Treatment of sewage sludge in a thermophilic membrane reactor (TMR) with alternate aeration cycles.

The management of sewage sludge is becoming a more and more important issue, both at national and international level, in particular due to the uncertain recovery/disposal future options. Therefore, it is clear that the development of new technologies that can mitigate the problem at the source by reducing sludge production is necessary, such as the European Directive 2008/98/EC prescribes. This work shows the results obtained with a thermophilic membrane reactor, for processing a biological sludge derived from a wastewater treatment plant (WWTP) that treats urban and industrial wastewater. Sewage sludge was treated in a thermophilic membrane reactor (TMR), at pilot-scale (1 m(3) volume), with alternate aeration cycles. The experimentation was divided into two phases: a "startup phase" during which, starting with a psychrophilic/mesophilic biomass, thermophilic conditions were progressively reached, while feeding a highly biodegradable substrate; the obtained thermophilic biomass was then used, in the "regime phase", to digest biological sludge which was fed to the plant. Good removal yields were observed: 64% and 57% for volatile solids (VS) and total COD (CODtot), respectively, with an average hydraulic retention time (HRT) equal to 20 d, an organic loading rate (OLR) of about 1.4-1.8 kg COD m(-3) d(-1) and aeration/non aeration cycles alternated every 4 h.

Sewage sludge treatment in a thermophilic membrane reactor (TMR): factors affecting foam formation.

Foam formation in the excess sludge treatment facilities of biological wastewater treatment plants (WWTPs) may represent a critical issue as it could lead to several operative problems and reduce the overall plant performance. This trouble also affects a novel technology recently proposed for sludge minimization, the thermophilic membrane reactor (TMR), operating with alternate aeration/non-aeration cycles. This technology, which has proven to be extremely resilient and suitable for treating industrial wastewater of different nature, demonstrated a high potential also as a solution for integrating existing WWTPs, aiming at the "zero sludge production." In this work, an experimental study was conducted with a TMR pilot plant (fed daily with thickened sewage sludge) by adjusting the duration of aeration/non-aeration alternate cycles. Extracellular polymeric substance (EPS) concentration (and its soluble and bound fractions) has been monitored along with foaming power indices. The results highlight that foaming can be correlated to the presence of soluble protein fraction of EPS. Moreover, EPS production seems to be reduced by increasing the duration of the non-aeration cycles: optimal operating conditions resulted 2 h of aeration followed by 6 h of non-aeration. These conditions allow to obtain an EPS concentration of 500 mg L-1 with respect to 2300 mg L-1 measured at the beginning of experimental work.