Laser Cooling of a Micromechanical Membrane to the Quantum Backaction Limit.

The radiation pressure of light can act to damp and cool the vibrational motion of a mechanical resonator, but even if the light field has no thermal component, shot noise still sets a limit on the minimum phonon occupation. In optomechanical sideband cooling in a cavity, the finite off-resonant Stokes scattering defined by the cavity linewidth combined with shot noise fluctuations dictates a quantum backaction limit, analogous to the Doppler limit of atomic laser cooling. In our work, we sideband cool a micromechanical membrane resonator to the quantum backaction limit. Monitoring the optical sidebands allows us to directly observe the mechanical object come to thermal equilibrium with the optical bath. This level of optomechanical coupling that overwhelms the intrinsic thermal decoherence was not reached in previous ground-state cooling demonstrations.

Effect of light assisted collisions on matter wave coherence in superradiant Bose-Einstein condensates.

We investigate experimentally the effects of light assisted collisions on the coherence between momentum states in Bose-Einstein condensates. The onset of superradiant Rayleigh scattering serves as a sensitive monitor for matter-wave coherence. A subtle interplay of binary and collective effects leads to a profound asymmetry between the two sides of the atomic resonance and provides far bigger coherence loss rates for a condensate bathed in blue detuned light than previously estimated. We present a simplified quantitative model containing the essential physics to explain our experimental data and point at a new experimental route to study strongly coupled light matter systems.

Feasibility of a nitrogen-recombination soft-x-ray laser using capillary discharge Z pinch.

Capillary discharge Z pinches have been shown to be efficient drivers for x-ray lasers (XRLs). In this work we examine the possibility of realizing a H_{alpha} nitrogen recombination laser ( 3-->2 transition) at lambda=13.4nm , using a capillary discharge Z pinch. A pulsed power generator with 60kA peak current and 70ns quarter period have been used to generate Z -pinch plasma in a 90-mm -long and 5-mm -diameter capillary. The plasma conditions were evaluated experimentally, using a filtered x-ray diode detector and time-integrated spectroscopy. The conditions required for the XRL were analytically estimated based on simple steady-state rate equations and then compared to experimental results. We demonstrated above 10% N7+ abundance at pinch time, while at least 50% is required. Then, in the expansion phase, the plasma is cooled in a time less than 5ns to temperatures below 60eV , as needed for the recombination laser. These results suggest that the required conditions for nitrogen-recombination lasing could be achieved in a capillary discharge Z pinch, but a higher-power driver might be needed.

Reconfigurable re-entrant cavity for wireless coupling to an electro-optomechanical device.

An electro-optomechanical device capable of microwave-to-optics conversion has recently been demonstrated, with the vision of enabling optical networks of superconducting qubits. Here we present an improved converter design that uses a three-dimensional microwave cavity for coupling between the microwave transmission line and an integrated LC resonator on the converter chip. The new design simplifies the optical assembly and decouples it from the microwave part of the setup. Experimental demonstrations show that the modular device assembly allows us to flexibly tune the microwave coupling to the converter chip while maintaining small loss. We also find that electromechanical experiments are not impacted by the additional microwave cavity. Our design is compatible with a high-finesse optical cavity and will improve optical performance.