RESUMO
The surface activation agents have been used to form a high quality coating layer on manganese phosphate process. The role of surface activation agents increases the nucleation sites, which leads to obtain a finer phosphate coating. In this study, the effects of surface activation agents on manganese phosphate coating were investigated by changing the chemical composition ratio between sodium pyrophosphate and manganese carbonate. The morphology, chemical composition and corrosion resistance of the coatings were analyzed by SEM, XRD, EDS, XPS and electrochemical polarization method, respectively. Also, the tribology property of manganese phosphate coating was tested by ball-on disk. In the results of EDS analysis, coating layer consists of elements such as Mn, P, Fe, O, and C. XRD showed that (Mn,Fe)5H2(PO4)4 · 4H2O in manganese phosphate coating layer was formed by the chemical reaction between manganese phosphate and elements in carbon steel. With regard to the effects of surface activation agents on the manganese phosphate coatings, it can be seen that there is an increase of the crystal size on phosphate coating as the content of sodium pyrophosphate increased. The increase of sodium pyrophosphate had effect on the tribology property under the condition of spindle oil retention. Corrosion resistance was improved for manganese carbonate (3 g/L) and sodium pyrophosphate (3 g/L) coating with the ratio of 1:1. Also, better tribology property was observed for manganese carbonate (3 g/L) and sodium pyrophosphate (15 g/L) with the ratio of 1:5.
RESUMO
Conductive hydrogels were prepared for biomedical patch in order to improve the electrical conductivity. Sodium polyacrylate and nano-sized carbon were mixed and fabricated by aqueous solution gelation process in various contents of nano-sized carbon with 0.1, 0.5, 1.0 and 2.0 wt%. Sodium polyacrylate/nano-sized carbon conductive hydrogels were investigated by molecular structure, surface morphology and electrical conductivity. The conductivity of the hydrogel/nano-sized carbon conductive hydrogel proved to be 10% higher than conductive hydrogel without nano-sized carbon. However, it was founded that conductive hydrogels with nano-sized carbon content from 0.5 up to 2.0 wt% were remarkably decreased. This may be due to the non-uniform distribution of nano-sized carbon, resulting from agglomerates of nano-sized carbon. The developed hydrogel is intended for use in the medical and cosmetic fields that is applicable to supply micro-current from device to human body.
Assuntos
Resinas Acrílicas , Hidrogéis , Carbono , Condutividade Elétrica , Equipamentos e Provisões , HumanosRESUMO
In this study, the correlation between morphology and friction of manganese phosphate coating layer with additive agent of tartaric acid by 2, 4, 6 g were investigated. The microstructure and morphology of the coatings were studied by scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive X-ray spectroscopy (EDS) and atomic force microscopic (AFM). Potentiodynamic polarization test was carried out in order to evaluate the corrosion protection properties of manganese phosphate coating in 3.5 wt.% NaCl solution. Also, the tribology property of manganese phophate coating was tested by ball-on disk. In the results of EDS analysis, coating layer consists of elements such as Mn, P, Fe, O, and C. XRD showed that (Mn, Fe)5H2(PO4)4·4H2O in manganese phosphate coating layer was formed by the chemical reaction between manganese phosphate and elements in SM45C alloy. The corrosion resistance of manganese phosphate coating with additive agent was superior than the one without additive agent. Also, in the Fe amount in sludge, manganese phosphate coating layer with additive agent was observed to be considerably decreased.