High-resolution X-ray emission spectroscopy with transition-edge sensors: present performance and future potential.

X-ray emission spectroscopy (XES) is a powerful element-selective tool to analyze the oxidation states of atoms in complex compounds, determine their electronic configuration, and identify unknown compounds in challenging environments. Until now the low efficiency of wavelength-dispersive X-ray spectrometer technology has limited the use of XES, especially in combination with weaker laboratory X-ray sources. More efficient energy-dispersive detectors have either insufficient energy resolution because of the statistical limits described by Fano or too low counting rates to be of practical use. This paper updates an approach to high-resolution X-ray emission spectroscopy that uses a microcalorimeter detector array of superconducting transition-edge sensors (TESs). TES arrays are discussed and compared with conventional methods, and shown under which circumstances they are superior. It is also shown that a TES array can be integrated into a table-top time-resolved X-ray source and a soft X-ray synchrotron beamline to perform emission spectroscopy with good chemical sensitivity over a very wide range of energies.

Synthesis of nanocrystalline calcium phosphate in microemulsion--effect of nature of surfactants.

Nanosized calcium phosphate (CP) powders have been synthesized by an inverse microemulsion system using kerosene as the oil phase, a cationic surfactant Aliquat 336, a non-ionic surfactant Tween 20 and their mixture and aqueous solutions of calcium nitrate tetrahydrate and biammonium hydrogen phosphate as the water phase. It has been found that the nature of surfactants played an important role to regulate the size and morphologies of the calcium phosphate nanoparticles. The cationic surfactant Aliquat 336 has been found to regulate the nucleation and crystal growth. The synthesized powders have been comprehensively characterized using transmission electron microscopy (TEM), scanning electron microscopy (SEM), powder X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR). Our results show that the brushite (DCPD) is the major phase comprising the calcium phosphate nanoparticles. In mixed surfactants mediated system a morphological controlled highly crystalline particles have been synthesized. Further, the role of Aliquat 336 has been established and a plausible synthetic mechanism has been proposed.

Determination of duloxetine in human plasma by liquid chromatography with atmospheric pressure ionization-tandem mass spectrometry and its application to pharmacokinetic study.

A rapid, sensitive and accurate liquid chromatographic-tandem mass spectrometry (LC-MS-MS) method is described for the determination of duloxetine in human plasma. Duloxetine was extracted from plasma using methanol and separated on a C18 column. The mobile phase consisting of a mixture of acetonitrile and 5mM ammonium acetate (45:55, v/v, pH 3.5) was delivered at a flow rate of 0.3 ml/min. Atmospheric pressure ionization (API) source was operated in positive ion mode. Multiple reaction monitoring (MRM) mode using the transitions of m/z 298.1-->m/z 44.0 and m/z 376.2-->m/z 123.2 were used to quantify duloxetine and internal standard (I.S.), respectively. The linearity was obtained over the concentration range of 0.1-50.0 ng/ml and the lower limit of quantitation (LLOQ) was 0.1 ng/ml. This method was successfully applied to pharmacokinetic study of a duloxetine formulation product after oral administration to healthy human subjects.

Simultaneous determination of fixed dose combination of nebivolol and valsartan in human plasma by liquid chromatographic-tandem mass spectrometry and its application to pharmacokinetic study.

A rapid, sensitive and accurate liquid chromatographic-tandem mass spectrometry method is described for the simultaneous determination of nebivolol and valsartan in human plasma. Nebivolol and valsartan were extracted from plasma using acetonitrile and separated on a C18 column. The mobile phase consisting of a mixture of acetonitrile and 0.05 mM formic acid (50:50 v/v, pH 3.5) was delivered at a flow rate of 0.25 ml/min. Atmospheric pressure ionization (API) source was operated in both positive and negative ion mode for nebivolol and valsartan, respectively. Selected reaction monitoring mode (SRM) using the transitions of m/z 406.1-->m/z 150.9; m/z 434.2-->m/z 179.0 and m/z 409.4-->m/z 228.1 were used to quantify nebivolol, valsartan and internal standard (IS), respectively. The linearity was obtained over the concentration range of 0.01-50.0 ng/ml and 1.0-2000.0 ng/ml and the lower limits of quantitation were 0.01 ng/ml and 1.0 ng/ml for nebivolol and valsartan, respectively. This method was successfully applied to the pharmacokinetic study of fixed dose combination (FDC) of nebivolol and valsartan formulation product after an oral administration to healthy human subjects.

