Assuntos
Clonagem Molecular/métodos , Técnicas de Cultura/instrumentação , Vetores Genéticos/isolamento & purificação , Nucleopoliedrovírus/isolamento & purificação , Proteínas Recombinantes de Fusão/isolamento & purificação , Cultura de Vírus/instrumentação , Animais , Divisão Celular , Linhagem Celular , Meios de Cultura , Técnicas de Cultura/métodos , DNA Recombinante/genética , DNA Recombinante/isolamento & purificação , Nucleopoliedrovírus/genética , Nucleopoliedrovírus/crescimento & desenvolvimento , Sistemas On-Line , Proteínas Recombinantes de Fusão/genética , Spodoptera/citologia , Cultura de Vírus/métodosRESUMO
A perfusion system based on a 4-L stirred tank bioreactor and a custom-designed tangential (cross-flow) filter was assembled to realize a scaleup of the Baculovirus Expression Vector System (BEVS). When perfused with 1 to 1.5 vol/day, Spodoptera frugiperda (Sf-9) insect cell cultures grew from 4 x 10(6) to 15 x 10(6) cells/mL over 3 to 4 days. The possibility of maintaining high specific production of recombinant VP6 protein (from bovine rotavirus) after baculovirus infection of the high-density cultures was then assessed. The process consisted of a growth phase in TNMFH + 10% FBS, followed by infection with Bac-BRV6L recombinant baculovirus and a shift to a low-serum (0 to 1%) medium for perfusion during the production phase. Multiple runs were executed, each including a battery of shaker flask controls at various cell densities and serum concentrations. On average, specific rVP6 production in the bioreactor amounted to 76% of that found in 20-mL shaker cultures simulatingthe bioreactor's high cell density, low serum concentration, and medium renewal rate. Mechanical stress generated by cell/medium separation in theperfusion process reduced cell growth rate but had minimal effect on rVP6production. Our results also indicated that serum concentration during the infection phase affected the rVP6 specific production in a cell density-dependent fashion. Although the feasibility of the cell density scale up was demonstrated, optimization is still needed to achieve a truly cost-effective process.
RESUMO
An 11-L helical ribbon impeller (HRI) bioreactor was tested for the culture of Spodoptera frugiperda (Sf-9) cells. This impeller and surface baffling ensured homogeneous mixing and high oxygen transfer through surface aeration and surface-induced babble generation. Serum-supplemented and serum-free cultures, using TNMFH and IPL/41 media, respectively, grew a similar specific growth rates(0.031 and 0.028 h(-1)) to maximum cell densities of 5.5 x 10(6)-6.0 x 10(6) cells. mL(-1) with viability exceeding 98% during exponential growth phase. Growth limitation coincided with glucose and glutamine depletion and production of significant amounts of alanine. The bioreactor was further tested under more stringent conditions by infecting a serum-free medium culture with a recombinant baculovirus. Heterologous protein production of approximately 35 microg per 10(6) cells was comparable to yields obtained in serum-free cultures grown in spinner flasks and petri dishes. Average specific oxygen up-take and carbon dioxide production rates of the serum-free culture prior to infection as measured by on-line mass spectroscopy were 0.20 micromol O(2).(10(6) cells)(-1) h(-1) and 0.22 micromol CO(2) . (10(6) cells)(-1)h(-1) and increased by 30-40% during infection. Therefore, the mixing and oxygenation conditions of this bioreactor were suitable for insect cell culture and recombinant protein production, with limitation being mainly attributed to nutrient depletion and toxic by-product generation.
RESUMO
The extracellular domain of the epidermal growth factor receptor (EGFR) was expressed using the baculovirus expression vector system. The maximum level of the EGFR extracellular domain secreted into the medium in Sf-9 (Spodoptera frugiperda or fall army-worm) cell batch culture was approximately 2.5 micrograms ml-1. In order to increase this yield, a process was developed that included the following sequence of steps: batch growth to maximum cell density, infection of the cells with recombinant virus, and replacement of spent medium. By using this process, the specific yield of recombinant protein, which in batch culture drops when infection is carried out at densities greater than 3 x 10(6) cells ml-1, can be maintained at a maximum in cultures infected at densities of 10(7) cells ml-1 or greater. The process, when applied to 3-1 and 11-1 bioreactor cultures, allowed a maximum volumetric yield of triple the maximum value attainable in batch culture. Spent-medium analysis indicates that medium replacement provides certain nutrients that could otherwise be limiting for recombinant protein production.