Enhanced interference-pattern visibility using multislit optical superposition method for imaging-type two-dimensional Fourier spectroscopy.

A solution is found for the problem of phase cancellation between adjacent bright points in wavefront-division phase-shift interferometry. To this end, a design is proposed that optimizes the visibility of the interference pattern from multiple slits. The method is explained in terms of Fraunhofer diffraction and convolution imaging. Optical simulations verify the technique. The final design can be calculated using a simple equation.

Identification of black microplastics using long-wavelength infrared hyperspectral imaging with imaging-type two-dimensional Fourier spectroscopy.

Despite recent progress in focal plane array Fourier transform infrared spectroscopy (FPA-FT-IR) for automatic microplastic (MP) discrimination, the analysis time is still too long (e.g., 9 h for a sample with a diameter of 47 mm) and the equipment is expensive. As a solution, a hyperspectral camera restricted to the near-infrared or short-wavelength infrared band could be applied. However, with these bands, the minimum discriminable size is only about 100 µm, and discrimination among darkly colored plastics is difficult. The long-wavelength infrared (LWIR) band is reportedly effective for discrimination among darkly colored plastics. In this study, we constructed a palm-sized LWIR hyperspectral camera (105 mm × 90 mm × 50 mm, 1.25 kg) for imaging-type two-dimensional Fourier spectroscopy. Our system used a general-purpose, inexpensive, and compact microbolometer for the LWIR band. This system could record the absorbance of black MPs (polystyrene, polyethylene, and polypropylene) in a 3.8 mm × 3.0 mm area in 36 s, which was less than 1/6th of the time required for FPA-FT-IR. Additionally, our system could obtain spectra for a 12 µm × 12 µm area. Because our device is cheaper and more compact than a FPA-FT-IR, it will be easier to take out in the field or on a research vessel.

Parametric standing wave generation of a shallow reflection plane in a nonrigid sample for use in a noninvasive blood glucose monitor.

When monitoring a moist sample using mid-infrared spectroscopy, its thickness must be <100 µm to avoid light absorption from the water. Therefore, we propose an ultrasonic-assisted mid-infrared spectroscopic imaging method that can generate a reflection plane at a depth of 100 µm from the surface of the sample by creating an ultrasonic standing wave. A frequency of 10 MHz is required to obtain an optical path length of 100 µm in biological samples. However, because biological samples generally have high compressibility, attenuation of ultrasonic waves at this frequency is significant. We use agar as a biological phantom and observe that a reflection plane is generated inside by ultrasonic standing waves using optical coherence tomography. It is found that when the sample is vibrated with an 800-kHz ultrasonic wave, a reflection plane is generated at a depth shallower than the theoretically predicted value. We believe that the reflection plane is generated by parametric standing waves, which are based on parametric effect. We detect the waveform distortion using an acoustic emission sensor and confirm the higher harmonics that generate the observed reflection plane using a fast Fourier transform.

Ultrasonic standing wave preparation of a liquid cell for glucose measurements in urine by midinfrared spectroscopy and potential application to smart toilets.

Smart toilets could be used to monitor different components of urine in daily life for early detection of lifestyle-related diseases and prompt provision of treatment. For analysis of biological samples such as urine by midinfrared spectroscopy, thin-film samples like liquid cells are needed because of the strong absorption of midinfrared light by water. Conventional liquid cells or fixed cells are prepared based on the liquid membrane method and solution technique, but these are not quantitative and are difficult to set up and clean. We generated an ultrasonic standing wave reflection plane in a sample and produced an ultrasonic liquid cell. In this cell, the thickness of the optical path length was adjustable, as in the conventional method. The reflection plane could be generated at an arbitrary depth and internal reflected light could be detected by changing the frequency of the ultrasonic wave. We could generate refractive index boundaries using the density difference created by the ultrasonic standing wave. Creation of the reflection plane in the sample was confirmed by optical coherence tomography. Using the proposed method and midinfrared spectroscopy, we discriminated between normal urine samples spiked with glucose at different concentrations and obtained a high correlation coefficient.

Synergistic extraction equilibrium of gallium(III) with di(2-ethylhexyl)phosphoric acid and 8-quinolinol derivatives into supercritical carbon dioxide.

The synergistic effect of five 8-quinolinol derivatives (HQs) on the extraction of gallium(III) with di(2-ethylhexyl)-phosphoric acid (D2EHPA or HA) from weak nitric acid into supercritical carbon dioxide (SC-CO(2)) was investigated. 8-Quinolinol (Hq), 5-ethoxymethyl-8-quinolinol (HO(2)q), 5-hexyloxymethyl-8-quinolinol (HO(6)q), 5-(2,2,2-trifluoroethoxymethyl)-8-quinolinol (HFO(2)q), and 5-chloro-8-quinolinol (5-Cl-Hq) were used as synergists. Synergism was observed for all of the HQs. The synergistic effect increased in the following order: Hq < HO(2)q < HFO(2)q < 5-Cl-Hq ≍ HO(6)q. The extent of synergism can be related to both the distribution constant and the acid dissociation constant of the HQ. The synergistic extraction equilibrium of gallium(III) with D2EHPA and 5-Cl-Hq into SC-CO(2) was investigated; the results suggest that the composition of the extracted complex is as GaA(2)Q·HA. The synergistic extraction mechanism was the same for both SC-CO(2) and n-heptane. The synergistic extraction equilibrium constants in both cases were calculated based on the experimental results.