Intradermal injection of Botulinum toxin type A alleviates infraorbital nerve constriction-induced thermal hyperalgesia in an operant assay.

Recent studies have shown that infraorbital nerve constriction (IoNC)-induced mechanical allodynia has been attenuated by administration of highly purified 150-kDa Botulinum neurotoxin type A (BoNT/A). Here, we extend these studies to determine whether BoNT/A could attenuate IoNC-induced symptoms of thermal hyperalgesia. Instead of testing head withdrawal thresholds, a thermal operant assay was used to evaluate cortical processing of sensory input following IoNC. In this assay, a fasted rat's desire to obtain a food reward (sweetened condensed milk) is coupled to its ability to tolerate facial contact with a warm (45 °C) thermode. Bilateral IoNC decreased the ratio of thermode contact duration/event, which is an indicative of thermal hyperalgesia. BoNT/A injection intradermally in the area of infraorbital nerve (IoN) innervation 7 days after IoNC resulted in decreased number of facial contacts and increased the ratio of contact duration/event (measured at 14 days after IoNC). The BoNT/A (2-200 pg) effects were dose dependent and statistically significant at 100 and 200 pg (P < 0·05). Complete reversal of thermal hyperalgesia symptoms was obtained with a 200-pg dose, without affecting sham rat behaviour. Off-site (neck) injection of BoNT/A did not relieve thermal hyperalgesia, while co-injection of BoNT/A with a neutralising antibody in the area of IoN innervation prevented relief of thermal hyperalgesia. Neither IoNC nor BoNT/A injection affected operant assay parameters with a 24 °C thermode, indicating selectivity of thermal hyperalgesia measurements. These results strongly suggest that intradermal injection of BoNT/A in the area of IoN innervation alleviates IoNC-induced thermal hyperalgesia in an operant assay.

Talbot interferometry for imaging two-dimensional electron density distribution over discharge plasma with higher sensitivity.

The basic properties of a Talbot interferometer implementing pinhole arrays were experimentally and numerically investigated for the improvement of measurement sensitivity of laser wavefront sensors utilized for electron density imaging over discharge plasmas. A numerical simulation using a plane wave decomposition method indicated that the pinhole arrays with a pitch of 300 µm and a pinhole diameter of 150 µm were most suitable for the measurement of the millimetre-scale discharge plasmas, in consideration of the spatial resolution and measurement accuracy. The plane wave decomposition simulation expected that the measurement sensitivity of the 8th-Talbot-length interferometer could be improved by a factor of 4 compared with the previously developed Shack-Hartmann type laser wavefront sensors, which was experimentally verified by the self-image behavior of the pinhole arrays. The Talbot interferometric system was successfully used for electron density imaging over the vacuum arcs generated between a 3-mm gap. The electron density image observed by the Talbot interferometers was in excellent agreement with that visualized by the previously developed Shack-Hartmann sensors. The practical notification for the pinhole array fabrication was also presented.