RESUMO
Limited flight duration is a considerable obstacle to the widespread application of micro aerial vehicles (MAVs)1-3, especially for ultralightweight MAVs weighing less than 10 g, which, in general, have a flight endurance of no more than 10 min (refs. 1,4). Sunlight power5-7 is a potential alternative to improve the endurance of ultralight MAVs, but owing to the restricted payload capacity of the vehicle and low lift-to-power efficiency of traditional propulsion systems, previous studies have not achieved untethered sustained flight of MAVs fully powered by natural sunlight8,9. Here, to address these challenges, we introduce the CoulombFly, an electrostatic flyer consisting of an electrostatic-driven propulsion system with a high lift-to-power efficiency of 30.7 g W-1 and an ultralight kilovolt power system with a low power consumption of 0.568 W, to realize solar-powered sustained flight of an MAV under natural sunlight conditions (920 W m-2). The vehicle's total mass is only 4.21 g, within 1/600 of the existing lightest sunlight-powered aerial vehicle6.
RESUMO
Insects and animals in nature generally have powerful muscles to guarantee their complex motion, such as crawling, running, and jumping. It is challenging for insect-sized robots to achieve controlled crawling and jumping within the scale of millimeters and milligrams. This article proposes a novelty bionic muscle actuator, where an electrical pulse is applied to generate joule heat to expand the actuator's chamber. Under the restoring force of the spring element, the chamber contracts back to the initial state to finish a complete cycle. The actuator can obtain high-frequency vibration under the high-frequency electrical signal. We propose a microrobot based on the novelty actuator to achieve controlled crawling and jumping over the obstacle of the millimeter-sized robot. The robot is fabricated with two actuators as a crawling module and one actuator as a jumping module, with a mass of 52 mg, length of 9.3 mm, width of 9.1 mm, and height of 4 mm. The microrobot has a maximum crawling turning velocity of 0.73 rad/s, a maximum jump height of 42 mm (10.5 times body height), and a maximum jump velocity of 0.91 m/s. This study extends the potential for applying the novelty bionic-muscle actuator to the microrobot.
RESUMO
The ability to move backward is crucial for millimeter-scale microrobots to navigate dead-end tunnels that are too narrow to allow for turning maneuvers. In this study, we introduce a 15-mm-long legged microrobot, BHMbot-B, which is capable of rapid forward and backward locomotion through vibration mode transition control. By properly arranging the vibratory motions of the magnet, cantilever, and linkages, the pitching movement of the body and the vibration of the forelegs are in phase during the first-order vibration mode of the cantilever and in antiphase during the second-order mode, which induces the forward and backward movement of the microrobot. Owing to its outstanding load-bearing capacity, the BHMbot-B equipped with dual electromagnetic actuators, an onboard battery, and a control circuit, can execute complex running trajectories under wireless command. Its maximum untethered running speeds are evaluated as 18.0 BL/s (360 mm/s) in the forward direction and 16.9 BL/s (338 mm/s) in the backward direction.
RESUMO
Running speed degradation of insect-scale (less than 5 cm) legged microrobots after carrying payloads has become a bottleneck for microrobots to achieve high untethered locomotion performance. In this work, we present a 2-cm legged microrobot (BHMbot, BeiHang Microrobot) with ultrafast untethered running speeds, which is facilitated by the complementary combination of bouncing length and bouncing frequency in the microrobot's running gait. The untethered BHMbot (2-cm-long, 1760 mg) can achieve a running speed of 17.5 BL s-1 and a turning centripetal acceleration of 65.4 BL s-2 at a Cost of Transport of 303.7 and a power consumption of 1.77 W. By controlling its two front legs independently, the BHMbot demonstrates various locomotion trajectories including circles, rectangles, letters and irregular paths across obstacles through a wireless control module. Such advancements enable the BHMbot to carry out application attempts including sound signal detection, locomotion inside a turbofan engine and transportation via a quadrotor.