RESUMO
Graphene materials, used as electrocatalyst support in green hydrogen production, contribute to increasing the efficiency and robustness of various systems. However, the preparation of a hybrid catalyst containing graphene materials from industrial wastes is still a challenge due to the heterogeneity of the waste. We report the synthesis of 3D electrodes using graphene oxides (GOs) from industrial waste (IW) prepared by immersion onto Toray carbon paper as a 3D support onto GO suspensions and electrodepositing NiFe layered double hydroxides (LDHs). Standard graphite was also used as the reference. The morphology of the two hybrid electrodes was determined by SEM, HRTEM, XPS. Although very similar in both, the sample containing graphene from IW (higher Csp3 hybridization in the graphene layer) has a NiFe phase with less crystallinity and larger presence of Fe2+ ions. These electrodes exhibited similar activity and stability as electrocatalysts of the oxygen evolution reaction (OER), demonstrating the proactive effect of the graphene into the 3D electrode even when this is prepared from heterogeneous industrial waste. Moreover, the defective graphenic structure of the waste GO enhances the reaction kinetics and improves the electron transfer rate, possibly due to the small differences in the electrodeposited NiFe LDH structure.
RESUMO
This work reports a sensitive SERS substrate based on graphene oxide (GO) and quantum-sized ZrO2 nanoparticles (GO/ZrO2) for label-free determination of the organophosphate pesticide methyl parathion (MP). The enhanced light-matter interactions and the consequent SERS effect in these substrates resulted from the effective charge transfer (CT) mechanism attributed to synergistic contributions of three main factors: i) the strong molecular adherence of the MP molecules and the ZrO2 surface which allows the first layer-effect, ii) the relatively abundant surface defects in low dimensional ZrO2 semiconductor NPs, which act as intermediate electronic states that reduce the large bandgap barrier, and iii) the hindered charge recombination derived from the transference of the photoinduced holes to the GO layer. This mechanism allowed an enhancement factor of 8.78 × 104 for GO/ZrO2-based substrates, which is more than 5-fold higher than the enhancement observed for platforms without GO. A detection limit of 0.12 µM was achieved with an outstanding repeatability (variation ≤4.5%) and a linear range up to 10 µM, which is sensitive enough to determine the maximal MP concentration permissible in drinking water according to international regulations. Furthermore, recovery rates between 97.4 and 102.1% were determined in irrigation water runoffs, strawberry and black tea extracts, demonstrating the reliability of the hybrid GO/ZrO2 substrate for the organophosphate pesticides quantification in samples related to agri-food sectors and environmental monitoring.
Assuntos
Grafite , Inseticidas , Nanopartículas Metálicas , Metil Paration , Reprodutibilidade dos Testes , Nanopartículas Metálicas/química , Grafite/químicaRESUMO
The preparation of graphene materials from biomass resources is still a challenge, even more so if they are going to be employed as supports for electrocatalysts for water splitting. Herein, we describe the preparation and characterization of graphene oxides (GOs) from solid macroalgae waste obtained after processing an agar-agar residue. The structural and morphological characterization of the obtained GO confirm the presence of a lamellar material that is composed of few layers with an increased number of heteroatoms (including nitrogen) if compared with those observed in a GO obtained from graphite (reference). Three-dimensional electrodes were prepared from these GOs by depositing them onto a fibrous carbon paper, followed by electrodeposition of the catalyst, NiFe. The electrocatalytic performance of these hybrid systems for the oxygen evolution reaction (OER) showed a proactive effect of both graphene materials toward catalysis. Moreover, the electrode prepared from the algae-based graphene showed the highest electrocatalytic activity. This fact could be explained by the different structure of the algae-based graphene which, due to differences in the nucleation growth patterns and electroactive sites developed during the electrodeposition process, produced more reactive NiFe species (higher oxidation state).
RESUMO
In the present work, multiple-wall carbon nanotubes (MWCNTs) were surface modified in an environmentally friendly way, using low-frequency ultrasonic energy. This type of modification was carried-out using two different types of organic acids, citric acid (CA) and oxalic acid (OA). The modification of the MWCNTs was confirmed by Fourier-transform infrared spectroscopy (FTIR), where functional groups such as OH, C=O, O-C=O and COOH were detected. By means of Raman spectroscopy, an increase in carbon surface defects was found. On the other hand, using X-ray photoelectron spectroscopy (XPS), oxidation was evidenced on the surface of the modified MWCNT. In both Raman spectroscopy and XPS, the results indicate a greater modification when CA is used, possibly due to the fact that CA has a larger number of functional groups. MWCNT-CA showed good dispersion in methanol, while MWCNT-OA showed good stability in methanol and ethanol. Finally, a 20% removal of creatinine efficiency improvement was found with respect to the unmodified MWCNTs, while no improvement was found in the case of urea and uric acid.
RESUMO
La transmisión de algunas enfermedades entre especies ha atraído la atención de los científicos desde el siglo XVIII. El scrapie, la enfermedad de Creutzfeldt-Jakob y otras encefalopatías espongiformes permitieron identificar nuevos agentes infecciosos que no responden a los criterios tradicionales de las enfermedades infecciosas. Los países y sus oficinas sanitarias deben mantener una vigilancia epidemiológica de su conducción respecto a las encefalopatías espongiformes