RESUMO
We report on what is to the best of our knowledge the longest 50-Gb/s/λ O-band wavelength-division multiplexed (WDM) transmission. A pair of in-house built bismuth-doped fiber amplifiers (BDFAs) and the use of Kramers-Kronig detection-assisted single-sideband transmission are adopted to overcome the fiber loss and chromatic dispersion, respectively, in a reach-extended O-band coarse WDM (CWDM) system with a channel spacing of â¼10 nm. Through experiments on an amplified 4×50-Gb/s/λ direct-detection system based on booster and pre-amp BDFAs, we show the superior performance of single-sideband transmission in terms of both optical signal-to-noise ratio sensitivity and uniformity in performance amongst CWDM channels relative to double-sideband transmission after both 75-km and 100-km lengths of single-mode fiber. As a result, up to 100-km reach with comparable performance at all 50-Gb/s channels was achieved without the need for in-line optical amplification.
RESUMO
The recent emergence of bismuth-doped fiber amplifiers (BDFAs) offers the potential to transmit high-speed WDM signals over long distances in the O-band spectral region, thereby greatly enhancing the scope of systems utilizing these wavelengths. In this paper, we present a comprehensive experimental study on several basic characteristics of an O-band BDFA based on a phosphosilicate optical fiber, including the frequency-dependent noise figure, gain tilt (static and dynamic), transient response, and polarization dependent gain. We discuss our findings and their implications on the use of BDFA technology in high bit-rate multichannel systems.
RESUMO
The recent emergence of efficient O-band amplification technologies has enabled the consideration of O-band transmission beyond short reach. Despite the O-band being a low chromatic dispersion (CD) window, the impact of CD will become increasingly significant when extending the reach of direct-detection (DD) systems. In this work, we first numerically investigate the 3-dB bandwidth of single-mode fibers (SMF) and the CD-restricted transmission reach in intensity-modulation DD systems, confirming the significant difference between low- and high-dispersion O-band wavelengths. We then carry out experimental transmission studies over SMF for distances of up to 70 km at two different wavelengths, the low-dispersion 1320 nm and the more dispersive 1360 nm, enabled by the use of an O-band bismuth-doped fiber amplifier as a preamplifier at the receiver. We compare three 50-Gb/s optical DD formats, namely, Nyquist on-off keying (OOK), Nyquist 4-ary pulse amplitude modulation (PAM4) and Kramers-Kronig detection-assisted single-sideband quadrature phase shift keying (KK-QPSK) half-cycle subcarrier modulation. Our results show that at both wavelengths, OOK and QPSK exhibit better bit error rate performance than PAM4. When transmitting over 70-km of SMF at the less dispersive wavelength of 1320 nm, 50-Gb/s OOK modulation offers more than 1.5-dB optical power sensitivity improvement at the photodiode (PD) compared to 50-Gb/s QPSK. Conversely, at 1360 nm, the required optical power to the PD can be reduced by more than 3 dB by using QPSK instead of OOK.