Comprehensive Chemical Characterization of the Aerosol Emissions of a Vaping Product Based on a New Technology.

Around 10 million people in the United States and 3 million people in the United Kingdom are estimated to use vaping category products. There are some estimates that there will be 75-80 million vapers worldwide by 2020. Most of these products are based on coil-and-wick technology. Because the heating and aerosol formation are separate processes, the system can lead to dry-wicking and elevated emission of carbonyls if designed and/or manufactured poorly. Low-nicotine and low-power coil-and-wick devices have also been linked to increased exposure to formaldehyde due to compensatory behavior by users. We characterized the emissions of a vaping product which uses a fabric-free stainless-steel mesh distiller plate technology that heats and aerosolizes the e-liquid in a single process. The plate has a microporous structure for capillary-induced liquid transformation (wicking) and aerosolization that is optimized to avoid fluid starvation and overheating and improved control. Compared with emissions previously reported for a coil-and-wick nicotine vaping product (e-cigarette), most classes of harmful and potentially harmful constituents (HPHCs) from this vaping product were below the level of detection or quantification. For those that were quantifiable, this vaping product generally had lower levels of emissions than the e-cigarette, including carbonyls. Formaldehyde and methyl glyoxal levels did not differ significantly between vaping products. In this system, the single mode of liquid transfer and vapor formation permits high aerosol mass delivery but further reduces emissions of HPHCs that may be present in conventional e-cigarette aerosol, by lessening the risk of thermal breakdown of the aerosol-generating solvent mixture.

Accurate measurement of main aerosol constituents from heated tobacco products (HTPs): Implications for a fundamentally different aerosol.

ISO 4387 Standard determines the main aerosol constituents (total particulate matter, water, nicotine, and nicotine-free-dry-particulate matter, referred to as "tar") in cigarette mainstream smoke (ISO, 2000). Heated Tobacco Products (also called Tobacco Heating Products or Heat-not-Burn Products) are designed to form aerosol by heating tobacco rather than burning like in combustible cigarettes. In this study we have evaluated the suitability of ISO 4387 Standard to be adapted for quantifying main aerosol constituents for HTP aerosol. HTP emissions have much higher levels of water and humectants (e.g., glycerol) in dynamic equilibria between gaseous and particulate phases. Several modifications to ISO 4387 Standard on aerosol collection were tested to improve the accuracy and reliability of aerosol capturing, with minimal deviation to the standard method. The proposed modifications are readily adoptable by laboratories already practicing the Standard for cigarette smoke analyses. Taking collectively with other available aerosol chemistry and biological results on HTPs in the literature, they show a fundamentally different aerosol in HTPs and call for category-specific product standards and terminology.

Assessment of tobacco heating product THP1.0. Part 2: Product design, operation and thermophysical characterisation.

A novel tobacco heating product, THP1.0, that heats tobacco below 245 °C is described. It was designed to eliminate tobacco combustion, while heating tobacco to release nicotine, tobacco volatiles and glycerol to form its aerosol. The stewardship assessment approach behind the THP 1.0 design was based on established toxicological principles. Thermophysical studies were conducted to examine the extent of tobacco thermal conversion during operation. Thermogravimetric analysis of the tobacco material revealed the major thermal behaviour in air and nitrogen up to 900 °C. This, combined with the heating temperature profiling of the heater and tobacco rod, verified that the tobacco was not subject to combustion. The levels of tobacco combustion markers (CO, CO2, NO and NOx) in the aerosol of THP1.0 were significantly lower than the levels if there were any significant pyrolysis or combustion. Quantification of other tobacco thermal decomposition and evaporative transfer markers showed that these levels were, on average, reduced by more than 90% in THP1.0 aerosol as compared with cigarette smoke. The physical integrity of the tobacco consumable rod showed no ashing. Taken together, these data establish that the aerosol generated by THP1.0 is produced mainly by evaporation and distillation, and not by combustion or pyrolysis.

Unraveling the cell-type dependent radiosensitizing effects of gold through the development of a multifunctional gold nanoparticle.

