RESUMO
In response to the COVID-19 pandemic, air cleaning technologies were promoted as useful tools for disinfecting public spaces and combating airborne pathogen transmission. However, no standard method exists to assess the potentially harmful byproduct formation from air cleaners. Through a consensus standard development process, a draft standard test method to assess portable air cleaner performance was developed, and a suite of air cleaners employing seven different technologies was tested. The test method quantifies not only the removal efficiency of a challenge chemical suite and ultrafine particulate matter but also byproduct formation. Clean air delivery rates (CADRs) are used to quantify the chemical and particle removal efficiencies, and an emission rate framework is used to quantify the formation of formaldehyde, ozone, and other volatile organic compounds. We find that the tested photocatalytic oxidation and germicidal ultraviolet light (GUV) technologies produced the highest levels of aldehyde byproducts having emission rates of 202 and 243 µg h-1, respectively. Additionally, GUV using two different wavelengths, 222 and 254 nm, both produced ultrafine particulate matter.
Assuntos
COVID-19 , Compostos Orgânicos Voláteis , Compostos Orgânicos Voláteis/análise , Material Particulado/análise , Ozônio/análise , Formaldeído/análise , SARS-CoV-2 , Desinfecção , Poluentes Atmosféricos/análise , Raios Ultravioleta , HumanosRESUMO
Energy-efficient residential building standards require the use of mechanical ventilation systems that replace indoor air with outdoor air. Transient outdoor pollution events can be transported indoors via the mechanical ventilation system and other outdoor air entry pathways and impact indoor air chemistry. In the spring of 2022, we observed elevated levels of NOx (NO + NO2) that originated outdoors, entering the National Institute of Standards and Technology (NIST) Net-Zero Energy Residential Test Facility through the mechanical ventilation system. Using measurements of NOx, ozone (O3), and volatile organic compounds (VOCs), we modeled the effect of the outdoor-to-indoor ventilation of NOx pollution on the production of nitrate radical (NO3), a potentially important indoor oxidant. We evaluated how VOC oxidation chemistry was affected by NO3 during NOx pollution events compared to background conditions. We found that nitric oxide (NO) pollution introduced indoors titrated O3 and inhibited the modeled production of NO3. NO ventilated indoors also likely ceased most gas-phase VOC oxidation chemistry during plume events. Only through the artificial introduction of O3 to the ventilation duct during a NOx pollution event (i.e., when O3 and NO2 concentrations were high relative to typical conditions) were we able to measure NO3-initiated VOC oxidation products, indicating that NO3 was impacting VOC oxidation chemistry.
Assuntos
Poluentes Atmosféricos , Poluição do Ar em Ambientes Fechados , Ozônio , Compostos Orgânicos Voláteis , Óxido Nítrico , Compostos Orgânicos Voláteis/análise , Poluentes Atmosféricos/análise , Poluição do Ar em Ambientes Fechados/análise , Dióxido de Nitrogênio/análise , Ozônio/análise , Monitoramento AmbientalRESUMO
Measurements of photolysis quantum yields are challenging because of the difficulties in measuring the first-generation photodissociation products, interference from other products or contaminants, sufficient photon fluxes and/or low absorption cross sections of the photolyte to make detectable amounts of products, and quantification of the photon flux. In the case of acetone (and other atmospherically relevant ketones) the uncertainty in the photolysis quantum yield creates uncertainty in the calculated OH radical and acyl peroxy nitrate production in the atmosphere. We present a new method for determining photodissociation product quantum yields by measuring acyl peroxy radicals (RC(O)O2) produced in the photolysis of ketones in air using chemical ionization mass spectrometry (CIMS). We show good agreement of our CIMS method with previously published quantum yields of the acyl radical from photolysis of biacetyl and methyl ethyl ketone (MEK) at 254 nm. Additionally, we highlight the capabilities of this CIMS method through the measurement of photolysis branching ratios for MEK. We suggest future applications of CIMS (in the laboratory and field) to measure RC(O)O2 and associated photolysis processes.
