RESUMO
Single-crystalline ZnTe nanowires were prepared by a simple vapor transport and deposition method. Photodetectors of individual ZnTe nanowires were fabricated to study photoconductivity of the nanowires. It was observed the nanowire photodetectors show the highest visible-light photoconductive gains among all reported photodetectors based on 1D nanostructure semiconductors, including CdS, CdSe, ZnSe, etc. The high photosensitivity and relatively fast response speed are attributable to the high crystal quality of the ZnTe nanowires. These results reveal that such single-crystalline ZnTe nanowires are excellent candidates for optoelectronic applications.
Assuntos
Colorimetria/instrumentação , Nanotubos/química , Fotometria/instrumentação , Telúrio/química , Zinco/química , Cristalização , Desenho de Equipamento , Análise de Falha de Equipamento , Luz , Teste de Materiais , Nanotubos/ultraestruturaRESUMO
Coaxial nanocables with a single-crystalline zinc telluride (ZnTe) nanowire core and an amorphous silicon oxide (SiO(x)) shell have been synthesized via a simple one-step chemical vapor deposition (CVD) method on gold-decorated silicon substrates. The single-crystal ZnTe nanowire core is in zinc-blende structure along the [111] direction, while the uniform SiO(x) shell fully covers the core with no observable pin-hole or crack. Formation mechanisms of the ZnTe-SiO(x) nanocables are discussed. The ZnTe nanowire core shows p-type electrical properties while the SiO(x) shell acts as an effective insulating layer. The ZnTe-SiO(x) nanocables may have potential applications in nanoscale devices, such as p-type FETs and nanosensors.
RESUMO
Selenium nanowires with a diameter of about 70 nm and a growth direction along [001] were fabricated via a facile solution method. Photoconductive properties of Se wires were systematically characterized via photodetectors made of single Se nanowire. The photodetectors exhibited a high light on-off current ratio (Ilight/ Idark) of 450, and a fast light response speed of millisecond rise/fall time with excellent stability and reproducibility. It was also observed that the response time strongly depend on the intensity of the illumination light: the rise time and fall time for a typical photodetector is 0.68/1.85, 0.53/1.70, 0.54/1.65, 0.51/1.59, and 0.49/1.58 ms for light intensity of 0.18, 0.26, 0.43, 0.96, and 1.89 mW/cm2, respectively, and the relationship between the light intensity and the photocurrent can be fitted by using a simple power law. The diameters of the nanowire were found to have a significant influence on the response speed with smaller Se nanowires showing higher response speed. Finally, the mechanisms of photoconduction and factors affecting the performance of the photodetectors were elucidated.
RESUMO
Well-aligned ZnO nanowire (NW) arrays with durable and reproducible p-type conductivity were synthesized on alpha-sapphire substrates by using N2O as a dopant source via vapor-liquid-solid growth. The nitrogen-doped ZnO NWs are single-crystalline and grown predominantly along the [110] direction, in contrast to the [001] direction of undoped ZnO NWs. Electrical transport measurements reveal that the nondoped ZnO NWs exhibit n-type conductivity, whereas the nitrogen-doped ZnO NWs show compensated highly resistive n-type and finally p-type conductivity upon increasing N2O ratio in the reaction atmosphere. The electrical properties of p-type ZnO NWs are stable and reproducible with a hole concentration of (1-2) x 10(18) cm(-3) and a field-effect mobility of 10-17 cm2 V(-2) s(-1). Surface adsorptions have a significant effect on the transport properties of NWs. Temperature-dependent PL spectra of N-doped ZnO NWs show acceptor-bound-exciton emission, which corroborates the p-type conductivity. The realization of p-type ZnO NWs with durable and controlled transport properties is important for fabrication of nanoscale electronic and optoelectronic devices.
RESUMO
The photoconductive characteristics of CdS single nanoribbons were investigated. The device characteristics, including spectral response, light intensity response, and time response, were studied systematically. It is found that CdS nanoribbon has the response speed substantively faster than those ever reported for conventional film and bulk CdS materials and the size of nanoribbons has a significant influence on the response speed with smaller CdS nanoribbons showing higher response speed. The high photosensitivity and high photoresponse speed are attributable to the large surface-to-volume ratio and high single-crystal quality of CdS nanoribbons and the reduction of recombination barrier in nanostructures. Measurements in a different atmosphere demonstrate that the absorption of ambient gas (mainly oxygen) can significantly change the photosensitivity of CdS nanoribbons through trapping electrons from the nanoribbons.