Measuring line tension: Thermodynamic integration during detachment of a molecular dynamics droplet.

The contact line (CL) is where solid, liquid, and vapor phases meet, and Young's equation describes the macroscopic force balance of the interfacial tensions between these three phases. These interfacial tensions are related to the nanoscale stress inhomogeneity appearing around the interface, and for curved CLs, e.g., a three-dimensional droplet, another force known as the line tension must be included in Young's equation. The line tension has units of force, acting parallel to the CL, and is required to incorporate the extra stress inhomogeneity around the CL into the force balance. Considering this feature, Bey et al. [J. Chem. Phys. 152, 094707 (2020)] reported a mechanical approach to extract the value of line tension τℓ from molecular dynamics (MD) simulations. In this study, we show a novel thermodynamics interpretation of the line tension as the free energy per CL length, and based on this interpretation, through MD simulations of a quasi-static detachment process of a quasi-two-dimensional droplet from a solid surface, we obtained the value τℓ as a function of the contact angle. The simulation scheme is considered to be an extension of a thermodynamic integration method, previously used to calculate the solid-liquid and solid-vapor interfacial tensions through a detachment process, extended here to the three-phase system. The obtained value agreed well with the result by Bey et al. and showed the validity of thermodynamic integration at the three-phase interface.

Equilibrium molecular dynamics evaluation of the solid-liquid friction coefficient: Role of timescales.

Solid-liquid friction plays a key role in nanofluidic systems. Following the pioneering work of Bocquet and Barrat, who proposed to extract the friction coefficient (FC) from the plateau of the Green-Kubo (GK) integral of the solid-liquid shear force autocorrelation, the so-called plateau problem has been identified when applying the method to finite-sized molecular dynamics simulations, e.g., with a liquid confined between parallel solid walls. A variety of approaches have been developed to overcome this problem. Here, we propose another method that is easy to implement, makes no assumptions about the time dependence of the friction kernel, does not require the hydrodynamic system width as an input, and is applicable to a wide range of interfaces. In this method, the FC is evaluated by fitting the GK integral for the timescale range where it slowly decays with time. The fitting function was derived based on an analytical solution of the hydrodynamics equations [Oga et al., Phys. Rev. Res. 3, L032019 (2021)], assuming that the timescales related to the friction kernel and the bulk viscous dissipation can be separated. By comparing the results with those of other GK-based methods and non-equilibrium molecular dynamics, we show that the FC is extracted with excellent accuracy by the present method, even in wettability regimes where other GK-based methods suffer from the plateau problem. Finally, the method is also applicable to grooved solid walls, where the GK integral displays complex behavior at short times.

Large effect of lateral box size in molecular dynamics simulations of liquid-solid friction.

Molecular dynamics simulations are a powerful tool to characterize liquid-solid friction. A slab configuration with periodic boundary conditions in the lateral dimensions is commonly used, where the measured friction coefficient could be affected by the finite lateral size of the simulation box. Here we show that for a very wetting liquid close to its melting temperature, strong finite size effects can persist up to large box sizes along the flow direction, typically ∼30 particle diameters. We relate the observed decrease of friction in small boxes to changes in the structure of the first adsorbed layer, which becomes less commensurable with the wall structure. Although these effects disappear for lower wetting cases or at higher temperatures, we suggest that the possible effect of the finite lateral box size on the friction coefficient should not be automatically set aside when exploring unknown systems.