A facile approach to the scalable preparation of thermoplastic/carbon nanotube composites.

Disentangling and dispersing multiwalled carbon nanotubes (MWCNTs) in thermoplastics by the existing melt compounding facilities where neither solvent nor liquid chemicals are allowed remains a great challenge. This challenge is addressed herein by combining ball milling with melt compounding. Specifically, ball milling is applied to disentangle MWCNTs and to eventually liberate each tube from agglomeration, and then the tubes are melt compounded with SSFs (PA6). A uniformly distributed MWCNT network is observed; obvious load transfer from the matrix to the tubes is evidenced by the presence of many firmly embedded tubes on the fracture surface. The electrical conductivity percolation threshold of PA6/MWCNT composites is found to be 2.5-3.0 wt%, in comparison with 5.0-8.0 wt% for PA6/stainless steel fiber composites. The PA6/MWCNT composite at 10.0 wt% shows a 76% increase in flexural modulus and 58% in flexural strength.

[Modified QuEChERS method based on multi-walled carbon nanotubes coupled with gas chromatography-tandem mass spectrometry for the detection of 10 pyrethroid pesticide residues in tea].

A modified QuEChERS method, based on multi-walled carbon nanotubes (MWCNTs), was established for the detection of 10 pyrethroid pesticides (cyfluthrin, flucythrinate, fenpropathrin, bifenthrin, cyhalothrin, permethrin, cypermethrin, etofenprox, fenvalerate, deltamethrin) in tea, in combination with gas chromatography-tandem mass spectrometry (GC-MS/MS). The purification effects and dosages of four carbon nanomaterials, viz. single-walled carbon nanotubes (SWCNTs), MWCNTs, amino-modified MWCNTs, and graphene, were compared. An orthogonal experimental design was used to determine the optimal experimental conditions for sample pretreatment. The experimental factors governing the process were analyzed using variance. The results showed that the optimized sample pretreatment parameters were as follows. Acetonitrile was used as the extraction solvent with ultrasonic extraction for 35 min, while 60 mg MWCNTs, 200 mg PSA, and 200 mg C18, were used as purifiers. The effects of the extraction solvent and the carbon nanomaterials used on the recoveries of the 10 pyrethroid pesticides were significantly different (p<0.001), and the effect of extraction time on the recoveries was statistically different (p<0.05). The dosage of carbon nanomaterials had no significant effect on the recoveries (p>0.05). Good linearities were observed for the 10 pyrethroid pesticides in the concentration range of 0.01-2 mg/L. The limits of detection (LODs) and limits of quantification (LOQs) were in the ranges of 0.001-0.01 mg/kg and 0.005-0.04 mg/kg, respectively. The average recoveries of the pyrethroid pesticides spiked into blank samples of green tea were 91.4%-109.7%, and the relative standard deviations were 0.12%-9.80% (n=6). Furthermore, the matrix effects (MEs) of scented green tea, green tea, and black tea were evaluated. It was found that the addition of MWCNTs to the purifier can effectively reduce the matrix effect in green tea and black tea matrices. The developed method and the national standard method were used to detect the residues of the 10 pyrethroid pesticides in 120 tea samples available in the market. The results showed that cyfluthrin, deltamethrin, fenvalerate, permethrin, fenpropathrin, cypermethrin, bifenthrin and cyhalothrin were detected, and the contents obtained with the two methods were similar. Although pyrethroids were detected in most tea samples, the contents of all pesticide residues were below the maximum residue limits (MRLs). Therefore, the developed method is suitable for the rapid quantitative analysis of pesticide residues in tea.

Hydrogen Bonding-Reinforced Hydrogel Electrolyte for Flexible, Robust, and All-in-One Supercapacitor with Excellent Low-Temperature Tolerance.

Flexible supercapacitors are promising energy storage devices for emerging wearable electronics. However, due to the poor mechanical strength, complicated device manufacturing process, and unsatisfactory low-temperature tolerance, their overall performance for practical applications is hindered. Herein, we report a hydrogen bonding-reinforced, dual-crosslinked poly(vinyl alcohol), acrylic acid, and H2SO4 (PVA-AA-S) hydrogel electrolyte for all-in-one flexible supercapacitors. The PVA-AA-S hydrogel demonstrates excellent compressive/tensile properties and high ionic conductivity. It tolerates compressive stress of 0.53 MPa and is stretchable up to 500%. The hydrogel-based all-in-one supercapacitor shows promising electrochemical performance under various harsh conditions. The device energy density and power density reach up to 14.2 µWh cm-2 and 0.94 mW cm-2, respectively. Furthermore, it retains nearly 80% capacitance after being stored at -35 °C for 23 days. The excellent performance of the hydrogel electrolyte originates from its abundant strong hydrogen bonding between polymer chains and water molecules.