RESUMO
Organic acids have primary and secondary sources in the atmosphere, impact ecosystem health, and are useful metrics for identifying gaps in organic oxidation chemistry through model-measurement comparisons. We photooxidized (OH oxidation) primary emissions from diesel and biodiesel fuel types under two engine loads in an oxidative flow reactor. formic, butyric, and propanoic acids, but not methacrylic acid, have primary and secondary sources. Emission factors for these gas-phase acids varied from 0.3-8.4 mg kg-1 fuel. Secondary chemistry enhanced these emissions by 1.1 (load) to 4.4 (idle) × after two OH-equivalent days. The relative enhancement in secondary organic acids in idle versus loaded conditions was due to increased precursor emissions, not faster reaction rates. Increased hydrocarbon emissions in idle conditions due to less complete combustion (associated with less oxidized gas-phase molecules) correlated to higher primary organic acid emissions. The lack of correlation between organic aerosol and organic acid concentrations downstream of the flow reactor indicates that the secondary products formed on different oxidation time scales and that despite being photochemical products, organic acids are poor tracers for secondary organic aerosol formation from diesel exhaust. Ignoring secondary chemistry from diesel exhaust would lead to underestimates of both organic aerosol and gas-phase organic acids.
Assuntos
Compostos Orgânicos/análise , Emissões de Veículos/análise , Aerossóis , Atmosfera , BiocombustíveisRESUMO
Diesel engines are important sources of fine particle pollution in urban environments, but their contribution to the atmospheric formation of secondary organic aerosol (SOA) is not well constrained. We investigated direct emissions of primary organic aerosol (POA) and photochemical production of SOA from a diesel engine using an oxidation flow reactor (OFR). In less than a day of simulated atmospheric aging, SOA production exceeded POA emissions by an order of magnitude or more. Efficient combustion at higher engine loads coupled to the removal of SOA precursors and particle emissions by aftertreatment systems reduced POA emission factors by an order of magnitude and SOA production factors by factors of 2-10. The only exception was that the retrofitted aftertreatment did not reduce SOA production at idle loads where exhaust temperatures were low enough to limit removal of SOA precursors in the oxidation catalyst. Use of biodiesel resulted in nearly identical POA and SOA compared to diesel. The effective SOA yield of diesel exhaust was similar to that of unburned diesel fuel. While OFRs can help study the multiday evolution, at low particle concentrations OFRs may not allow for complete gas/particle partitioning and bias the potential of precursors to form SOA.
Assuntos
Aerossóis , Emissões de Veículos , Biocombustíveis , Gasolina , OxirreduçãoRESUMO
Devices using 222 nm germicidal ultraviolet light (GUV222) have been marketed to reduce virus transmission indoors with low risk of occupant harm from direct UV exposure. GUV222 generates ozone, an indoor air pollutant and oxidant, under constrained laboratory conditions, but the chemistry byproducts of GUV222-generated ozone in real indoor spaces is uncharacterized. We deployed GUV222 in a public restroom, with an air change rate of 1 h-1 one weekend and 2 h-1 the next, to measure ozone formation and byproducts generated from ozone chemistry indoors. Ozone from GUV222 increased background concentrations by 5 ppb on average for both weekends and reacted rapidly (e.g., at rates of 3.7 h-1 for the first weekend and 2.0 h-1 for the second) with gas-phase precursors emitted by urinal screens and on surfaces. These ozone reactions generated volatile organic compound and aerosol byproducts (e.g., up to 2.6 µg m-3 of aerosol mass). We find that GUV222 is enhancing indoor chemistry by at least a factor of two for this restroom. The extent of this enhanced chemistry will likely be different for different indoor spaces and is dependent upon ventilation rates, species and concentrations of precursor VOCs, and surface reactivity. Informed by our measurements of ozone reactivity and background aerosol concentrations, we present a framework for predicting aerosol byproduct formation from GUV222 that can be extended to other indoor spaces. Further research is needed to understand how typical uses of GUV222 could impact air quality in chemically diverse indoor spaces and generate indoor air chemistry byproducts that can affect human health.
