RESUMO
Thermal ionization mass spectrometry (TIMS) has shown excellent analytical precision for Sr isotopic ratio analysis, even for small masses of material (0.5-10 ng). However, because of the sensitivity limit of TIMS, it is still not possible to obtain high precision 87Sr/86Sr isotope ratios for picogram-level sample sizes (30-100 pg) due to the lack of a highly sensitive emitter. This study is the first to employ a highly sensitive silicotungstic acid emitter to measure Sr isotopes at the picogram-level using TIMS. This emitter produces a 3-fold enhancement in the ionization efficiency of Sr and not only significantly reduces the required sample size but also has good external precision. Analyses of the NIST 987 standard yield an external reproducibility (2 RSD, n = 8) better than ±0.013% even for 30 pg of Sr. It is possible to yield an internal precision (2 RSE) of ±0.003% for 100 pg of sample using the default 1011 Ohm feedback resistors. This method was verified by using a suite of silicate reference materials. Replicate digestions and analyses ( n = 8) of the basalt standard BCR-2 (87Sr/86Sr = 0.704998 ± 0.000028, 2 SD) at the 326 ± 30 pg level demonstrates that good external reproducibility is reached on ultratrace level silicate samples. This method has a wide variety of potential applications for samples containing ultralow amounts of Sr in geoscience and archeological studies, such as single grains of mica, sphalerite, and pyrite, single mantle melt inclusions, precious extra-terrestrial materials, and human hair to name just a few.
Assuntos
Silicatos/química , Isótopos de Estrôncio/análise , Temperatura , Compostos de Tungstênio/química , Silicatos de Alumínio/química , Cabelo/química , Humanos , Ferro/química , Espectrometria de Massas , Sulfetos/químicaRESUMO
Thermal ionization mass spectrometry (TIMS) allows excellent precision for determining Sr isotope ratios in natural water samples. Traditionally, a chemical separation procedure using cation exchange resin has been employed to obtain a high purity Sr fraction from natural water, which makes sample preparation time-consuming. In this study, we present a rapid and precise method for the direct determination of the Sr isotope ratio of natural water using TIMS equipped with amplifiers with two 10(12) Ω resistors. To eliminate the (87)Rb isobaric interference, Re ribbons are used as filaments, providing a significant advantage over W ribbons in the inhibition of Rb(+) emission, based on systematically examining a series of NIST SRM987 standard doping with various amounts of Rb using Re and W ribbons. To validate the applicability of our method, twenty-two natural water samples, including different water types (rain, snow, river, lake and drinking water), that show a large range in Sr content variations (2.54-922.8 ppb), were collected and analyzed from North and South China. Analytical results show good precision (0.003-0.005%, 2 RSE) and the method was further validated by comparative analysis of the same water with and without chemical separation. The method is simple and rapid, eliminates sample preparation time, and prevents potential contamination during complicated sample-preparation procedures. Therefore, a high sample throughput inherent to the TIMS can be fully utilized.
RESUMO
Zinc isotopic ratios serve as powerful tools for tracing biochemical cycling of metals at Earth's surface, including the distribution, transportation, and enrichment of zinc (Zn) in soil. To conduct such studies and enable inter-laboratory comparisons, high-precision Zn isotopic measurements require the use of soil reference materials (RMs). However, there have been limited reports on the high-precision Zn isotope ratios of soil RMs thus far. In this study, we have developed a two-step Zn chemical separation protocol utilizing Bio-Rad AG MP-1M resin columns. This method has demonstrated excellent reproducibility for measuring the external δ66Zn values (relative to JMC-Lyon) of standard soil reference materials over an extended time period, with a better than 0.06 (2SD) precision. Remarkably, this study is the first to report the Zn isotopic compositions of 20 soil reference materials from various soil types in China. With the exception of one sample obtained from a mining area, the Zn isotopic compositions of all the analyzed soil reference materials exhibit remarkable similarity, with an average δ66Zn value of 0.31 ± 0.12, which aligns closely with the values observed in igneous rocks. The exceptional sample, with a higher δ66Zn value of 0.61 ± 0.02, indicates potential contamination during mining activities.
