 and then measuring the rate of gas decay, (3) using a similar approach with a natural source of CO2, (4) measuring the rise of CO2 when people enter a building and (5) using hot-wire anemometers. Experiment 2 used CO2 data loggers to compare ventilation in a reference metal-roofed house with closed eaves and badly-fitting doors with a similar house with (1) thatched roof and open eaves, (2) eaves tubes, (3) screened doors and (4) screened doors and windows. RESULTS: In experiment 1, CO2 data loggers placed indoors in two identical houses showed similar changes in airflow (p > 0.05) for all three methods recording either decreasing or increasing CO2. Blower doors were unable to measure airflow in houses with open eaves or screened windows and the anemometers broke down under field conditions. In experiment 2, open eaves in thatched houses, screened doors alone, and screened doors and windows increased indoor ventilation compared to the reference metal-roofed house with closed eaves and badly fitting doors (p < 0.05). Eaves tubes did not increase ventilation in comparison to the reference house. CONCLUSION: CO2 data loggers proved to be a simple and efficient method for measuring ventilation in rural houses at night. Ventilation of metal-roofed houses can be improved by adding two screened doors and windows on opposite walls. Improved ventilation will result in increased thermal comfort making it more likely that people will sleep under a bed net.

Impact of increased ventilation on indoor temperature and malaria mosquito density: an experimental study in The Gambia.

In sub-Saharan Africa, cooler houses would increase the coverage of insecticide-treated bednets, the primary malaria control tool. We examined whether improved ventilation, using windows screened with netting, cools houses at night and reduces malaria mosquito house entry in The Gambia. Identical houses were constructed, with badly fitting doors the only mosquito entry points. Two men slept in each house and mosquitoes captured using light traps. First, temperature and mosquito density were compared in four houses with 0, 1, 2 and 3 screened windows. Second, carbon dioxide (CO2), a major mosquito attractant, was measured in houses with (i) no windows, (ii) screened windows and (iii) screened windows and screened doors. Computational fluid dynamic modelling captured the spatial movement of CO2. Increasing ventilation made houses cooler, more comfortable and reduced malaria mosquito house entry; with three windows reducing mosquito densities by 95% (95%CI = 90-98%). Screened windows and doors reduced the indoor temperature by 0.6°C (95%CI = 0.5-0.7°C), indoor CO2 concentrations by 31% between 21.00 and 00.00 h and malaria mosquito entry by 76% (95%CI = 69-82%). Modelling shows screening reduces CO2 plumes from houses. Under our experimental conditions, cross-ventilation not only reduced indoor temperature, but reduced the density of house-entering malaria mosquitoes, by weakening CO2 plumes emanating from houses.

Recommendations for building out mosquito-transmitted diseases in sub-Saharan Africa: the DELIVER mnemonic.

In sub-Saharan Africa, most transmission of mosquito-transmitted diseases, such as malaria or dengue, occurs within or around houses. Preventing mosquito house entry and reducing mosquito production around the home would help reduce the transmission of these diseases. Based on recent research, we make key recommendations for reducing the threat of mosquito-transmitted diseases through changes to the built environment. The mnemonic, DELIVER, recommends the following best practices: (i) Doors should be screened, self-closing and without surrounding gaps; (ii) Eaves, the space between the wall and roof, should be closed or screened; (iii) houses should be Lifted above the ground; (iv) Insecticide-treated nets should be used when sleeping in houses at night; (v) houses should be Ventilated, with at least two large-screened windows to facilitate airflow; (vi) Environmental management should be conducted regularly inside and around the home; and (vii) Roofs should be solid, rather than thatch. DELIVER is a package of interventions to be used in combination for maximum impact. Simple changes to the built environment will reduce exposure to mosquito-transmitted diseases and help keep regions free from these diseases after elimination. This article is part of the theme issue 'Novel control strategies for mosquito-borne diseases'.

Status of insecticide resistance in Anopheles gambiae (s.l.) of The Gambia.

