RESUMO
The CH4 storage by adsorption on activated carbons for natural gas handling has gained interest due to the appearance of lightweight materials with large surface areas and pore volumes. Consequently, kinetic parameters estimation of the adsorptive process can play a crucial role in understanding and scaling up the system. Concerning its versatility, banana peel (BP) is a biomass with potential for obtaining different products, such as biochar, a solid residue from the biomass' thermal decomposition of difficult disposal, where through an activation process, the material porous features are taken advantage to application as adsorbent of gaseous substances. This research reported data for the CH4 adsorption kinetic modeling by biochar from BP pyrolysis. The activated biochar textural characterization showed particles with fine mesoporous structure (pore diameter ranging between 29.39 and 55.62 Å). Adsorption kinetic analysis indicated that a modified pseudo-first-order model was the most suitable to represent the experimental data, with equilibrium adsorption of 28 mg g-1 for the samples activated with 20.0% vol wt.-1 of H3PO4 and pyrolysis at 500 °C. The equilibrium constant was consistent with the Freundlich isotherm model, suggesting a physisorption mechanism, and led to a non-ideal, reversible, and not limited to monolayer CH4 adsorption.
Assuntos
Carvão Vegetal , Metano , Metano/química , Adsorção , Carvão Vegetal/química , Cinética , Biomassa , Musa/químicaRESUMO
In this work, the adsorption of nickel ions from a real effluent from a metal-mechanic industry was investigated in a fixed-bed column using biochar. Biochar was prepared from winemaking residues originating from the Beifiur® composting process. The use of wine industry residues as precursor materials for biochar production is established in biomass residue valorization using the existing logistics and the lowest possible number of manipulations and pre-treatments. The results found in the work showed that the optimal conditions for nickel adsorption in fixed-bed columns were bed height (Z) of 7 cm, initial nickel concentration (C0) of 1.5 mg L-1, and flow rate (Q) of 18 mL min-1. In this condition, the maximum adsorption capacity of the column was 0.452 mg g-1, the mass transfer zone (Zm) was 3.3 cm, the treated effluent volume (Veff) was 9.72 L, and the nickel removal (R) was 92.71%. The Yoon-Nelson and BDST dynamic models were suitable to represent the breakthrough curves of nickel adsorption. Finally, the fixed-bed column adsorption using biochar from winemaking residues proved to be a promising alternative for nickel removal from real industrial effluents.
Assuntos
Poluentes Químicos da Água , Purificação da Água , Níquel/química , Purificação da Água/métodos , Adsorção , Carvão Vegetal/química , Poluentes Químicos da Água/análiseRESUMO
Eversa® Transform 2.0 lipase used as biocatalyst to biodiesel (fatty acid methyl esters - FAME) synthesis has been the target of interesting studies due to its thermostability and cost-effectiveness. In these researches, data about reaction conditions that result in satisfactory yields were investigated. Nevertheless, kinetic and thermodynamic parameters considering this enzyme are scarce. This paper presents an estimation of kinetic and thermodynamic parameters for the Eversa® Transform 2.0-mediated hydroesterification to FAME synthesis. Kinetic studies were performed for different methanol, water and lipase loads in distinct temperatures. Parameters adjusted by the thermodynamic model indicate that the hydrolysis is decisive in the overall hydroesterification reaction rate and the esterification reaction is endothermic (ΔHe = 38.98 kJ/mol). Formation of enzymatic complexes is favored by increasing the temperature, especially the enzyme-methanol inhibition complex. Statistical analysis showed that the model was not overparameterized, and the small confidence interval indicated good reliability of the estimated parameters.
Assuntos
Enzimas Imobilizadas , Metanol , Biocombustíveis , Enzimas Imobilizadas/metabolismo , Esterificação , Ésteres , Ácidos Graxos , Cinética , Lipase/metabolismo , Reprodutibilidade dos Testes , TermodinâmicaRESUMO
A real industrial effluent from the pre-treatment and painting processes was polished through adsorption using alternative biochar derived from grape pomace wastes. The biochar was produced in a pilot-scale plant from composted grape pomace. Biochar showed an equilibrium between acidic and basic groups on the surface. The presence of irregular cavities in the structure and mesopores was confirmed by analyzing N2 physisorption and SEM. Concerning the effluent, Ni and Zn were the main problematic elements. The adsorption isotherms and kinetics of Ni and Zn from the effluent using the biochar could be represented by the Henry, pseudo-first-order, and pseudo-second-order models, respectively. Adsorption equilibrium was reached within 60 min for Ni and Zn present in the real effluent. Besides, the adsorption process was endothermic, favorable, and spontaneous. These results demonstrate that Zn and Ni metals were successfully removed from the industrial effluent, presenting final concentration values within the limit of legislation for effluent disposal in agricultural soil.