Ternary cubic phases containing ionic liquid.

The phase diagram of 1-butyl-3-methylimidazolium tetrafluoroborate (bmim-BF(4)) in aqueous solutions of oleyl polyoxyethylene (20) ether (C(18:1)E(20)) was determined at 25 degrees C by a combination of visual inspection and small-angle X-ray scattering (SAXS). The micellar cubic Im3m liquid crystalline phase found in the ternary system was investigated by means of SAXS and rheological techniques. The cubic samples show highly elastic gel-like properties indicated by their mechanical and discrete relaxation spectra. Moreover at a constant C(18:1)E(20)/bmim-BF(4) ratio, with decreasing water content the network strength increases. The internal structure apparently becomes more stable, as indicated by an increase in the storage and loss moduli and a decrease in the lattice parameter alpha and interfacial area of per surfactant a(S). Furthermore, investigations on the representative micellar Im3m cubic phases formed in a relatively hydrophobic ionic liquid bmim-PF(6) with C(18:1)E(20) and water ternary system (P(1)), a C(18:1)E(20)/water binary system (J(1)), and C(18:1)E(20)/water/bmim-BF(4) system (B(1)) were made in comparison. It can be clearly seen that appreciably different mechanical spectra and relaxation spectra are shown by the cubic phases investigated. B(1) exhibits a typical gel-like dynamic rheogram while P(1) exhibits fluid-like viscoelastic properties to some extent, and J(1) shows traits of the general Maxwell model. These differences are analyzed through SAXS data as the employment of ionic liquids and their different location in the cubic phases.

Microstructure and rheological properties of liquid crystallines formed in Brij 97/water/IPM system.

The phase diagram of Brij 97/water/IPM systems was determined at 25 degrees C. Rich liquid crystalline phases including Lalpha, H1, and cubic Fd3m phases were identified by means of small angle X-ray scattering (SAXS). Microstructure transitions of liquid crystals with changes in surfactant concentration and oil content are explained qualitatively by the surfactant packing parameter (vL/aSlc). Dynamic rheological results indicate that all three kinds of liquid crystals investigated show high elasticity. The lamellar, Lalpha, phases formed in Brij 97/water with two different oils, oleic acid and geraniol, were also studied in comparison with those of Brij 97/water/IPM systems. The strength of the network of lamellar phases formed in Brij 97/water/oleic acid and Brij 97/water/geraniol systems are appreciably stronger than for Brij 97/water/IPM systems, indicated by the smaller area of surfactant molecules at the interface and the higher moduli (G' and G'').

Molecular interaction in binary surfactant mixtures containing alkyl polyglycoside.

Surface tensions were measured for several binary mixtures of a multidegree polymerized alkyl polyglycoside, C12G1.46' with different types of surfactants in 0.1 M NaCl at 25 degrees C. Based on regular solution theory, using a dimensional crystal model and a phase separation model, the molecule exchange energy in mixed monolayer formation (epsilon) and mixed micellization (epsilon(m)) were determined. Surfactants used in the mixtures with C12G1.46 in this study are C12E3S (trioxyethylenated dodecyl sulfonate), C12TAC (dodecyl trimethylammonium chloride), BE-6 (hexaoxyethylenated trisiloxane surfactant), and TMN-6 (hexaoxyethylenated-2,6,8-trimethylnonanol). The mixtures show exchange energy in mixed monolayer formation (epsilon) and mixed micellization (epsilon(m)) ranging from -660 to -1410 J/mol, indicating a decrease in surface energy upon mixing. The decreases in surface energy are in the order C12G1.46/C12E3S > C12G1.46/C12TAC, C12G1.46/C12TAC > C12G2/C12TAC and C12G1.46/BE-6 > C12G1.46/TMN-6. The ability of the mixed monolayer formation relative to the mixed micelle formation of the same binary mixture, measured by the (epsilon-epsilon(m)) values, is in the order C12G1.46/BE-6 > C12G1.46/TMN-6 > C12G1.46/C12E3S-->0 > C12G1.46/C12TAC.

The surface potential of a spherical colloid particle: functional theoretical approach.

By using the iterative method in functional analysis, the potential of the electrical double layer of a spherical colloid particle, which is represented by the so-called Poisson-Boltzmann (PB) equation, has been solved analytically under general potential conditions. With the help of the diagram method in mathematics, the surface potential of the particle has been defined from the second iterative solution. The influence of the parameters included in the solutions on the surface potential has been studied. The results show that the surface potential of the particle increases as the temperature of the system, the aggregation number, and the concentration of ions increase, but decreases with an increase in the dielectric constant and the valence of the ions. The corresponding space charge density also has been illustrated in this work.

Spontaneous vesicle formation and vesicle-tubular microstructure transition in aqueous solution of a poly-tailed cationic and anionic surfactants mixture.

