Selection of a density separation solution to study microplastics in tropical riverine sediment.

Microplastics (MPs) are small (< 5 mm) plastic particles that are widely found in marine, freshwater, terrestrial and atmospheric environments. Due to their prevalence and persistence, MPs are considered an emerging contaminant of environmental concern. The separation and quantitation of MPs from freshwater sediments is a challenging and critical issue. It is necessary to identify the fate and sources of MPs in the environment, minimise their release and adverse effects. Compared to marine sediments, standardised methods for extracting and estimating the amount of MPs in freshwater sediments are relatively limited. The present study focuses on MP recovery efficiency of four commonly used salt solutions (NaCl, NaI, CaCl2 and ZnCl2) for isolating MPs during the density separation step from freshwater sediment. Known combinations of artificial MP particles (PS, PE, PVC, PET, PP and HDPE) were spiked into standard river sediment. Extraction using NaI, ZnCl2 and NaCl solutions resulted in higher recovery rates from 37 to 97% compared to the CaCl2 solution (28-83%) and varied between polymer types. Low-density MPs (PE, HDPE, PP and PS) were more effectively recovered (> 87%) than the denser polymers (PET and PVC: 37 to 88.8%) using NaCl, NaI and ZnCl2 solutions. However, the effective flotation of ZnCl2 and NaI solutions is relatively expensive and unsafe to the environment, especially in the context of developing countries. Therefore, considering the efficiency, cost and environmental criteria, NaCl solution was selected. The protocol was then tested by extracting MPs from nine riverine sediment samples from the Red River Delta. Sediments collected from urban rivers were highly polluted by MPs (26,000 MPs items·kg-1 DW) compared to sediments located downstream. Using a NaCl solution was found to be effective in this case study and might also be used in long-term and large-scale MP monitoring programmes in Vietnam.

Microplastics in sediments from urban and suburban rivers: Influence of sediment properties.

Although sediments are considered to be a major sink for microplastics (MP), there is still a relative lack of knowledge on the factors that influence the occurrence and abundance of MP in riverine sediments. The present study investigated the occurrence and distribution of MP in riverine sediments collected at twelve sites representative of different populated and urbanized rivers (To Lich, Nhue and Day Rivers) located in the Red River Delta (RRD, Vietnam, during dry and rainy seasons. MP concentrations ranged from 1600 items kg-1 dw to 94,300 items kg-1dw. Fiber shape dominated and MP were made of polypropylene (PP) and polyethylene (PE) predominantly. An absence of seasonal effect was observed for both fragments and fibers for each rivers. Decreasing MP concentrations trend was evidenced from the To Lich River, to the Nhue River and to the Day River, coupled with a decreasing fiber length and an increasing fragment area in the surface sediment from upstream to downstream. Content of organic matter was correlated to MP concentrations suggesting that, high levels of organic matter could be MP hotspots in urban rivers. Also, high population density as well as in highly residential areas are related to higher MP concentrations in sediments. Finally, a MP high ecological risk (RI: 866 to 4711) was calculated in the RDD.

Microplastics in Asian freshwater ecosystems: Current knowledge and perspectives.

Plastic pollution in freshwater ecosystems, including microplastics (MPs) smaller than 5 mm, has become an emerging global concern. Asia is considered a "hot spot" for plastic pollution due to rapid economic and demographic growth, together with rapid urbanization. Here, we provide an overview of the current knowledge on MP abundance, sources, fate, and transfer in Asian freshwater ecosystems based on publications from January 2014 to May 2021. MP contamination in freshwater compartments, including water, sediment, and biota, was found to vary strongly. In water, it ranged from 0.004 items m-3 in a moderately urbanized region to more than 500,000 items m-3 in a dumping river in a highly populated watershed. In the sediment, MP abundance ranged from 1 to more than 30,000 items kg-1 dry weight. Polyethylene (PE) and polypropylene (PP) were predominant in both water and sediment compartments. MP was detected in biota samples from all the studied species, but their abundance depended on the locations and species studied. Overall, MP characteristics (form, size, color, and polymer type) depended on sources and natural constraints (mainly hydrodynamics). This study also revealed that MP in Asian freshwater ecosystems mainly originated from domestic wastewater/runoff, followed by industrial emissions, fisheries and aquaculture wastewater. Plastic waste is not efficiently recycled or incinerated in Asia, leading to MP transfer and accumulation in the aquatic environment, and, more importantly, to ingestion by low to high trophic level organisms. This work highlights several knowledge gaps to guides future research to improve MP pollution management for the sustainable development of highly populated regions such as Asia.