Role of Carboxyl and Amine Termination on a Boron-Doped Diamond Solution Gate Field Effect Transistor (SGFET) for pH Sensing.

In this paper, we report on the effect of carboxyl- and amine terminations on a boron-doped diamond surface (BDD) in relation to pH sensitivity. Carboxyl termination was achieved by anodization oxidation in Carmody buffer solution (pH 7). The carboxyl-terminated diamond surface was exposed to nitrogen radicals to generate an amine-terminated surface. The pH sensitivity of the carboxyl- and amine-terminated surfaces was measured from pH 2 to pH 12. The pH sensitivities of the carboxyl-terminated surface at low and high pH are 45 and 3 mV/pH, respectively. The pH sensitivity after amine termination is significantly higher—the pH sensitivities at low and high pH are 65 and 24 mV/pH, respectively. We find that the negatively-charged surface properties of the carboxyl-terminated surface due to ionization of ⁻COOH causes very low pH detection in the high pH region (pH 7⁻12). In the case of the amine-terminated surface, the surface properties are interchangeable in both acidic and basic solutions; therefore, we observed pH detection at both low and high pH regions. The results presented here may provide molecular-level understanding of surface properties with charged ions in pH solutions. The understanding of these surface terminations on BDD substrate may be useful to design diamond-based biosensors.

Spin-State Control of Shallow Single NV Centers in Hydrogen-Terminated Diamond.

The ability to control the charge and spin states of nitrogen-vacancy (NV) centers near the diamond surface is of pivotal importance for quantum applications. Hydrogen-terminated diamond is promising for long spin coherence times and ease of controlling the charge states due to the low density of surface defects. However, it has so far been challenging to create negatively charged single NV centers with controllable spin states beneath a hydrogen-terminated surface because atmospheric adsorbates that act as acceptors induce surface holes. In this study, we optically detected the magnetic resonance of shallow single NV centers in hydrogen-terminated diamond through precise control of the nitrogen implantation fluence. Furthermore, we found that the probability of detecting the resonance was enhanced by reducing the surface acceptor density through passivation of the hydrogen-terminated surface with hexagonal boron nitride without air exposure. This control method opens up new opportunities for using NV centers in quantum applications.

Single-crystalline boron-doped diamond superconducting quantum interference devices with regrowth-induced step edge structure.

Superconducting quantum interference devices (SQUIDs) are currently used as magnetic flux detectors with ultra-high sensitivity for various applications such as medical diagnostics and magnetic material microstructure analysis. Single-crystalline superconducting boron-doped diamond is an excellent candidate for fabricating high-performance SQUIDs because of its robustness and high transition temperature, critical current density, and critical field. Here, we propose a fabrication process for a single-crystalline boron-doped diamond Josephson junction with regrowth-induced step edge structure and demonstrate the first operation of a single-crystalline boron-doped diamond SQUID above 2 K. We demonstrate that the step angle is a significant parameter for forming the Josephson junction and that the step angle can be controlled by adjusting the microwave plasma-enhanced chemical vapour deposition conditions of the regrowth layer. The fabricated junction exhibits superconductor-weak superconductor-superconductor-type behaviour without hysteresis and a high critical current density of 5800 A/cm2.

Ionic-liquid-gating setup for stable measurements and reduced electronic inhomogeneity at low temperatures.

The ionic-liquid-gating technique can be applied to the search for novel physical phenomena at low temperatures because of its wide controllability of the charge carrier density. Ionic-liquid-gated field-effect transistors are often fragile upon cooling, however, because of the large difference between the thermal expansion coefficients of frozen ionic liquids and solid target materials. In this paper, we provide a practical technique for setting up ionic-liquid-gated field-effect transistors for low-temperature measurements. It allows stable measurements and reduces the electronic inhomogeneity by reducing the shear strain generated in frozen ionic liquid.

Vertical-type two-dimensional hole gas diamond metal oxide semiconductor field-effect transistors.

Power semiconductor devices require low on-resistivity and high breakdown voltages simultaneously. Vertical-type metal-oxide-semiconductor field-effect transistors (MOSFETs) meet these requirements, but have been incompleteness in diamond. Here we show vertical-type p-channel diamond MOSFETs with trench structures and drain current densities equivalent to those of n-channel wide bandgap devices for complementary inverters. We use two-dimensional hole gases induced by atomic layer deposited Al2O3 for the channel and drift layers, irrespective of their crystal orientations. The source and gate are on the planar surface, the drift layer is mainly on the sidewall and the drain is the p+ substrate. The maximum drain current density exceeds 200 mA mm-1 at a 12 µm source-drain distance. On/off ratios of over eight orders of magnitude are demonstrated and the drain current reaches the lower measurement limit in the off-state at room temperature using a nitrogen-doped n-type blocking layer formed using ion implantation and epitaxial growth.