Tailored Langmuir-Schaefer Deposition of Few-Layer MoS2 Nanosheet Films for Electronic Applications.

Few-layer MoS2 films stay at the forefront of current research of two-dimensional materials. At present, continuous MoS2 films are prepared by chemical vapor deposition (CVD) techniques. Herein, we present a cost-effective fabrication of the large-area spatially uniform films of few-layer MoS2 flakes using a modified Langmuir-Schaefer technique. The compression of the liquid-phase exfoliated MoS2 flakes on the water subphase was used to form a continuous layer, which was subsequently transferred onto a submerged substrate by removing the subphase. After vacuum annealing, the electrical sheet resistance dropped to a level of 10 kΩ/sq, being highly competitive with that of CVD-deposited MoS2 nanosheet films. In addition, a consistent fabrication protocol of the large-area conductive MoS2 films was established. The morphology and electrical properties predetermine these films to advanced detecting, sensing, and catalytic applications. A large number of experimental techniques were used to characterize the exfoliated few-layer MoS2 flakes and to elucidate the formation of the few-layer MoS2 Langmuir film.

Plume Dynamics of Laser-Produced Swine Muscle Tissue Plasma.

We report on the plume dynamics of the plasma induced by laser ablation of a swine skeletal muscle tissue sample in different vacuum conditions. Pulses from a transversely excited atmospheric CO2 laser were focused onto a target sample and the induced plasma was allowed to expand in different air pressures. The expansion features were studied using fast photography of the overall visible emission by using a gated intensified charged coupled device. Free expansion and plume splitting were observed at different pressure levels. The expansion of the plasma plume front was analyzed using various expansion models and the velocity of the plume front was estimated. The effect of the number of accumulated laser shots on the crater volume at different ambient air pressures and an elemental analysis of the sample were performed using scanning electron microscopy coupled with energy dispersive X-ray spectroscopy (EDX) analysis. The surface morphology of the irradiated surface showed that increasing the pressure of the ambient gas decreased the ablated mass, or in other words it reduced significantly the laser-target coupling.