BACKGROUND: Vector control activities, namely long-lasting insecticidal nets (LLIN) and indoor residual spraying (IRS), have contributed significantly to the decreasing malaria burden observed in The Gambia since 2008. Nevertheless, insecticide resistance may threaten such success; it is important to regularly assess the susceptibility of local malaria vectors to available insecticides. METHODS: In the transmission seasons of 2016 and 2017, Anopheles gambiae (s.l.) larvae were sampled in or around the nine vector surveillance sentinel sites of the Gambia National Malaria Control Programme (GNMCP) and in a few additional sampling points. Using WHO susceptibility bioassays, female adult mosquitoes were exposed to insecticide-impregnated papers. Molecular identification of sibling species and insecticide resistance molecular markers was done on a subset of 2000 female mosquitoes. RESULTS: A total of 4666 wild-caught female adult mosquitoes were exposed to either permethrin (n = 665), deltamethrin (n = 744), DDT (n = 1021), bendiocarb (n = 990) or pirimiphos-methyl (n = 630) insecticide-impregnated papers and control papers (n = 616). Among the 2000 anophelines, 1511 (80.7%) were Anopheles arabiensis, 204 (10.9%) Anopheles coluzzii, 75 (4%) Anopheles gambiae (s.s.), and 83 (4.4%) An. gambiae (s.s.) and An. coluzzii hybrids. There was a significant variation in the composition and species distribution by regions and year, P = 0.009. Deltamethrin, permethrin and DDT resistance was found in An. arabiensis, especially in the coastal region, and was mediated by Vgsc-1014F/S mutations (odds ratio = 34, P = 0.014). There was suspected resistance to pirimiphos-methyl (actellic 300CS) in the North Bank Region although only one survivor had the Ace-1-119S mutation. CONCLUSIONS: As no confirmed resistance to bendiocarb and actellic 300CS was detected, the national malaria control programme can continue using these insecticides for IRS. Nevertheless, the detection of Ace-1 119S mutation warrants extensive monitoring. The source of insecticide pressure driving insecticide resistance to pyrethroids and DDT detected at the coastal region should be further investigated in order to properly manage the spread of resistance in The Gambia.

How house design affects malaria mosquito density, temperature, and relative humidity: an experimental study in rural Gambia.

INTRODUCTION: Unprecedented improvements in housing are occurring across much of rural sub-Saharan Africa, but the consequences of these changes on malaria transmission remain poorly explored. We examined how different typologies of rural housing affect mosquito house entry and indoor climate. METHODS: Five typologies of mud-block houses were constructed in rural Gambia: four were traditional designs with poorly fitted doors and one was a novel design with gable windows to improve ventilation. In each house, one male volunteer slept under a bednet and mosquitoes were collected indoors with a light trap. Typologies were rotated between houses weekly. Indoor conditions were monitored with data loggers and the perceived comfort of sleepers recorded with questionnaires. We used pyschrometric modelling to quantify the comfort of the indoor climate using the logger data. Primary measurements were mean number of Anopheles gambiae and mean temperature for each house typology. FINDINGS: In thatched-roofed houses, closing the eaves reduced A gambiae house entry by 94% (95% CI 89-97) but increased the temperature compared with thatched-roofed houses with open eaves. In houses with closed eaves, those with metal roofs had more A gambiae, were hotter (1·5°C hotter [95% CI 1·3-1·7]) between 2100h and 2300 h, and had 25% higher concentrations of carbon dioxide (211·1 ppm higher [117·8-304·6]) than those with thatched roofs. In metal-roofed houses with closed eaves, mosquito house entry was reduced by 96% (91-98) by well fitted screened doors. Improved ventilation of metal-roofed houses made them as cool as thatched houses with open eaves. Metal-roofed houses with closed eaves were considered more uncomfortable than thatched ones with closed eaves. In metal-roofed houses, ventilated houses were more comfortable than unventilated houses before midnight, when people retired to bed. INTERPRETATION: Closing the eaves reduced vector entry in thatched houses but increased entry in metal-roofed houses. Metal-roofed houses with closed eaves were, however, protected against malaria vectors by well fitted screened doors and were made comfortable by increasing ventilation. House designs that exclude mosquitoes and are comfortable to live in should be a priority in sub-Saharan Africa. FUNDING: Sir Halley Stewart Trust, Global Clinical Trials, and Global Challenges Research Fund.

New Prototype Screened Doors and Windows for Excluding Mosquitoes from Houses: A Pilot Study in Rural Gambia.

Despite compelling evidence that modern housing protects against malaria, houses in endemic areas are still commonly porous to mosquitoes. The protective efficacy of four prototype screened doors and two windows designs against mosquito house entry, their impact on indoor climate, as well as their use, durability and acceptability was assessed in a Gambian village. A baseline survey collected data on all the houses and discrete household units, each consisting of a front and back room, were selected and randomly allocated to the study arms. Each prototype self-closing screened door and window was installed in six and 12 units, respectively, with six unaltered units serving as controls. All prototype doors reduced the number of house-entering mosquitoes by 59-77% in comparison with the control houses. The indoor climate of houses with screened doors was similar to control houses. Seventy-nine percentage of door openings at night occurred from dusk to midnight, when malaria vectors begin entering houses. Ten weeks after installation the doors and windows were in good condition, although 38% of doors did not fully self-close and latch (snap shut). The new doors and windows were popular with residents. The prototype door with perforated concertinaed screening was the best performing door because it reduced mosquito entry, remained fully functional, and was preferred by the villagers. Screened doors and windows may be useful tools for reducing vector exposure and keeping areas malaria-free after elimination, when investment in routine vector control becomes difficult to maintain.