Highly Stable and Recyclable Sequestration of CO2 Using Supported Melamine on Layered-Chain Clay Mineral.

A type of highly stable and recyclable clay-based composite was developed for sequestration of CO2, which was synthesized by loading melamine (MEL) onto attapulgite (ATT) via a wet impregnation method. The synthesized materials were characterized by N2 adsorption-desorption, Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TG), and transmission electron microscopy (TEM). By means of thermal and acidic treatments more active sites of ATT were exposed, and large surface areas were obtained. The MEL molecules were well combined with those exposed sites, which enhanced stability and cyclability for CO2 sequestration. On the basis of CO2 adsorption-desorption measurements, the composite of ATT-MEL was found to have a higher CO2 adsorption capacity (4.91 cm3/g) which was much higher than that of CO2 absorption on bare MEL (1.30 cm3/g) at 30 °C. After ten cycles of reusing, the composite exhibited even higher capacity for CO2 adsorption by an increased percentage of 5.91% (30 °C) and 5.77% (70 °C) compared to the capacity in the first cycle. The reason lies in the strong interaction between melamine and attapulgite matrix which was further confirmed by DFT calculations. The MEL was validated to have advantages over aliphatic amines (TEPA) in modifying ATT to get high stability of CO2-adsorbents.

Amino-functionalized mesoporous silica modified glassy carbon electrode for ultra-trace copper(II) determination.

This paper described a facile and direct electrochemical method for the determination of ultra-trace Cu(2+) by employing amino-functionalized mesoporous silica (NH2-MCM-41) as enhanced sensing platform. NH2-MCM-41 was prepared by using a post-grafting process and characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM) and fourier transform infrared (FTIR) spectroscopy. NH2-MCM-41 modified glassy carbon (GC) electrode showed higher sensitivity for anodic stripping voltammetric (ASV) detection of Cu(2+) than that of MCM-41 modified one. The high sensitivity was attributed to synergistic effect between MCM-41 and amino-group, in which the high surface area and special mesoporous morphology of MCM-41 can cause strong physical absorption, and amino-groups are able to chelate copper ions. Some important parameters influencing the sensor response were optimized. Under optimum experimental conditions the sensor linearly responded to Cu(2+) concentration in the range from 5 to 1000 ng L(-1) with a detection limit of 0.9 ng L(-1) (S/N=3). Moreover, the sensor possessed good stability and electrode renewability. In the end, the proposed sensor was applied for determining Cu(2+) in real samples and the accuracy of the results were comparable to those obtained by inductively coupled plasma optical emission spectrometry (ICP-OES) method.