Temporal Variation of Radionuclide Contamination of Marine Plants on the Fukushima Coast after the East Japan Nuclear Disaster.

As a result of the Great East Japan Earthquake and associated tsunami in March 2011, the Fukushima Daiichi Nuclear Power Plant (FDNPP) released a large amount of radioactive material into the environment, resulting in contamination of many marine organisms. In this study, 15 marine algal species and a seagrass species were collected from the sublittoral zone of the Iwaki Coast of Fukushima Prefecture from May 2012 to June 2015 and analyzed for variations in 110mAg, 134Cs, and 137Cs over time. The results indicated that (1) 110mAg, 134Cs, and 137Cs were present in all marine plants collected in May 2012, (2) the concentration of 110mAg in the seagrass Phyllospadix iwatensis decreased significantly over time while the ecological half-life of 110mAg in P. iwatensis was longer at locations closer to the FDNPP, and (3) the 110mAg/137Cs radioactivity ratio of P. iwatensis was remarkably high until 2015, indicating that detectable 110mAg was present in the coastal environment 4 years after the accident. The concentration of 110mAg in P. iwatensis was higher than those in other marine algae, demonstrating a species-specific mechanism of accumulation.

Sulfate aerosol as a potential transport medium of radiocesium from the Fukushima nuclear accident.

To date, areas contaminated by radionuclides discharged from the Fukushima Dai-ichi nuclear power plant accident have been mapped in detail. However, size of the radionuclides and their mixing state with other aerosol components, which are critical in their removal from the atmosphere, have not yet been revealed. We measured activity size distributions of (134)Cs and (137)Cs in aerosols collected 47 days after the accident at Tsukuba, Japan, and found that the activity median aerodynamic diameters of (134)Cs and (137)Cs in the first sample (April 28-May 12) were 0.54 and 0.53 µm, respectively, and those in the second sample (May 12-26) were both 0.63 µm. The activity size distributions of these radiocesium were within the accumulation mode size range and almost overlapped with the mass size distribution of non-sea-salt sulfate aerosol. From the analysis of other aerosol components, we found that sulfate was the potential transport medium for these radionuclides, and resuspended soil particles that attached radionuclides were not the major airborne radioactive substances at the time of measurement. This explains the relatively similar activity sizes of radiocesium measured at various sites during the Chernobyl accident. Our results can serve as basic data for modeling the transport/deposition of radionuclides.

A trial of in situ and static measurements of levels of radioactive cesium 137 on shallow rugged reefs lying close to the coastline of Fukushima.

With the use of an in situ and static method for gamma-ray measurements, levels of radioactive cesium 137 on shallow rugged reefs which lie between 37.3° N and 37.4° N, from the coastline of Fukushima to 141.06° E, at a depth of around 10 m were surveyed for the first time from May 2016 to December 2017. To confirm the contact between the detector and a surface of rock, we used a fact that potassium containing minerals are abundant and uniformly distributed in the area, and thus the strength of the photoelectric peak of natural radioactive potassium 40 is nearly constant over the area. We have found that the levels of radioactive cesium 137 varied from point to point within a range from 1 × 104 Bq/m2 to 6 × 104 Bq/m2.

Measurement of incident position of hypervelocity particles on piezoelectric lead zirconate titanate detector.

A cosmic dust detector for use onboard a satellite is currently being developed by using piezoelectric lead zirconate titanate (PZT). The characteristics of the PZT detector have been studied by bombarding it with hypervelocity iron (Fe) particles supplied by a Van de Graaff accelerator. One central electrode and four peripheral electrodes were placed on the front surface of the PZT detector to measure the impact positions of the incident Fe particles. It was demonstrated that the point of impact on the PZT detector could be identified by using information on the time at which the first peak of the output signal obtained from each electrode appeared.

Weak size dependence of resuspended radiocesium adsorbed on soil particles collected after the Fukushima nuclear accident.