The radiosensitizing efficacy of gold is well established, however, there remain several significant barriers to the successful clinical translation of nano-sized gold particles (AuNPs). These barriers include: retaining stability in relevant biological sera, demonstrating effectiveness at clinically relevant AuNP concentrations and identifying the biological context where significant benefit is most likely to be achieved. Herein we have developed a AuNP preparation, stress-tested to provide effective protection from salt and serum mediated agglomeration. Furthermore, the core AuNP is co-functionalized with two biologically derived peptides designed to enhance endocytosis and promote endosomal escape, thus maximizing intracellular AuNP surface area. In summary, these investigations demonstrate restored AuNP internalization using the co-functionalized preparation that generated significant radiosensitization, in both in vitro and in vivo models, at clinically viable treatment concentrations. Furthermore, we have identified an underpinning biological mechanism in the inherent radical scavenging capacity that could be used to predict radiosensitizing efficacy.

Eukaryotic genome size databases.

Three independent databases of eukaryotic genome size information have been launched or re-released in updated form since 2005: the Plant DNA C-values Database (www.kew.org/genomesize/homepage.html), the Animal Genome Size Database (www.genomesize.com) and the Fungal Genome Size Database (www.zbi.ee/fungal-genomesize/). In total, these databases provide freely accessible genome size data for >10,000 species of eukaryotes assembled from more than 50 years' worth of literature. Such data are of significant importance to the genomics and broader scientific community as fundamental features of genome structure, for genomics-based comparative biodiversity studies, and as direct estimators of the cost of complete sequencing programs.

Towards photon radiotherapy treatment planning with high Z nanoparticle radiosensitisation agents: the Relative Biological Effective Dose (RBED) framework.

A novel treatment planning framework, the Relative Biological Effective Dose (RBED), for high Z nanoparticle (NP)-enhanced photon radiotherapy is developed and tested in silico for the medical exemplar of neoadjuvant (preoperative) breast cancer MV photon radiotherapy. Two different treatment scenarios, conventional and high Z NP enhanced, were explored with a custom Geant4 application that was developed to emulate the administration of a single 2 Gy fraction as part of a 50 Gy radiotherapy treatment plan. It was illustrated that there was less than a 1% difference in the dose deposition throughout the standard and high Z NP-doped adult female phantom. Application of the RBED framework found that the extent of possible biological response with high Z NP doping was great than expected via the dose deposition alone. It is anticipated that this framework will assist the scientific community in future high Z NP-enhanced in-silico, pre-clinical and clinical trials.

A hierarchical Bayesian approach to calibrating the linear-quadratic model from clonogenic survival assay data.

We propose a Bayesian hierarchical model applicable to the calibration of the linear-quadratic model of radiation dose-response. Experimental data used in model calibration were taken from a clonogenic survival assay conducted on human breast cancer cells (MDA-MB-231) across a range of radiation doses (0-6Gy). Employing Markov-chain Monte Carlo methods, we calibrated the proposed Bayesian hierarchical model, computed posterior distributions for the model parameters and survival fraction dose-response probability densities. Key contributions include the proposal of a model that incorporates multiple sources of inter- and intra-experiment variability commonly neglected in the standard frequentist approach and its subsequent application to in vitro experimental data.

A comparison of gold nanoparticle surface co-functionalization approaches using Polyethylene Glycol (PEG) and the effect on stability, non-specific protein adsorption and internalization.

To create clinically useful gold nanoparticle (AuNP) based cancer therapeutics it is necessary to co-functionalize the AuNP surface with a range of moieties; e.g. Polyethylene Glycol (PEG), peptides and drugs. AuNPs can be functionalized by creating either a mixed monolayer by attaching all the moieties directly to the surface using thiol chemistry, or by binding groups to the surface by means of a bifunctional polyethylene glycol (PEG) linker. The linker methodology has the potential to enhance bioavailability and the amount of functional agent that can be attached. While there is a large body of published work using both surface arrangements independently, the impact of attachment methodology on stability, non-specific protein adsorption and cellular uptake is not well understood, with no published studies directly comparing the two most frequently employed approaches. This paper compares the two methodologies by synthesizing and characterizing PEG and Receptor Mediated Endocytosis (RME) peptide co-functionalized AuNPs prepared using both the mixed monolayer and linker approaches. Successful attachment of both PEG and RME peptide using the two methods was confirmed using Dynamic Light Scattering, Fourier Transform Infrared Spectroscopy and gel electrophoresis. It was observed that while the 'as synthesized' citrate capped AuNPs agglomerated under physiological salt conditions, all the mixed monolayer and PEG linker capped samples remained stable at 1M NaCl, and were stable in PBS over extended periods. While it was noted that both functionalization methods inhibited non-specific protein attachment, the mixed monolayer samples did show some changes in gel electrophoresis migration profile after incubation with fetal calf serum. PEG renders the AuNP stable in-vivo however, studies with MDA-MB-231 and MCF 10A cell lines indicated that functionalization with PEG, blocks cellular uptake. It was observed that co-functionalization with RME peptide using both the mixed monolayer and PEG linker methods greatly enhanced cellular internalization compared to PEG capped AuNPs.

