RESUMO
We spend most of our time indoors; however, little is known about the effects of exposure to aerosol particles indoors. We aimed to determine differences in relative toxicity and physicochemical properties of PM2.5 collected simultaneously indoors (PM2.5 INDOOR ) and outdoors (PM2.5 OUTDOOR ) in 15 occupied homes in southern Sweden. Collected particles were extracted from filters, pooled (indoor and outdoor separately), and characterized for chemical composition and endotoxins before being tested for toxicity in mice via intratracheal instillation. Various endpoints including lung inflammation, genotoxicity, and acute-phase response in lung and liver were assessed 1, 3, and 28 days post-exposure. Chemical composition of particles used in toxicological assessment was compared to particles analyzed without extraction. Time-resolved particle mass and number concentrations were monitored. PM2.5 INDOOR showed higher relative concentrations (µg mg-1 ) of metals, PAHs, and endotoxins compared to PM2.5 OUTDOOR . These differences may be linked to PM2.5 INDOOR causing significantly higher lung inflammation and lung acute-phase response 1 day post-exposure compared to PM2.5 OUTDOOR and vehicle controls, respectively. None of the tested materials caused genotoxicity. PM2.5 INDOOR displayed higher relative toxicity than PM2.5 OUTDOOR under the studied conditions, that is, wintertime with reduced air exchange rates, high influence of indoor sources, and relatively low outdoor concentrations of PM. Reducing PM2.5 INDOOR exposure requires reduction of both infiltration from outdoors and indoor-generated particles.
Assuntos
Poluentes Atmosféricos , Poluição do Ar em Ambientes Fechados , Pneumonia , Animais , Camundongos , Poluentes Atmosféricos/análise , Poluição do Ar em Ambientes Fechados/efeitos adversos , Poluição do Ar em Ambientes Fechados/análise , Monitoramento Ambiental , Tamanho da Partícula , Reação de Fase Aguda , Suécia , Material Particulado/análise , Pneumonia/etiologiaRESUMO
Burning candles release a variety of pollutants to indoor air, some of which are of concern for human health. We studied emissions of particles and gases from the stressed burning of five types of pillar candles with different wax and wick compositions. The stressed burning was introduced by controlled fluctuating air velocities in a 21.6 m3 laboratory chamber. The aerosol physicochemical properties were measured both in well-mixed chamber air and directly above the candle flame with online and offline techniques. All candles showed different emission profiles over time with high repeatability among replicates. The particle mass emissions from stressed burning for all candle types were dominated by soot (black carbon; BC). The wax and wick composition strongly influenced emissions of BC, PM2.5 , and particle-phase polycyclic aromatic hydrocarbons (PAHs), and to lower degree ultrafine particles, inorganic and organic carbon fraction of PM, but did not influence NOx , formaldehyde, and gas-phase PAHs. Measurements directly above the flame showed empirical evidence of short-lived strong emission peaks of soot particles. The results show the importance of including the entire burn time of candles in exposure assessments, as their emissions can vary strongly over time. Preventing stressed burning of candles can reduce exposure to pollutants in indoor air.
Assuntos
Poluentes Atmosféricos , Poluição do Ar em Ambientes Fechados , Hidrocarbonetos Policíclicos Aromáticos , Poluentes Atmosféricos/análise , Poluição do Ar em Ambientes Fechados/análise , Monitoramento Ambiental , Humanos , Material Particulado/análise , Hidrocarbonetos Policíclicos Aromáticos/análise , FuligemRESUMO
Exposure to airborne particles causes detrimental health effects, hence their assessment in indoor environments, where people spend most of the time, is important. The influence of energy renovation and occupants' activities on airborne particle concentrations was assessed in seven occupied Swedish residences. Ultrafine particle (UFP, <100 nm) number concentrations, PM2.5 (<2.5 µm) and black carbon (BC, <900 nm) mass concentrations were simultaneously measured inside and outside before, after renovation, and during follow-up. The average indoor UFP number concentrations increased from 6200 (±4070) cm-3 before renovation to 12,700 (±6040) cm-3 during the follow up, as the number of indoor activities doubled. Indoor UFP number concentrations depended mainly on frequency and type of occupants' activities in studied residences (e.g., cooking, candle burning). The average indoor PM2.5 concentration decreased from 8.6 (±5.8) µg m-3 before renovation to 2.5 (±1.3) µg m-3 during follow up, as the activities that generated PM2.5 decreased, and infiltration of outdoor particles could have been decreased due to renovation measures. However, the indication of infiltration decrease during the follow up, assessed on the basis of indoor to outdoor ratios during non-activity times (with no influence of occupants' activities), was not observed after the renovation and should be treated with caution. In this study indoor PM2.5 and BC were influenced by activities and outdoor concentrations. Reduction of exposure to indoor UFP, might be obtained by optimization of kitchen exhaust flows. An improved design of supply air inlets in mechanical exhaust ventilation systems may reduce PM2.5 infiltration. Occupants' logbook records, needed for identification of sources contributing to particle exposure, proved useful but not always accurate compared to technical measurements of activities and UFP concentrations. Development of simple and reliable activity detection systems is needed to complement logbooks and allow accurate assessment of source contribution to particle exposure in homes and associated health effects.
Assuntos
Poluentes Atmosféricos , Poluição do Ar em Ambientes Fechados , Poluentes Atmosféricos/análise , Poluição do Ar em Ambientes Fechados/análise , Monitoramento Ambiental , Humanos , Tamanho da Partícula , Material Particulado/análise , SuéciaRESUMO
We spend about two thirds of our time in private homes where airborne particles of indoor and outdoor origins are present. The negative health effects of exposure to outdoor particles are known. The characteristics of indoor airborne particles, though, are not well understood. This study assesses the differences in chemical composition of PM1 (<1 µm) inside and outside of an occupied Swedish residence in real time with a High-Resolution Time-of-Flight Aerosol Mass Spectrometer (HR-ToF-AMS) and an Aethalometer. The chemical composition and concentration of particles indoors showed large differences compared to outdoors. The average indoor concentration was 15 µg m-3 and was higher than the outdoor 7 µg m-3. Organics dominated indoor particle composition (86% of the total mass) and originated from indoor sources (cooking, e-cigarette vaping). The average indoor to outdoor ratios were 5.5 for organic matter, 1.0 for black carbon, 0.6 for sulphate, 0.1 for nitrate, 0.2 for ammonium and 0.2 for chloride. The occupancy time accounted for 97% of the total measured period. Four factors were identified in the source apportionment of organic particle fraction by applying positive matrix factorization (PMF): two cooking factors, one e-cigarette factor and one outdoor contribution (OOA) organic factor penetrated from outside.