[Molecular regulatory mechanisms of hypoxia-inducible factor and interventional effect of Chinese herbal medicine].

Hypoxia-inducible factors(HIFs)are the key transcription factors that sense and regulate cellular oxygen concentration in vivo. HIF-1 is composed of 2 subunits,α and ß,in which,the molecular regulatory mechanism of HIF-1α involves the main processes of its degradation and activation. The degradation of HIF-1α is regulated by oxygen-dependent pathways,including "von hippel-lindau protein(pVHL)-dependent pathway" and "pVHL-independent pathway". The activation of HIF-1α is regulated by oxygen-independent pathways,including mammalian target of rapamycin(mTOR)/eukaryotic initiation factor 4 E-binding protein 1(4 EBP1)/HIF-1α pathway,phosphatidylinositol 3-kinase(PI3 K)/proteirrserinc-threonine kinases(Akt)/HIF-1α pathway and silent information regulator1(Sirt1)/HIF-1α pathway. In recent years,based on the molecular regulatory mechanism of HIFs,Roxadustat,a new drug for the treatment of renal anemia has been developed. Besides, some macromolecular substances with similar pharmacological effect to HIFs have been found in the extracts from Chinese herbal medicine(CHM),such as emodin,notoginseng triterpenes,honokiol and clematichinenoside. These natural macromolecular substances play the regulatory roles in inflammatory response,epigenetic modification and auto-phagy. It is worth noting that,for common hypoxic-related diseases including diabetic kidney disease,HIFs-mediated "pyroptosis" may be a new target of CHMs for clearing dampness and heat and its representative classical prescriptions(Ermiao Pills)in treating inflammatory injury in cells and tissues.

Wear Behavior of a Heat-Treatable Al-3.5Cu-1.5Mg-1Si Alloy Manufactured by Selective Laser Melting.

In this study, the wear behavior of a heat-treatable Al-7Si-0.5Mg-0.5Cu alloy fabricated by selective laser melting was investigated systematically. Compared with the commercial homogenized AA2024 alloy, the fine secondary phase of the SLM Al-Cu-Mg-Si alloy leads to a low specific wear rate (1.8 ± 0.11 × 10-4 mm3(Nm)-1) and a low average coefficient of friction (0.40 ± 0.01). After the T6 heat treatment, the SLM Al-Cu-Mg-Si alloy exhibits a lower specific wear rate (1.48 ± 0.02 × 10-4 mm3(Nm)-1), but a similar average coefficient of friction (0.34 ± 0.01) as the heat-treated AA2024 alloy. Altogether, the SLM Al-3.5Cu-1.5Mg-1Si alloy is suitable for the achievement of not only superior mechanical performance, but also improved tribological properties.