Preclinical evaluation of gold-DTDTPA nanoparticles as theranostic agents in prostate cancer radiotherapy.

AIM: Gold nanoparticles have attracted significant interest in cancer diagnosis and treatment. Herein, we evaluated the theranostic potential of dithiolated diethylenetriamine pentaacetic acid (DTDTPA) conjugated AuNPs (Au@DTDTPA) for CT-contrast enhancement and radiosensitization in prostate cancer. MATERIALS & METHODS: In vitro assays determined Au@DTDTPA uptake, cytotoxicity, radiosensitizing potential and DNA damage profiles. Human PC3 xenograft tumor models were used to determine CT enhancement and radiation modulating effects in vivo. RESULTS: Cells exposed to nanoparticles and radiation observed significant additional reduction in survival compared with radiation only. Au@DTDTPA produced a CT enhancement of 10% and a significant extension in tumor growth delay from 16.9 days to 38.3 compared with radiation only. CONCLUSION: This study demonstrates the potential of Au@DTDTPA to enhance CT-image contrast and simultaneously increases the radiosensitivity of prostate tumors.

Calcium/cadmium interactions at uptake surfaces in rainbow trout: waterborne versus dietary routes of exposure.

Juvenile rainbow trout (Oncorhynchus mykiss) were exposed to control, 3 microg/L waterborne Cd, or 500 mg/kg dietary Cd in combination with either a control (20 mg/g Ca2+ as CaCO3) or elevated (60 mg/g Ca2+) Ca2+ diet for 28 d. No mortality or growth effects were observed in response to either route of Cd exposure, although fish fed Ca2+-supplemented diets exhibited minor reductions in growth within the first few days of feeding. Waterborne and dietary Cd resulted in significant Cd accumulation in most tissues, with dietary uptake being far in excess of waterborne under the exposure conditions used. The order of Cd accumulation strongly reflected the exposure pathway, being gill and kidney > liver > gut > carcass (waterborne Cd); gut > kidney > liver > gill > carcass > bone (dietary Cd). On a whole-body basis, the net retention of Cd from the diet was < 1%, indicating that the gut wall forms an important protective barrier reducing Cd accumulation into internal tissues. Dietary Ca2+ supplementation reduced short-term whole-body uptake rates of waterborne Ca2+ and Cd by >50% and resulted in much lower chronic accumulation of Cd (via the water and diet) in target tissues. Results suggest that Ca2+ and Cd share common pathway(s)/transport mechanism(s) in the gill and gut and that increased gastrointestinal Ca2+ uptake likely caused downregulation of branchial and gastrointestinal Ca2+ and therefore Cd uptake pathways. Because nutrient metals other than Ca2+ may also influence Cd (and other metal) uptake, new regulatory approaches to metal toxicity (e.g., biotic ligand model) require understanding of the influence of dietary status on metal accumulation.

Gold nanoparticle surface functionalization: a necessary requirement in the development of novel nanotherapeutics.

With several gold nanoparticle-based therapies currently undergoing clinical trials, these treatments may soon be in the clinic as novel anticancer agents. Gold nanoparticles are the subject of a wide ranging international research effort with preclinical studies underway for multiple applications including photoablation, diagnostic imaging, radiosensitization and multifunctional drug-delivery vehicles. These applications require an increasingly complex level of surface modification in order to achieve efficacy and limit off-target toxicity. This review will discuss the main obstacles in relation to surface functionalization and the chemical approaches commonly utilized. Finally, we review a range of recent preclinical studies that aim to advance gold nanoparticle treatments toward the clinic.

A novel multidrug-resistance protein 2 gene mutation identifies a subgroup of patients with primary biliary cirrhosis and pruritus.

A single nucleotide polymorphism characterized by the substitution of valine for glutamate (V1188E) in exon 25 of the multidrug resistance protein 2 gene was found in a group of patients with primary biliary cirrhosis. This heterozygous mutation was significantly associated with the presence of pruritus.