Changing the metal binding specificity of superoxide dismutase from Thermus thermophilus HB-27 by a single mutation.

Metal binding of superoxide dismutase from Thermus thermophilus HB27 was analyzed by comparing the related structures and sequences from different origins. Mutants (Ile166Leu, Asp167Glu, and Ile166Leu-Asp167Glu) were prepared and characterized. The mutants Asp167Glu and Ile166Leu-Asp167Glu changed their binding specificities from manganese to iron, which were manifested by the differences in color of the enzyme solutions and by flame atomic absorption analysis. Specific activities of the three mutants were 112, 52, and 62% of that of the wild-type enzyme, respectively. Asp167Glu and Ile166Leu-Asp167Glu only retained 6.8 and 6.1%, respectively, of the original activities after dialysis against 1 mM EDTA. Tryptophan fluorescence measurement and native gel electrophoresis implied that the three mutants could fold into a less condensed structure. Their folding and changes in the ion binding sites of the modeled structures might be the reason for their low affinities to metal ions. These findings increased our understanding of metal binding specificity of superoxide dismutase.

Development of a Norovirus P particle platform for eliciting neutralizing antibody responses to the membrane proximal external region of human immunodeficiency virus type 1 envelope.

Eliciting efficient broadly neutralizing antibodies (BnAbs) is an important goal that has yet to be achieved for human immunodeficiency type 1 (HIV-1) vaccine development, although they are rarely produced in virus-infected individuals. In particular, inducing specific neutralizing antibodies to the gp41 membrane proximal external region (MPER) has proven a difficult task. In this study, we introduce Norovirus P particles as a new platform to display the MPER epitope of HIV-1 as a vaccine with the aim of enhancing immune responses. The results showed that HIV-1 chimeric P particles were capable of inducing MPER-specific antibody responses in immunized guinea pigs, although only weakly neutralizing activity could be detected. These findings are consistent with other previous studies which have also focused on the well-studied 2F5 and 4E10 BnAbs. Our findings provide an alternate strategy for design of vaccines against HIV-1. However, great challenges remain in the effort to develop vaccines that can induce efficient HIV-1 neutralizing antibodies.

HPV prevalence, E6 sequence variation and physical state of HPV16 isolates from patients with cervical cancer in Sichuan, China.

OBJECTIVES: Infection with high-risk human papillomavirus (hr-HPV) is an important factor associated with cervical cancer. The genetic mutation of HPV16 E6 and integration of HPV16 DNA in the cervical carcinoma tissues are considered important genetic changes in cervical lesion progression. But the studies of hr-HPV epidemiology are relatively less in the area of Sichuan, China. Therefore, we investigated the prevalence of 9 high-risk subtypes and analyzed the genetic mutation characteristic of HPV16 E6 and physical state of HPV16 DNA. METHODS: The fragments of L1 and E6 genes were amplified by PCR or nested PCR and then directly sequenced. Further, the multiplex PCR for HPV16 E2 and E6 genes was performed for detection of integration. RESULTS: HPV16, 58 and 18 were prominent, accounting for 78.6%, 20.0% and 9.7%, respectively in 145 isolates. E6 variants revealed that the European (EP) prototype and East Asia (EA) strain were 26 (23.0%) and 34 (30.1%), respectively. Furthermore, there were 14 base substitutions in E6 regions of the study group, of which 12 resulted in amino acid changes and the rest was silent mutation. Significantly, the 240G substitution exactly located the P53 degradation site. Overall, 8 of 114 (7.0%) isolates only contained integrated HPV16 DNA, 43 (37.7%) only contained episomal DNA and 63 (55.3%) contained both integrated and episomal DNA. The proportion of disruption of an intact E2 gene in the patients with cervical cancer is much lower than that in the previous studies. CONCLUSIONS: HPV16, 58 and 18 were mainly prevailing subtypes in patients with cervical cancer from Sichuan areas, China and EP/EA strains were predominant in these areas. Some mutations of E6 gene, which lead to the amino acid changes, may be more potentially carcinogenic and the proportion of disruption of an intact E2 gene is much lower.