Spontaneous vesicle formation has been observed in aqueous mixtures of tri-(N-dodecyldimethylhydroxypropylammonium chloride) phosphate (PTA) and bis-(2-ethylhexyl) sulfosuccinate (Aerosol OT), which is supported by negative-staining TEM and dynamic light scattering. The range of vesicle formation in the PTA/AOT mixtures is wide and monodisperse vesicles are obtained. The vesicle diameter increases with the total surfactant concentration. Tubular microstructures, vesicle fusion, and vesicle-tubular microstructure transition have been also observed by negative-staining TEM. The vesicle formation mechanism is discussed from the viewpoint of molecular geometry, conformation, and the interaction between surfactant molecules.

TX-100/water/1-butyl-3-methylimidazolium hexafluorophosphate microemulsions.

Both ionic liquids and water are typical green solvents. In this work, the phase behavior of the ternary system consisting of ionic liquid 1-butyl-3-methylimidazolium hexafluorophosphate (bmimPF6), TX-100, and water was determined at 25.0 degrees C. The water-in-bmimPF6, bicontinuous, and bmimPF6-in-water microregions of the microemulsions were identified by cyclic voltammetry method using potassium ferrocyanide K4Fe(CN)6 as the electroactive probe. Dynamic light scattering (DLS) and the UV-vis method were used to characterize the microemulsions. It was demonstrated that the hydrodynamic diameter (Dh) of the bmimPF6-in-water microemulsions is nearly independent of the water content but increases with increasing bmimPF6 content due to the swelling of the micelles by the ionic liquid. The UV-vis further confirmed the existence of water domains in the water-in-bmimPF6 microemulsions, and the salt potassium ferricyanide K3Fe(CN)6 could be dissolved in the water domains.

Hexagonal liquid crystalline phases formed in ternary systems of Brij 97-water-ionic liquids.

Phase diagrams of two ionic liquids: hydrophobic 1-butyl-3-methylimidazolium hexafluorophosphate (bmim-PF(6)) and relatively hydrophilic 1-butyl-3-methylimidazolium tetrafluoroborate (bmim-BF(4)) in aqueous solutions of Brij 97 were determined at 25 degrees C. Two hexagonal liquid crystalline phases formed in bmim-PF(6)- and bmim-BF(4)-containing ternary systems were investigated by means of small-angle X-ray scattering (SAXS) and rheological techniques, with comparison of composition and temperature effects. From analysis of the SAXS data, bmim-PF(6) is dominantly penetrated between the oxyethylene chains of surfactant molecules, whereas bmim-BF(4) is mainly located in the water layer of hexagonal phases. The strength of the network of hexagonal phase formed in the Brij 97/water/bmim-BF(4) system is appreciably stronger than that of the Brij 97/water/bmim-PF(6) system, indicated by the smaller area of the surfactant molecule at the interface and the higher moduli (G', G' '). Temperature has a converse effect on the lattice parameters of the two hexagonal phases.

Preparation and characterization of inclusion complexes of beta-cyclodextrin with ionic liquid.

The solubilities of beta-cyclodextrin (beta-CD), ionic liquid (IL) 1-butyl-3-methylimidazolium hexafluorophosphate (bmimPF6), and their mixture in water were determined, and the conductivity of these aqueous solutions was measured. It was demonstrated that beta-CD and bmimPF6 could enhance the solubility of each other, and the solubility curves of each were linear with gradients of about 1. The conductivity decreased remarkably with increasing beta-CD concentration, and a discernible break in the conductivity curve could be observed when beta-CD and bmimPF6 were equimolar in the solution. The solubility and conductivity results indicated that inclusion complexes (ICs) of 1:1 stoichiometry were formed. The inclusion compounds were further characterized by using powder X-ray diffraction (XRD) analysis, 13C CP/MAS (cross-polarization magic-angle spinning) NMR and 1H NMR spectroscopy, and thermogravimetric analysis (TGA). The results showed that the ICs were a fine crystalline powder. The host-guest system exhibited a channel-type structure and each glucose unit of beta-CD was in a similar environment. The decomposition temperature of the ICs was lower than that of bmimPF6 and beta-CD individually.

Formation of water-in-CO(2) microemulsions with non-fluorous surfactant Ls-54 and solubilization of biomacromolecules.

The solubility of Ls-54 surfactant in supercritical CO(2) was determined. It was found that the surfactant was highly soluble in SC CO(2) and the water-in-CO(2) microemulsions could be formed, despite it being a non-fluorous and non-siloxane nonionic surfactant. The main reasons for the high solubility and formation of the microemulsions may be that the surfactant has four CO(2)-philic groups (propylene oxide) and five hydrophilic groups (ethylene oxide) and its molecular weight are relatively low. The results of this work provide useful information for designing CO(2)-soluble non-fluorous and non-siloxane surfactants. The phase behavior of the CO(2)/Ls-54/H(2)O system, solvatochromic probe study, and the UV spectrum of lysozyme proved the existence of water domains in the SC CO(2) microemulsions. The method of synchrotron radiation small-angle X-ray scattering was used to obtain the structural information on the Ls-54 based water-in-CO(2) reverse micelles. By using the Guinier plot (ln I(q) versus q (2)) on the data sets in a defined small q range (0.022-0.040 A(-1)), the radii of the reverse micelles were obtained at different pressures and molar ratio of water to surfactant, W(0), which were in the range of 20.4-25.2 A.