In-vitro and in-vivo correlation for two gliclazide extended-release tablets.

The aim of this study was to perform an in-vitro-in-vivo correlation (IVIVC) for two 60-mg gliclazide extended-release formulations (Fast and Slow release) given once a day and to compare their plasma concentrations over time. In-vitro release rate data were obtained for each formulation using the USP apparatus II, paddle stirrer at 50 and 100 rev min(-1) in 0.1 M HCl and pH 7.4 phosphate buffer. The similarity factor (f2) was used to analyse the dissolution data. Eighteen healthy subjects participated in the study, conducted according to a completely randomized, two-way crossover design. The formulations were compared using area under the plasma concentration-time curve, AUC(0-infinity), time to reach peak plasma concentration, Tmax, and peak plasma concentration Cmax, while correlation was determined between in-vitro release and in-vivo absorption. A linear correlation model was developed using percent absorbed data versus percent dissolved data from the two formulations. Predicted gliclazide concentrations were obtained by use of a curve fitting equation. Prediction errors were estimated for Cmax and area under the curve AUC(0-infinity) to determine the validity of the correlation. 0.1 M HCl at 50 rev min(-1) was found to be the most discriminating dissolution method. Linear regression analysis of the mean percentage of dose absorbed versus the mean percentage of in-vitro release resulted in a significant correlation (r2 > 0.98) for the two formulations. An average percent prediction error for Cmax was 4.15% for Fast release and 3.99% for Slow release formulation whereas for AUC(0-infinity) it was 6.36% and 4.66% for Fast release and Slow release formulation, respectively.

Comparison of three types of intervention to enhance placental redistribution in term newborns: randomized control trial.

OBJECTIVE: To compare the effect of combined delayed cord clamping and umbilical cord milking to either of them had done alone, on hematological parameters at 6 weeks of age in term neonates. STUDY DESIGN: It was a randomized controlled trial, conducted during January to December 2014. Three hundred eligible neonates were randomly allocated to three parallel groups. Primary outcome was hemoglobin and serum ferritin at 6 weeks of age. Data were analyzed using analysis of variance and Kruskal-Wallis test. RESULTS: Baseline characteristics and hemodynamic parameters were comparable in all the three groups. The median serum ferritin level at 6 weeks was significantly higher in the group receiving both delayed cord clamping and milking the cut cord group (295.49 (233.5 to 346.54) ng ml(-1)) as compared with the group that received only milking of the cut cord (184.55 (131.22 to 256.5) ng ml(-1)) or only delayed cord clamping (268.8 (189.4 to 315.44) ng ml(-1)). CONCLUSION: Delayed cord clamping with milking the cut cord improved iron stores at 6 weeks of age in term infants, then either of the two interventions alone.

Bioequivalence study of sildenafil citrate tablets in healthy human volunteers.

