RESUMO
An electrochemical couple of lithium and sulfur possesses the highest theoretical energy density (>2600 Wh/kg) at the material level. However, disappointingly, it is out of place in primary batteries due to its low accessible energy density at the cell level (≤500 Wh/kg) and poor storage performance. Herein, a low-density methyl tert-butyl ether was tailored for an ultralight electrolyte (0.837 g/mL) with a protective encapsulation solvation structure which reduced electrolyte weight (23.1%), increased the utilization of capacity (38.1%), and simultaneously forfended self-discharge. Furthermore, active fluorinated graphite partially replaced inactive carbon to construct a hybrid sulfur-based cathode to bring the potential energy density into full play. Our demonstrated pouch cell achieved an incredible energy density of 661 Wh/kg with a negligible self-discharge rate based on the above innovations. Our work is anticipated to provide a new direction to realize the practicality of lithium-sulfur primary batteries.
RESUMO
Single-crystalline Ni-rich cathodes with high capacity have drawn much attention for mitigating cycling and safety crisis of their polycrystalline analogues. However, planar gliding and intragranular cracking tend to occur in single crystals with cycling, which undermine cathode integrity and therefore cause capacity degradation. Herein, we intensively investigate the origin and evolution of the gliding phenomenon in single-crystalline Ni-rich cathodes. Discrete or continuous gliding forms are revealed with new surface exposure including the gliding plane (003) and reconstructed (-108) under surface energy drive. It is also demonstrated that the gliding process is the in-plane migration of transition metal ions, and reducing oxygen vacancies will increase the migration energy barrier by which gliding and microcracking can be restrained. The designed cathode with less oxygen deficiency exhibits outstanding cycling performance with an 80.8% capacity retention after 1000 cycles in pouch cells. Our findings provide an insight into the relationship between defect control and chemomechanical properties of single-crystalline Ni-rich cathodes.
RESUMO
Single-crystalline Ni-rich cathodes are promising candidates for the next-generation high-energy Li-ion batteries. However, they still suffer from poor rate capability and low specific capacity due to the severe kinetic hindrance at the nondilute state during Li+ intercalation. Herein, combining experiments with density functional theory (DFT) calculations, we demonstrate that this obstacle can be tackled by regulating the oxidation state of nickel via injecting high-valence foreign Ta5+ . The as-obtained single-crystalline LiNi0.8 Co0.1 Mn0.1 O2 delivers a high specific capacity (211.2â mAh g-1 at 0.1 C), high initial Coulombic efficiency (93.8 %), excellent rate capability (157â mAh g-1 at 4 C), and good durability (90.4 % after 100 cycles under 0.5 C). This work provides a strategy to mitigate the Li+ kinetic hindrance of the appealing single-crystalline Ni-rich cathodes and will inspire peers to conduct an intensive study.
RESUMO
Mn-based ZrCuSiAs-type pnictides ThMnPnN (Pn = P, As) containing PbO-type Th2N2 layers were synthesized. The crystal and magnetic structures are determined using X-ray and neutron powder diffraction. While neutron diffraction indicates a C-type antiferromagnetic state at 300 K, the temperature dependence of the magnetic susceptibility shows cusps at 36 and 52 K respectively for ThMnPN and ThMnAsN. The susceptibility cusps are ascribed to a spontaneous antiferromagnetic-to-antiferromagnetic transition for Mn2+ moments, which is observed for the first time in Mn-based ZrCuSiAs-type compounds. In addition, measurements of the resistivity and specific heat suggest an abnormal increase in the density of states at the Fermi energy. The result is discussed in terms of the internal chemical pressure effect.
RESUMO
The deposition of volatilized Na+ on the surface of the cathode during sintering results in the formation of surface residual alkali (NaOH/Na2 CO3 NaHCO3 ) in layered cathode materials, leading to serious interfacial reactions and performance degradation. This phenomenon is particularly evident in O3-NaNi0.4 Cu0.1 Mn0.4 Ti0.1 O2 (NCMT). In this study, a strategy is proposed to transform waste into treasure by converting residual alkali into a solid electrolyte. Mg(CH3 COO)2 and H3 PO4 are reacted with surface residual alkali to generate the solid electrolyte NaMgPO4 on the surface of NCMT, which can be labeled as NaMgPO4@NaNi0.4 Cu0.1 Mn0.4 Ti0.1 O2 -X (NMP@NCMT-X, where X indicates the different amounts of Mg2+ and PO4 3- ). NaMgPO4 acts as a special ionic conductivity channel on the surface to improve the kinetics of the electrode reactions, remarkably improving the rate capability of the modified cathode at a high current density in the half-cell. Additionally, NMP@NCMT-2 enables a reversible phase transition from the P3 to OP2 phase in the charge-discharge process above 4.2 V and achieves a high specific capacity of 157.3 mAh g-1 and outstanding capacity retention in the full cell. The strategy can effectively and reliably stabilize the interface and improve the performance of layered cathodes for Na-ion batteries (NIBs).
RESUMO
Overshadowing the superconducting dome in hole-doped cuprates, the pseudogap state is still one of the mysteries that no consensus can be achieved. It has been suggested that the rotational symmetry is broken in this state and may result in a nematic phase transition, whose temperature seems to coincide with the onset temperature of the pseudogap stateT∗around optimal doping level, raising the question whether the pseudogap results from the establishment of the nematic order. Here we report results of resistivity measurements under uniaxial pressure on several hole-doped cuprates, where the normalized slope of the elastoresistivityζcan be obtained as illustrated in iron-based superconductors. The temperature dependence ofζalong particular lattice axis exhibits kink feature atTkand shows Curie-Weiss-like behavior above it, which may suggest a spontaneous nematic transition. WhileTkseems to be the same asT∗around the optimal doping and in the overdoped region, they become very different in underdoped La2-xSrxCuO4. Our results suggest that the nematic order, if indeed existing, is an electronic phase within the pseudogap state.
RESUMO
The coexistence of large conductivity and robust ferroelectricity is promising for high-performance ferroelectric devices based on polarization-controllable highly efficient carrier transport. Distinct from traditional perovskite ferroelectrics, Bi2 WO6 with a layered structure shows a great potential to preserve its ferroelectricity under substantial electron doping. Herein, by artificial design of photosensitive heterostructures with desired band alignment, three orders of magnitude enhancement of the short-circuit photocurrent is achieved in Bi2 WO6 /SrTiO3 at room temperature. The microscopic mechanism of this large photocurrent originates from separated transport of electrons and holes in [WO4 ]-2 and [Bi2 O2 ]+2 layers respectively with a large in-plane conductivity, which is understood by a combination of ab initio calculations and spectroscopic measurements. The layered electronic structure and appropriately designed band alignment in this layered ferroelectric heterostructure provide an opportunity to achieve high-performance and nonvolatile switchable electronic devices.