Most studies of the properties of airborne radionuclides emitted from the Fukushima Daiichi Nuclear Power Plant have focused on the relatively early stages of the accident, and little is known about the characteristics of radiocesium in the long-term. In this study, we analyzed activity size distributions of airborne radiocesium collected over 5 months in Tsukuba, Japan. Radiocesium in the accumulation mode size range (0.1-2 µm in aerodynamic diameter) was overwhelming in the early aerosol samples and decreased with time, while that associated with coarse aerosols remained airborne. We examined the radiocesium adsorbed onto airborne soil particles, and found that the size dependence of 137Cs surface density adsorbed on soil particles was weak. That is, radiocesium was distributed homogeneously throughout the aerodynamic diameter range of 2.1-11 µm. This characteristic may be related to the reported structure of radiocesium-bearing soil particles collected from the ground, which consisted of an aggregate of specific clay minerals and other non-cesium adsorbing particles. The resuspension factors for the first two aerosol samples collected during late April and May 2011 were close to those in European cities in the months following the Chernobyl accident, despite different soil and weather conditions.

Influence of the location of the parotid duct orifice on oral clearance.

OBJECTIVES: To determine the location of the parotid duct orifice in relation to the maxillary molars and its influence on oral clearance on the buccal surfaces of the maxillary molars. METHODS: A 2-mm hole was made at the centre of an adhesive therapeutic agent for aphthous stomatitis and the agent was placed on the mucosa so that the hole matched the parotid duct orifice. To locate the orifice, an impression of the buccal tooth surfaces and mucosa around the agent was taken with the teeth in centric occlusion. To evaluate the oral clearance rate, 12 subjects who displayed the parotid duct orifice within 1S.D. of the mean values obtained from the original 35 subjects were selected. 1% agar containing 1 mol/l potassium chloride was placed into three cylinders positioned horizontally, 6mm apart, in an acrylic holder centred over the mean duct location. The diffusion chambers were taken from the mouth at selected time intervals and the gel transferred quantitatively to flasks containing 300 ml of 100 ppm NaCl, which was assayed for potassium by atomic absorption spectrophotometry. Half-times for clearance were calculated. RESULTS: The mean location of the parotid duct orifice was -0.4 mm (range -7.5 to +6.1 mm) mesial to the contact surface between the maxillary first and second molars (where negative values indicate mesial and positive values distal) and 7.2 mm (range +3.8 to +10.4 mm) above a line touching the buccal cusps of the upper molars. The clearance half-time values were shortest for the central cylinder whether salivary flow was unstimulated or stimulated and when flow was unstimulated the clearance half-time was shorter for the mesial than the distal cylinder. CONCLUSION: The degree of individual variation in the location of the parotid duct orifice is great and its exact location will markedly affect oral clearance at different positions on the buccal surfaces of the upper molars.

NMR analysis of lignins in CAD-deficient plants. Part 1. Incorporation of hydroxycinnamaldehydes and hydroxybenzaldehydes into lignins.

Peroxidase/H2O2-mediated radical coupling of 4-hydroxycinnamaldehydes produces 8-O-4-, 8-5-, and 8-8-coupled dehydrodimers as has been documented earlier, as well as the 5-5-coupled dehydrodimer. The 8-5-dehydrodimer is however produced kinetically in its cyclic phenylcoumaran form at neutral pH. Synthetic polymers produced from mixtures of hydroxycinnamaldehydes and normal monolignols provide the next level of complexity. Spectral data from dimers, oligomers, and synthetic polymers have allowed a more substantive assignment of aldehyde components in lignins isolated from a CAD-deficient pine mutant and an antisense-CAD-downregulated transgenic tobacco. CAD-deficient pine lignin shows enhanced levels of the typical benzaldehyde and cinnamaldehyde end-groups, along with evidence for two types of 8-O-4-coupled coniferaldehyde units. The CAD-downregulated tobacco also has higher levels of hydroxycinnamaldehyde and hydroxybenzaldehyde (mainly syringaldehyde) incorporation, but the analogous two types of 8-O-4-coupled products are the dominant features. 8-8-Coupled units are also clearly evident. There is clear evidence for coupling of hydroxycinnamaldehydes to each other and then incorporation into the lignin, as well as for the incorporation of hydroxycinnamaldehyde monomers into the growing lignin polymer. Coniferaldehyde and sinapaldehyde (as well as vanillin and syringaldehyde) co-polymerize with the traditional monolignols into lignins and do so at enhanced levels when CAD-deficiency has an impact on the normal monolignol production. The implication is that, particularly in angiosperms, the aldehydes behave like the traditional monolignols and should probably be regarded as authentic lignin monomers in normal and CAD-deficient plants.