RESUMO
Illitic clay is ubiquitous in clastic hydrocarbon reservoirs, and the host for several radiometric isotopes such as the potassium-argon (K-Ar) and rubidium-strontium (Rb-Sr) systems. This study applied the isotope-dilution thermal ionization mass spectrometry technique for small samples (3-4 mg) to conduct illite Rb-Sr isotope dating of five illitic clay samples from the Silurian bituminous sandstone (SBS) intersected by five drillholes in the Tarim Basin, NW China. The 87Rb/86Sr ratio of clays is fractionated mainly by the addition of Rb during the illitization of mixed-layer illite/smectite (I/S), which is the dominant clay species in the Tarim Basin samples. The subsample-scale Rb/Sr isotope values suggest that each subsample may contain I/S particles of slightly variable degrees of illitization. Three of the analyzed samples (H6, KQ1 and TZ67) generated Rb-Sr isochron ages of 141 ± 61 Ma, 332 ± 32 Ma and 235 ± 8 Ma (errors quoted at 2σ), respectively. These results are similar to the corresponding K-Ar ages (125 Ma, 389 Ma and 234 Ma). The isotopic ages are consistent with the timing of hydrocarbon charge which varies in different drillholes as constrained by basin modelling, indicating that a closed-system behavior is attained by the hydrocarbon charge that inhibits the illitization of I/S. The Rb-Sr isotope analyses of the other two samples (YM35-1 and Q1) that did not yield isochron ages suggest the conditions for producing isochrons were not satisfied, which may be caused by disturbance of the isotope system by a post-charge hydrothermal event. The outcomes of this study show the robust potential of Rb-Sr clay subsample geochronology for cross-checking isotopic ages yielded by other systems (e.g. K-Ar system) and constraining the timing of hydrocarbon charge.
RESUMO
AIM: To investigate the genetic mutations that are associated the hereditary autosomal dominant cataract in a Chinese family. METHODS: A Chinese family consisting of 20 cataract patients (including 9 male and 11 female) and 2 unaffected individuals from 5 generations were diagnosed to be a typical autosomal dominant cataract pedigree. Genomic DNA samples were extracted from the peripheral blood cells of the participants in this pedigree. Exon sequence was used for genetic mutation screening. In silico analysis was used to study the structure characteristics of connexin 46 (CX46) mutant. Immunoblotting was conduceted for testing the expression of CX46. RESULTS: To determine the involved genetic mutations, 11 well-known cataract-associated genes (cryaa, cryab, crybb1, crybb2, crygc, crygd, Gja3, Gja8, Hsf4, Mip and Pitx3) were chosen for genetic mutation test by using exon sequencing. A novel cytosine insertion at position 1195 of CX46 cDNA (c.1194_1195ins C) was found in the samples of 5 tested cataract patients but not in the unaffected 2 individuals nor in normal controls, which resulted in 30 amino acids more extension in CX46C-terminus (cx46fs400) compared with the wild-type CX46. In silico protein structure analysis indicated that the mutant showed distinctive hydrophobicity and protein secondary structure compared with the wild-type CX46. The immunoblot results revealed that CX46 protein, which expressed in the aging cataract lens tissues, was absence in the proband lens. In contrast, CX50, alpha A-crystallin and alphaB-crystallin expressed equally in both proband and aging cataract tissues. Those results revealed that the cx46fs400 mutation could impair CX46 protein expression. CONCLUSION: The insertion of cytosine at position 1195 of CX46 cDNA is a novel mutation site that is associated with the autosomal dominant cataracts in this Chinese family. The C-terminal frameshift mutation is involved in regulating CX46 protein expression.
RESUMO
It has previously been postulated that the Earth's hydrous mantle transition zone may play a key role in intraplate magmatism, but no confirmatory evidence has been reported. Here we demonstrate that hydrothermally altered subducted oceanic crust was involved in generating the late Cenozoic Chifeng continental flood basalts of East Asia. This study combines oxygen isotopes with conventional geochemistry to provide evidence for an origin in the hydrous mantle transition zone. These observations lead us to propose an alternative thermochemical model, whereby slab-triggered wet upwelling produces large volumes of melt that may rise from the hydrous mantle transition zone. This model explains the lack of pre-magmatic lithospheric extension or a hotspot track and also the arc-like signatures observed in some large-scale intracontinental magmas. Deep-Earth water cycling, linked to cold subduction, slab stagnation, wet mantle upwelling and assembly/breakup of supercontinents, can potentially account for the chemical diversity of many continental flood basalts.