Newly developed sildenafil citrate (SC), a selective inhibitor of cyclic guanosine monophosphate (c-GMP) specific phosphodiesterase type 5 (PDE 5) in the corpus cavernosum is used for the oral treatment of erectile dysfunction. A convenient, sensitive and simple method for the determination of sildenafil in human plasma is presented. The analytical technique was based on reversed-phase high-performance liquid chromatography coupled with UV detector set at 295 nm. Rofecoxib was used as internal standard (I.S). Liquid-liquid extraction using diethyl ether was performed to recover sildenafil and rofecoxib. The retention time of I.S and sildenafil were 5.5 minutes and 7.2 minutes respectively. The method was validated over a linear range of 10 to 1000 ng/ml from plasma. Separate stability study showed that sildenafil is stable under conditions of analysis. The extraction efficiency from plasma varied from 79.69% to 81.13 %. The minimum quantifiable concentration was set at 10 ng/ml. (%o CV<12.5%). The method was used for Bioequivalence Study of Two Brands of Sildenafil citrate 50 mg tablets in healthy human volunteers. All pharmacokinetic parameter were calculated along with statistical evaluation.

Evaluation of bioequivalence of two formulations containing 100 milligrams of aceclofenac.

The bioequivalence of two oral formulations containing aceclofenac 100 mg was determined in 24 healthy Indian male volunteers. The study was designed as a single dose, fasting, two-period two-sequence crossover study with a washout period of 1 week. The content of aceclofenac in plasma was determined by a validated HPLC method with UV detection. The preparations were compared using the parameters area under the plasma concentration-time curve (AUC0-t), area under the plasma concentration-time curve from zero to infinity (AUC0-infinity), peak plasma concentration (Cmax), and time to reach peak plasma concentration (tmax). No statistically significant difference was observed between the logarithmic transformed AUC0-infinity and Cmax values of the two preparations. The 90% confidence interval for the ratio of the logarithmic transformed AUC0-t, AUC0-infinity, and Cmax were within the bioequivalence limit of 0.80-1.25.

High performance liquid chromatographic determination of cox-2 inhibitor rofecoxib in human plasma.

A convenient, sensitive and simple method for the determination of rofecoxib in human plasma is presented. The analytical technique is based on reversed phase high performance liquid chromatography coupled with UV detector (Knauer, Germany) set at 272 nm. The retention time of rofecoxib after recovery from plasma, was 8.9 minutes. The method has been validated over a linear range of 50-450 ng/ml from plasma. After validation the method was used to study the pharmacokinetic profile of rofecoxib in 6 healthy volunteers as per DCGI guidelines after administration of a single oral dose (50 mg). The extraction efficiency from plasma varied from 93.95-99.58%. The minimum quantifiable concentration was set at 50 ng/ml (% CV < 10%). The pharmacokinetic parameters were Cmax = 318.58 +/- 30.65 ng/ml at tmax = 2.66 +/- 0.25 hours, AUC0-t = 4007.88 +/- 438.32 ng hour/ml, AUC0-yen = 5454.66 +/- 822.29 ng hour/ml, Kel = 0.0433 +/- 0.0067/hour, and t1/2 = 16.36 +/- 2.89 hours.

A study to determine the pharmacokinetics of gatifloxacin following a single oral dose.

Gatifloxacin is a broad spectrum fluoroquinolone that offers enhanced Gram-positive activity and anaerobic coverage to other fluoroquinolones. The pharmacokinetic parameters (Cmax, AUCo-t, tmax) of this drug have been evaluated to compare the single dose (400mg) bioavailability of gatifloxacin with the reference formulation. High performance liquid chromatography (HPLC) coupled with U-V detector set at 290 nm has been used to determine plasma concentration of 12 human volunteers as per DCGI (Drug Controller General of India) guidelines. The method has been validated over a linear range of 0.25 to 8 microg/ml from plasma. The minimum quantifiable concentration has been set at 0.25 microg/ml (% CV < 10%). The pharmacokinetic parameters are: Cmax = 4.366 +/- 0.44 microg/ml at tmax = 1.83 +/- 0.44 hour, AUCO0-t = 25.26 +/- 2.91 microg hour/ml, AUCo-inf = 33.68 +/- 4.31 microg hour/ml, Kel = 0.094 +/- 0.024/hour and t1/2 = 8.0 +/- 1.92 hour.