Assuntos
Poluição do Ar em Ambientes Fechados , Ozônio , Raios Ultravioleta , Ozônio/química , Ozônio/análise , Poluição do Ar em Ambientes Fechados/análise , Compostos Orgânicos Voláteis/análise , Poluentes Atmosféricos/análiseRESUMO
The Chemical Assessment of Surfaces and Air (CASA) study aimed to understand how chemicals transform in the indoor environment using perturbations (e.g., cooking, cleaning) or additions of indoor and outdoor pollutants in a well-controlled test house. Chemical additions ranged from individual compounds (e.g., gaseous ammonia or ozone) to more complex mixtures (e.g., a wildfire smoke proxy and a commercial pesticide). Physical perturbations included varying temperature, ventilation rates, and relative humidity. The objectives for CASA included understanding (i) how outdoor air pollution impacts indoor air chemistry, (ii) how wildfire smoke transports and transforms indoors, (iii) how gases and particles interact with building surfaces, and (iv) how indoor environmental conditions impact indoor chemistry. Further, the combined measurements under unperturbed and experimental conditions enable investigation of mitigation strategies following outdoor and indoor air pollution events. A comprehensive suite of instruments measured different chemical components in the gas, particle, and surface phases throughout the study. We provide an overview of the test house, instrumentation, experimental design, and initial observations - including the role of humidity in controlling the air concentrations of many semi-volatile organic compounds, the potential for ozone to generate indoor nitrogen pentoxide (N2O5), the differences in microbial composition between the test house and other occupied buildings, and the complexity of deposited particles and gases on different indoor surfaces.
RESUMO
Recent interest in commercial devices containing germicidal ultraviolet lamps with a peak emission wavelength at 222 nm (GUV222) has focused on mitigating virus transmission indoors while posing minimum risk to human tissue. However, 222 nm light can produce ozone (O3) in air. O3 is an undesirable component of indoor air because of health impacts from acute to chronic exposure and its ability to degrade indoor air quality through oxidation chemistry. In seven four-hour experiments we measured O3 produced from a single filtered GUV222 lamp in a 31.5 m3 stainless steel chamber. Using an emission model, we determined an O3 generation rate of 19.4 ppbv h-1 ± 0.3 ppbv h-1 (equivalent to 1.22 mg h-1 ± 0.02 mg h-1). We estimated the fluence rate from the lamp using two methods: (1) chemical actinometry using tetrachloroethylene (actinometry) and (2) geometric projection of the irradiance field from radial and angular distribution measurements of the GUV222 lamp fluence (irradiance). Using the estimated lamp fluence rates of 2.2 µW cm-2 (actinometry) and 3.2 µW cm-2 (irradiance) we predicted O3 production in our chamber within 20 % of the average measured mixing ratio. Future studies should evaluate the indoor air quality impacts of GUV222 technologies.
RESUMO
Wildfires are increasing in frequency, raising concerns that smoke can permeate indoor environments and expose people to chemical air contaminants. To study smoke transformations in indoor environments and evaluate mitigation strategies, we added smoke to a test house. Many volatile organic compounds (VOCs) persisted days following the smoke injection, providing a longer-term exposure pathway for humans. Two time scales control smoke VOC partitioning: a faster one (1.0 to 5.2 hours) that describes the time to reach equilibrium between adsorption and desorption processes and a slower one (4.8 to 21.2 hours) that describes the time for indoor ventilation to overtake adsorption-desorption equilibria in controlling the air concentration. These rates imply that vapor pressure controls partitioning behavior and that house ventilation plays a minor role in removing smoke VOCs. However, surface cleaning activities (vacuuming, mopping, and dusting) physically removed surface reservoirs and thus reduced indoor smoke VOC concentrations more effectively than portable air cleaners and more persistently than window opening.