Differentiation of Four Polyvinylidene Fluoride Polymers Based on Their End Groups by DART-FT-ICR MS and Kendrick Plots.

Nowadays, synthetic polymers are produced and used in many materials for different applications. Matrix-assisted laser desorption/ionization or electrospray mass spectrometry are classically used to investigate them, but these techniques require sample preparation steps, which are not always suitable for the study of insoluble or formulated polymers. Alternatively, direct real-time (DART) ionization analysis may be conducted without sample preparation. Four polyvinylidene fluoride (PVDF) polymers involving the C2H2F2 repeating unit coming from different suppliers have been analyzed by DART Fourier transform ion cyclotron resonance mass spectrometry (FT-ICR MS) in negative-ion mode. The obtained mass spectra systematically displayed an oligomeric distribution between m/z 400 and 1300 of [M - H]-, [M + O2]•-, and [M + NO2]- ions. Kendrick plots were used to ease the identification of PVDF end-groups and establish a difference between the samples. Both commercial PVDF polymers shared the same α+ω end groups formula, which confirmed a similar polymerization process for their synthesis. The two other PVDFs were clearly different from the commercial ones by the occurrence of specific end-groups. MS/MS and MS3 experiments were conducted to obtain structural information on these end-groups.

Quantitative analysis of phosphoric acid esters in aqueous samples by isotope dilution stir-bar sorptive extraction combined with direct analysis in real time (DART)-Orbitrap mass spectrometry.

A novel hyphenated technique, namely the combination of stir bar sorptive extraction (SBSE) with isotope dilution direct analysis in real time (DART) Orbitrap™ mass spectrometry (OT-MS) is presented for the extraction of phosphoric acid alkyl esters (tri- (TnBP), di- (HDBP), and mono-butyl phosphate (H2MBP)) from aqueous samples. First, SBSE of phosphate esters was performed using a Twister™ coated with 24 µL of polydimethylsiloxane (PDMS) as the extracting phase. SBSE was optimized for extraction pH, phase ratio (PDMS volume/aqueous phase volume), stirring speed, extraction time and temperature. Then, coupling of SBSE to DART/Orbitrap-MS was achieved by placing the Twister™ in the middle of an open-ended glass tube between the DART and the Orbitrap™. The DART mass spectrometric response of phosphate esters was probed using commercially available and synthesized alkyl phosphate ester standards. The positive ion full scan spectra of alkyl phosphate triesters (TnBP) was characterized by the product of self-protonation [M+H](+) and, during collision-induced dissociation (CID), the major fragmentation ions corresponded to consecutive loss of alkyl chains. Negative ionization gave abundant [M-H](-) ions for both HDnBP and H2MnBP. Twisters™ coated with PDMS successfully extracted phosphate acid esters (tri-, di- and mono-esters) granted that the analytes are present in the aqueous solution in the neutral form. SBSE/DART/Orbitrap-MS results show a good linearity between the concentrations and relative peak areas for the analytes in the concentration range studied (0.1-750 ng mL(-1)). Reproducibility of this SBSE/DART/Orbitrap-MS method was evaluated in terms of %RSD by extracting a sample of water fortified with the analytes. The %RSDs for TnBP, HDnBP and H2MnBP were 4, 3 and 3% (n=5) using the respective perdeuterated internal standards. Matrix effects were investigated by matrix matched calibration standards using underground water samples (UWS) and river water samples (RWS). Matrix effects were effectively compensated by the addition of the perdeuterated internal standards. The application of this new SBSE/DART/Orbitrap-MS method should be very valuable for on-site sampling/monitoring, limiting the transport of large volumes of water samples from the sampling site to the laboratory.

Retention behaviour of peptides in capillary electrochromatography using an embedded ammonium in dodecacyl stationary phase.

The potential of a silica stationary phase bearing an embedded cationic quaternary amine in dodecacyl chain, to separate peptides by capillary electrochromatography (CEC) has been evaluated. The ability of this stationary phase, to generate a consistent anodic electroosmotic flow was first evaluated. This flow was found to be independent of pH over a wide range (2-12), of the acetonitrile percentage in the electrolyte. The stability of the stationary phase evaluated through the electroosmotic flow variations was demonstrated at extreme pH values (2.5 and 9.1). A careful examination of the influence of mobile phase conditions (acetonitrile percentage, salt concentration and nature of buffer) on the electrochromatographic retention and electrophoretic migration behaviour of different standard peptides was carried out. In acidic conditions, the electrokinetic contribution appears to be predominant compared to the chromatographic one. Several types of chromatographic interactions, reversed-phase partitioning and anion exchange, were involved in the CEC of peptides, whereas repulsive electrostatic interaction could be considered as negligible. This stationary phase affords different selectivity compared to that observed on a C18 stationary phase. Finally, the method was applied to the peptide mapping of beta-lactoglobulin and human growth hormone under unpressurized and isocratic elution.

Selection of two reliable parameters to evaluate the impact of the mobile-phase composition on capillary electrochromatography performance with monolithic and particle-packed capillary columns.

Different models have been described in the literature to evaluate the total porosity of CEC columns: gravimetric, flow as well as conductivity-based methods. In this study, these models have been compared for two kinds of CEC columns: two mixed-mode silica particle stationary phases and different monolithic columns (acrylate or polystyrene divinylbenzene-based). The total porosities measured from the conductivity-based methods were lower than the total column porosities obtained by gravimetric or flow methods for all the investigated columns while the wide distribution of observed values shows that conductivity-based methods discriminate columns more efficiently with very different properties. We propose a conductivity-based method taking into account the actual length proposed by Horvath, to evaluate what we call an "actual electrokinetic" porosity (AEP). This parameter, based on electrokinetic theory only, affords the most consistent evaluation of porosity under experimental CEC conditions for the packed- and acrylate-based monolithic columns. To illustrate the potential of AEP and actual EOF for the estimation of the performances of a CEC system (stationary and mobile phases) we studied the influence of the mobile-phase composition on these parameters for CEC separations with an ammonium embedded packed stationary phase. The AEP and the actual electroosmotic mobility should allow a better understanding of the perfusive EOF and stationary-phase wettability. For neutral compounds (substituted phenols), AEP evaluation allowed us to predict the mobile-phase conditions able to enhance the efficiency while both AEP and actual EOF had to be considered in the case of peptide analysis.

A study of the binding between polymers and peptides, using affinity capillary electrophoresis, applied to polymeric drug delivery systems.

We have investigated the potential of affinity capillary electrophoresis (ACE) to evaluate binding constants between an anionic polydispersed polymer and four peptides. Nonlinear regression and three current linearization methods, the y-reciprocal, the x-reciprocal and the double-reciprocal, were employed for the estimation of the binding constants. The x-reciprocal and the double-reciprocal plots indicated the presence of two portions of straight lines for angiopeptin, triptorelin and the thyrotropin releasing hormone (TRH), and therefore the probable existence of a second-order interaction which causes the deviation from the 1:1 model. Peptide 1 exhibited a unique binding constant of 2.4 x 10(6)M(-1). In contrast, angiopeptin, triptorelin and TRH exhibited a K(1) of 4.0 x 10(6), 5.3 x 10(6) and 20.2 x 10(6)M(-1), respectively, and a K(2) of 0.4 x 10(6), 0.5 x 10(6) and 1.4 x 10(6)M(-1), respectively. The origin of the high scattering of the data points was further investigated. Neither the viscosity, nor the adsorption of the peptides to the capillary wall appeared to be the determining factor of data scattering. Finally, a possible adsorption of the polymer leading to the electroosmotic flow instability was supposed.