RESUMO
Currently there still remains a critical need of human involvements for multi-robot system (MRS) to successfully perform their missions in real-world applications, and the hand-controller has been commonly used for the operator to input MRS control commands. However, in more challenging scenarios involving concurrent MRS control and system monitoring tasks, where the operator's both hands are busy, the hand-controller alone is inadequate for effective human-MRS interaction. To this end, our study takes a first step toward a multimodal interface by extending the hand-controller with a hands-free input based on gaze and brain-computer interface (BCI), i.e., a hybrid gaze-BCI. Specifically, the velocity control function is still designated to the hand-controller that excels at inputting continuous velocity commands for MRS, while the formation control function is realized with a more intuitive hybrid gaze-BCI, rather than with the hand-controller via a less natural mapping. In a dual-task experimental paradigm that simulated the hands-occupied manipulation condition in real-world applications, operators achieved improved performance for controlling simulated MRS (average formation inputting accuracy increases 3%, average finishing time decreases 5 s), reduced cognitive load (average reaction time for secondary task decreases 0.32 s) and perceived workload (average rating score decreases 15.84) with the hand-controller extended by the hybrid gaze-BCI, over those with the hand-controller alone. These findings reveal the potential of the hands-free hybrid gaze-BCI to extend the traditional manual MRS input devices for creating a more operator-friendly interface, in challenging hands-occupied dual-tasking scenarios.
RESUMO
Microtubules are the structural center of neurons, stretching in overlapping arrays from the cell body to the far reaches of axons and dendrites. They also act as the tracks for long-range transport mediated by dynein and kinesin motors. Transcription and most translation take place in the cell body, and newly made cargoes must be shipped from this site of synthesis to sites of function in axons and dendrites. This constant demand for transport means that the microtubule array must be present without gaps throughout the cell over the lifetime of the animal. This task is made slightly easier in many animals by the relatively long, stable microtubules present in neurons. However, even stable neuronal microtubules have ends that are dynamic, and individual microtubules typically last on the order of hours, while the neurons around them last a lifetime. "Birth" of new microtubules is therefore required to maintain the neuronal microtubule array. In this review we discuss the nucleation of new microtubules in axons and dendrites, including how and where they are nucleated. In addition, it is becoming clear that neuronal microtubule nucleation is highly regulated, with unexpected machinery impinging on the decision of whether nucleation sites are active or inactive through space and time.
Assuntos
Microtúbulos/metabolismo , Neurônios/metabolismo , Animais , Humanos , Neurônios/ultraestruturaRESUMO
Effects of hydrocarbon compositions on raw exhaust emissions and combustion processes were studied on an engine test bench. The optimization of gasoline hydrocarbon composition was discussed. As olefins content increased from 10.0% to 25.0% in volume, the combustion duration was shortened by about 2 degree crank angle (degrees CA), and the engine-out THC emission was reduced by about 15%. On the other hand, as aromatics content changed from 35.0% to 45.0%, the engine-out NOx emissions increased by 4%. An increment in olefins content resulted in a slight increase in engine-out CO emission, while the aromatics content had little effect on engine-out total hydrocarbon (THC) and CO emissions. Over the new European driving cycle (NEDC), the THC, NOx and CO emissions of fuel with 25.0% olefins and 35.0% aromatics were about 45%, 21% and 19% lower than those of fuel with 10.0% olefins and 40.0% aromatics, respectively. The optimized gasoline compositions for new engines and new vehicles have low aromatics and high olefins contents.
Assuntos
Gasolina/análise , Hidrocarbonetos/análise , Emissões de Veículos/prevenção & controle , Alcenos/análise , Monitoramento Ambiental/instrumentação , Monitoramento Ambiental/métodos , Hidrocarbonetos Aromáticos/análiseRESUMO
Recent developments in the non-muscular human-robot interface (HRI) and shared control strategies have shown potential for controlling the assistive robotic arm by people with no residual movement or muscular activity in upper limbs. However, most non-muscular HRIs only produce discrete-valued commands, resulting in non-intuitive and less effective control of the dexterous assistive robotic arm. Furthermore, the user commands and the robot autonomy commands usually switch in the shared control strategies of such applications. This characteristic has been found to yield a reduced sense of agency as well as frustration for the user according to previous user studies. In this study, we firstly propose an intuitive and easy-to-learn-and-use hybrid HRI by combing the Brain-machine interface (BMI) and the gaze-tracking interface. For the proposed hybrid gaze-BMI, the continuous modulation of the movement speed via the motor intention occurs seamlessly and simultaneously to the unconstrained movement direction control with the gaze signals. We then propose a shared control paradigm that always combines user input and the autonomy with the dynamic combination regulation. The proposed hybrid gaze-BMI and shared control paradigm were validated for a robotic arm reaching task performed with healthy subjects. All the users were able to employ the hybrid gaze-BMI for moving the end-effector sequentially to reach the target across the horizontal plane while also avoiding collisions with obstacles. The shared control paradigm maintained as much volitional control as possible, while providing the assistance for the most difficult parts of the task. The presented semi-autonomous robotic system yielded continuous, smooth, and collision-free motion trajectories for the end effector approaching the target. Compared to a system without assistances from robot autonomy, it significantly reduces the rate of failure as well as the time and effort spent by the user to complete the tasks.